Panduit DIFBA3003S00S rack accessory
Contents
1. FRONT OF CABINET 2 Bottom Screws Provided in kit with matching cage nuts if needed leave slightly extended Adjust Switch Ducting Use 4 wing nuts and tooth washers to adjust position of switch duct seals Install foam seal if necessary to seal ducting to bottom of switch 4 Wing Nuts and Tooth Washers Install Foam Seal if necessary For Technical Support www panduit com resources install_maintain asp Page 3 of 4 INSTALLATION INSTRUCTIONS Vv00029ES Routing of Switch Power Cable Route switch power cable through power grommet located on either side of DIFBA3003S00S Use utility knife to slit power grommet s along guide lines as needed to allow for power cord pass through Switch Power Cable Slit Power Grommet s to allow for power cord pass through use utility knife 2 Power Grommets Install Front Perforated Plate Slide slots at bottom of Front Perforated Plate over 2 bottom screws Secure top of Front Perforated Plate to switch ducting and equipment rails with 2 bonding screws then tighten 2 bottom screws 2 Bonding Screws Ti e 2 Bottom Screws tighten after plate installation For Instructions in Local Languages E mail and Technical Support D U IT techsupport panduit com Fax www panduit com resources install_maintain asp2. PANDUIT wittunetoe Panduit Corp 2014 INSTALLATION INSTRUCTIONS Vv00029ES Cisco Nexus 93128 Switch reference DIFBA3003S00S installed in Net Access S Type Server Cabinet FOR TECHNICAL SUPPORT www panduit com resources install_maintain asp Page 1 of 4 INSTALLATION INSTRUCTIONS Vv00029ES Prepare Switch for Ducting Installation Remove bottom screws from front of switch rails and discard FRONT OF CABINET Install Cage Nuts Insert 4 Bonding cage nuts per equipment rail in rack space immediately above switch rails at front of cabinet 4 Bonding Cage Nuts install in Rack Space Intended above switch rails Mounting 5 Location 3 rack spaces ffo FRONT OF CABINET For Technical Support www panduit com resources install_maintain asp Page 2 of 4 INSTALLATION INSTRUCTIONS Vv00029ES Install Switch Ducting Secure DIFBA3003S00S switch ducting to equipment rails with 8 new screws and the two bottom screws taken out earlier Do not tighten 2 bottom screws Leave slightly extended for Front Perforated Plate installation see page 4 8 Bonding Screws y
3. www panduit com 866 405 6654 Page 4 of 4
Download Pdf Manuals
Related Search