Caliber RMD213 car media receiver
Contents
1. USB port Card reader for SD cards 3 5 mm stereo input socket for the connection of an external audio device Left speaker Right speaker Installation PRECAUTIONS Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver Avoid installing the unit where it would be subject to high temperatures such as from direct sunlight or hot air from the heater or where it would be subject to dust dirt or excessive vibration Use only the supplied mounting hardware for a safe and secure installation Be sure to remove the front panel before installing the unit NOTE Inclination angle for car radio installation must not exceed 30 otherwise the front panel will not open Bend these claws if necessay Note Keep the release key in the safe place as you may need it in future to remove the unit from the car To support the unit oem 1 2 RELEASE CASE 3 DASH BOARD 4 HEX NUT 5 LOCK WASHER 6 7 8 9 1 Dashboard PLAIN WASHER CAR BODY REAR SUPPORT STRAP TAPPING SCREW 0 M5 X 15 HEX BOLT N S X gt D 1 Wire connection RCA Jack Line Out Red right White left ISO CONNECTOR ANTENNA 11131517 CONNECTOR A IEEE 4 MEMORY 24V CONNECTOR LINE OUT zen 5 AUTO ANTENNA OUTPUT A 7 24V TO IGNITION KEY L WHITE R RED 8 GROUND Note connector A no 7 mus2. 5 Fader Turn the VOL 3 knob to change the settings of the menu item displayed Further settings using the SEL button TA AF EQ AVOL STEREO LOUD SPEAKER LOCAL ADUST CLOCK Hold down the SEL button for about 2 seconds and then keep pressing the SEL button until the required function is shown on the display Turn the VOL knob to change the settings of the menu item displayed 2 sec P SEL TA gt SEL AF SEL EQ gt SEL AVOL SEL STEREO SEL LOUD SEL SPK SEL LOC SEL TA Enabling disabling Traffic Announcement traffic information TA ON IF TA mode is enabled the device immediately switches from other stations or operating modes to the radio station that is currently transmitting traffic information Note When the TA function is enabled you can only search for or save stations that are transmitting traffic information Stations that are transmitting traffic information signals are denoted in the display by TP TA OFF The TA function is disabled AF Enabling disabling Alternative Frequencies AF ON When the AF function is enabled the device searches for the current station s optimum frequency AF OFF The AF function is disabled EQ Equaliser Turn the multi controller to select one of the FLAT CLASSIC ROCK POP or EQ OFF settings The equaliser will be disabled if EQ OFF is set The equaliser setting is shown at the bottom of the display AVOL Set the volume when radio i
3. NS ley TECHNOLOGY RMD 213 Manual ENGLISH TECHNICAL SPECIFICATIONS MP3 WMA PLAYER SECTION Signal to Noise Ratio Channel Separation Frequency Response TUNER FM Frequency range Sensitivity Stereo separation Signal to noise ratio Channel step LINE OUT Output Impedance FRONT AUX IN Frequency Response Sensitivity Impedance GENERAL Power Supply Speaker impedance Output power Fuse gt 60 dB gt 50 dB 1kHz 60Hz 15 kHz 87 5 108 MHz 2 8 uV 30 dB 45 dB 50 kHz 5V max 10k Ohm 60 Hz 20 kHz 775 mV 20k Ohm 24V DC 10 8 32V allowable 4 or 8 Ohm 25W x 4CH 7 5A Note Specification and the design are subject to possible modification without notice due to improvements Location of parts and controls COO Or CoN a EI ET Switching the device on and off turning the sound off MU Call up Settings menu Turn to set values volume Preset stations 1 2 3 4 5 6 Setting the operating mode MD setting the PTY function PTY Selecting memory location band BD showing display information DISP Title Station search backwards forwards Kd gt gt I Automatic station memory search function during MP3 WMA playback A PS LCD display Pause playback 1 PAU Repeat function 2 RPT Intro function 3 INT Random play 4 RDM Directory backwards forwards MP3 WMA Files only 5 FL 6 FL
4. carriers up to 16 GB Connecting data carriers Push the USB port protective cap to the right Connect your USB device to the port To protect against dirt replace the protective cap on the USB port when no USB device is connected Card reader The device can process SD MMC memory cards up to 2 GB and SDHC memory cards up to 32 GB Connecting data carriers Push a memory card into the memory card slot with the lettering pointing upwards MP3 WMA playback functions Playback e The device can play back files in the MP3 and WMA formats A mixture of titles and directories on the same level can cause problems when playing back During playback the information from the MP3 file ID3 tag is read and shown in turn on the display e Playback of the MP3 or WMA title on the USB device or memory card begins automatically Stop playback Press the 1 PAU button to stop playback Press the 1 PAU button again to continue playback Note Keep the 1 PAU button pressed to play the first title on the storage medium Skip title Press the M1 or 44 button to select the next or previous title The title number is shown on the display Fast forward backward Hold down the gt gt I or Ke button for longer to start fast forward or backward Repeat function RPT Repeat Press the 2 RPT button several times to switch between the repeat functions The following settings are available RPT ONE The current title is repeated RPT DIR All tit
5. l the PTY message is shown at the bottom of the display Then press one of the 1 to 6 buttons to select the required PTY entry To change between the Musical style and Vocal style PTY entries press the MD button again when the first PTY entry is displayed Buttons 1 to 6 are assigned as follows Musical genre 1 Pop M Rock M 2 Easy M Light M 3 Classics Other M 4 Jazz Country 5 Nation M Oldies 6 Folk M Vocal style 1 News Affairs Info 2 Sport Educate Drama 3 Culture Science Varied 4 Weather Finance Children 5 Social Religion Phone IN 6 Travel Leisure Document If there is no further input for 2 seconds an automatic search for stations matching the PTY entry starts The search stops when the first station is found Disabling enabling the PTY function Press the MD button to activate the PTY search The PTY symbol is shown on the display with the last PTY entry selected e g POP M Rock M Only stations with the PTY ID currently selected are included in the station search e Press the MD button again to disable the PTY search PTY is no longer shown on the display Station search by PTY ID If you do not input anything for 2 seconds whilst a PTY ID is being displayed an automatic search for stations matching this PTY ID is started If no stations matching this PTY ID are found PTY NONE is shown briefly and the search then ends at the station last set USB port The device can process USB data
6. les in the current directory are repeated RPT ALL All titles on the storage medium are repeated Title sampling Press the 3 INT button All titles are played back one after the other for approximately 10 seconds Press the 3 INT button again to commence playback of the title currently selected Random playback of all titles RDM Random Press the 4 RDM button Arandomly controlled playback is started Press the 4 RDM button to commence normal playback again Skip directory Press the 6 FL button to skip to the next directory or the 5 FL button to skip to the previous directory Playback starts automatically Search functions Title number search e Press the A PS button Turn the VOL knob to set the first digit of the title number required e Press the SEL button to confirm the entry and to skip to entry of the second third or fourth digit Press the 1 PAU button to commence playback of the selected title Title name search Press the A PS button twice The search for title names starts immediately If no title starting with the digit set is found Turn the VOL knob until the desired character or digit appears Press the gt gt I or H button to confirm the character set and to display all titles beginning with the required character Press the 1 PAU button to commence playback of the title displayed Search for directories Press the A PS button three times The directory currently being played back is shown e Tu
7. rn the VOL knob to switch between the available directories Press the 1 PAU button to select the directory currently being displayed Playback of the first title from the selected directory starts immediately Connecting an external audio device to the device Connect the audio output of an external audio device e g an MP3 player via a 3 5 mm stereo jack plug to the AUX IN socket on the front panel of the device Select audio input playback by repeatedly pressing the MD button until AUX is shown on the display Memory Backup This unit is equipped with built in memory I C Integrated Circuits to save user settings such as tuner preset stations and audio control settings Whenever power is unplug these settings will not be lost Reset RESET To reset the device to its factory default settings press and hold 6 sec the RESET button with a pointed object such as a pen Reset the device e when operating for the first time Z gt after the cable connection if not all function buttons are working Fe Kr when an error message appears in the display Note To access the RESET button the face plate must be completely detached see also the section Removing the face plate WWW CALIBER NL CALIBER HEAD OFFICE The Netherlands Fax 31 0 416 69 90 OI E mail info calibernl
8. s switched on Turn the VOL knob to set the volume level used when the radio is turned on STEREO MONO Set the audio output Turn the VOL knob to set the audio output in radio mode to stereo or mono If you are receiving a stereo station the stereo symbol appears on the display LOUD Enable disable the loudness function Turn the VOL knob to increase base or treble levels LOUD ON or to disable the function LOUD OFF When the loudness function is enabled LOUD is shown on the right of the display SPEAKERS Turn the VOL knob to turn ON or OFF built in speakers DX LOCAL Set reception sensitivity Turn the VOL knob to align the reception sensitivity to national stations DX or regional stations LOCAL ADJ Set the time Turn the VOL knob to the right to set the minutes and to the left to set the hours Note The device has an RDS controlled clock The clock sets itself automatically when the RDS function is enabled and continues to run when the radio is switched off If you do not receive any RDS signal you can set the time of day manually Radio functions Selecting the station memory band Press the BD button to switch between station memory bands FM1 FM2 FM3 Each station memory band covers the same frequency range and has 6 memory locations Automatic station search Keep the gt gt I or K lt button pressed to start automatic station search The search stops when a station is found Manual station selection Pres
9. s the gt gt I or I44 button briefly to change the frequency until the required frequency is set Storing radio stations Keep one of the 1 to 6 buttons pressed for about 3 seconds to store the station currently selected The showing of numbers 1 to 6 on the display indicates a successful store Selecting stations stored Use BD to select the station memory band FM1 FM2 FM3 Press one of the 1 to 6 buttons to select the station stored Automatic storing Keep the A PS button pressed for 3 seconds A search starts immediately and stays for about 5 seconds at each station found The station indicator and or the station frequency flashes and the memory slot is displayed The search continues automatically when weak stations are found Run through the stations stored Press the A PS button briefly All stations are selected briefly When you hear the required station press the A PS button The station chosen remains selected Programme type PTY You can use this function to search for a particular type of station The following settings are available POP M ROCK M NEWS AFFAIRS INFO EASY M LIGHT M SPORT EDUCATE DRAMA CLASSICS OTHER M CULTURE SCIENCE VARIED JAZZ COUNTRY WEATHER FINANCE CHILDREN NATION M OLDIES SOCIAL RELIGION PHONE IN FOLK M TRAVEL LEISURE DOCUMENT Note Please note that this information is dependent on region broadcasting corporation and station Setting the PTY ID Keep pressing the MD button unti
10. t be connected by car ignition FUSE 7 5A key in order to avoid that car battery being drained when the car will be not used for long period CONNECTOR B REAR RIGHT SPEAKER REAR RIGHT SPEAKER FRONT RIGHT SPEAKER FRONT RIGHT SPEAKER FRONT LEFT SPEAKER FRONT LEFT SPEAKER REAR LEFT SPEAKER REAR LEFT SPEAKER oND d e wN gt General operations Switching on and off Press any button to switch the device on To switch off press and hold the 0 MU button pressed Volume Turn the VOL 3 knob to set the volume Switching mute on off Press the MU button briefly to turn the sound off Press the MU button again to turn the sound on again Muting is cancelled when receiving a PTY or TA station Operating mode Press the MD button to switch between AUX TUNER USB SD mode Display Keep pressing the BD button to have the following information displayed in turn Radio station time automatically set with RDS reception frequency and PTY settings these RDS functions are sent by broadcasting services in various volumes also refer to Section Radio functions Settings using the SEL 2 button VOL BAS TRE BAL FAD Press the SEL button on the device The current volume level is shown Each further press of the SEL button accesses the next setting The following settings are possible 1 J SEL 2 SEL 3 SEL 4 SEL 5 SEL 2 Eee 0 1 Volume 2 Bass 3 Treble 4 Balance
Download Pdf Manuals
Related Search