Havis C-VS-1600-EXPL car kit
Contents
1. Havis Inc 75 Jacksonville Road PO Box 2099 f S Warminster PA 18974 T 800 524 9900 F 215 957 0729 www havis com HAV Productivity in motion INSTALL INSTRUCTIONS C VS 1600 EXPL 16 VEHICLE SPECIFIC CONSOLE 2006 2010 FORD EXPLORER TOOLS NEEDED Screw Driver Set Wire Crimping tool Wire Cutters Torx Bit Set Socket set QTY DESCRIPTION PART 1 Hardware kit Torx C HK 1 4 4 Flat washer GSM31005 4 14 20 x 34 Hex head bolt GSM33001 1 Duct block off plate CM001517 l Duct block off plate gasket CM001518 Always gt Read all instructions before installing any Havis Inc products gt Check for obstructions Wire brake lines fuel tank etc before drilling any holes gt Use hardware provided with install kit C VS 1600 EXPL_INST_6 09 docx6 09 O E M console prior to removal Carefully remove Remove O E M cup chrome trim bezel holder assembly 7mm ti Unplug 12volt socket Remove O E M console housing 7mm If vehicle has MP3 or USB ports Remove O E M console you must remove plugs and A relocation plate for the MP3 and USB housing 7mm reconnect harness for Dash system plugs is not currently available It is up to work correctly to the installer to locate where desired Remove O E M console housing 7mm or 10mm 10mm Driver amp Pass Remove front side bolts Remove rear side bolts 10mm Driver amp Pass C VS 1600 EXPL_INST_6 09 docx6 09 Unplu2. g O E M housing Remove side panel O E M console harness Driver amp Pass completely removed Passenger side aes Remove one 1 floor nut on driver side and passenger side 1 1mm Install air duct block off Attach brackets to vehicle using O E M 11mm nut Make sure brackets plate and gasket using are pushed forward towards dash O E M bolt 11mm Remove 2 passenger side Pu ae shift lever into floor bolts and harness clip Drive and carefully Attach passenger side floor 10mm place new console with O E M bolts 10mm housing into position All floor brackets to the inside of housing w extension Reattach harness clip C VS 1600 EXPL_INST_6 09 docx6 09 Attach rear of housing to O E M bracket with O E M bolts 10mm Push front of housing down and forward while attaching to the floor brackets with supplied 4 x 34 hex bolts amp washers Two each side Attach rear of housing to O E M bracket with O E M Reattach front trim panels bolts 10mm Reattach chrome trim bezel Insert supplied cup holder Complete wiring and install control head s C VS 1600 EXPL_INST_6 09 docx6 09
Download Pdf Manuals
Related Search