Ergotron Cart 32
Contents
1. 14 Cleaning and Maintenance Cart and Equipment Electric Safety There are specific risks associated with the use of equipment having power cables You must be aware of and avoid these risks when the Cart is located in close proximity to children A WARNING Failure to observe the following Electrical Safety notices can result in fire or death by electric shock A Electrical cables can be hazardous Misuse can result in fire or death by electrical shock e Double Pole Neutral Fusing e Inspect power cables thoroughly before each use e Do not use cables that are damaged e Insert the plug completely into the outlet e Grasp the plug to remove from the outlet e Do not unplug by pulling on the cable e Do not use excessive force to make connections e Do not plug the cable into an extension cable e Do not remove bend or modify any metal prongs or pins of cable e Do not drive drag or place objects over the cable e Do not walk on the cable e Avoid overheating Uncoil the cable and do not cover it with any material e Do not run cable through doorways holes in ceilings walls or floors A Keep the Cart away from water e Do not use it when wet e Do not place the Cart in close proximity to flammable liquids or gases This cart is intended for use only with loading as indicated Use with loads greater than indicated may result in instability causing possible injury 4 The cart power cord acts as the connect disconn2. only with loading as indicated Use with loads greater than indicated may result in instability causing possible injury A AX WARNING Tip Hazard Do not allow children to use cart without adult supervision Failure to follow this warning may result in injury or equipment DO UU A TR caipmentdamage Do not push lt a side of cart Do not pull cart Product of China 827 466 00 11 of 12 Specifications This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference 2 This device must accept any interference received including interference that may cause undesired operation This Class A digital apparatus complies with Canadian ICES 003 Cet appareil num rique de la classe A est conforme a la norme NMB 003 du Canada ZORE TIZATRRNRE CT COREE REI CHAT SCR RMSE EEZ LTZ ENEE T COMBIMEREY BS WREST SLIBKENATEMPBV ET VCCI A Cart dimensions 23 W x 18 4 D x 39 3 H 58 4 x 46 7 x 100 cm Shipping dimensions 46 1 x 29 9 x 22 8 in 117 x 76 x 58 cm Cart weight w o equipment 32 Unit Cart 100 Ibs 45 4 kg Shipping weight 48 Unit Cart 126 5 Ibs 57 4 kg 32 Unit Cart 147 Ib 67 kg 48 Unit Cart 175 5 Ib 80 kg Rated weight capacity Top Work Surface 25 Ib 11 3 kg Power system Bottom Shelf 32 Unit Carts only 25 b 11 3 kg 100 120 V 12A 50 60 Hz or 220 230 240 V 5 5A 50 60 Hz Maximum tablet size Depending o
3. 00 rev Be 05 14 1 of 12 Safety Hazard Review These symbols alert users of a safety condition that demands attention All Charging and Managed Cart users should be able to recognize and understand the significance of the following Safety Hazards if encountered on the Cart or within Cart documentation Children who are not able to recognize and respond appropriately to Safety Alerts should not use the Cart without adult supervision Symbol Signal Word Level of Hazard A NOTE indicates important information that helps you make better use of your Cart A CAUTION indicates either potential damage to hardware or loss of data CAUTION and tells you how to avoid the problem A WARNING indicates either potential for property damage personal injury or death An Electrical indicates an impending electrical hazard which if not ERECT RIEA avoided may result in personal injury fire and or death Components One Tablet Management Cart 2 Keys Includes 32 48 USB to Lightning Cables Features 48 Unit Management Cart Handle LED Power Indicator Individual Status Indicators ISI Tablet Access Doors Keyed Locks 2 Non locking Casters AC Adaptor Cradle Auxilary Power Outlet s USB Port Fans one for each module Cord Wrap Bay and Power Cord 2 Locking Casters 32 Unit Management Cart Bottom shelf 888 24 272 G 00 rev Be 05 14 3 of 12 Tablet Charging module Connect the tablet USB chargi
4. 8 31 33 45 45 600 and use of its products it will not be held liable for any editorial errors or omissions including those 1 651 681 7600 www ergotron com made in the process of translation from English to another language or for incidental special or www ergotron com info eu ergotron com consequential damages of any nature resulting from furnishing this instruction and performance of l e ie l sales ergotron com equipment in connection with this instruction Ergotron Inc reserves the right to make changes in the product design and or product documentation without notification to its users For the most current product information or to know if this document is available in languages other than those herein please contact Ergotron No part of this publication may be reproduced stored in a retrieval system or APAC Sales Worldwide OEM Sales transmitted in any form or by any means electronic mechanical photocopying recording or otherwise without the prior written consent of Ergotron Inc 1181 Trapp Road Eagan Minnesota 55121 USA Tokyo Japan www ergotron com Patents Pending and Patented U S amp Foreign Ergotron is a registered trademark of Ergotron Inc www ergotron com info cem ergotron com apaccustomerservice ergotron com 1208120 888 24 272 6 00 tev B 05 14
5. Tablet Management Cart for iPad ERGOTRON L iPad qa www ergotron com 48 Unit Management Cart 32 Unit Management Cart USA 1 800 888 8458 N Europe 31 0 33 45 45 600 China 86 769 86018920 Table of Contents Hazard SVIVUIOIS ROVICW se cccsnqunstsaneraesiocenieateserm E 2 OTITIS COONS E E E eee E E sameness 2 FE ILS cas coz acs spon tarias ayepeasn on E E E SEEN A EEE E A E 3 PALE CUTAN GING AEA E E E E O E E A A E E 4 KEDO Sy NN E E E A E E E TE 8 Cable Replacement Instructions seeesseessseesssesssessseesssesssessseeoseeussesssessseesssesseessseessresseesssessseesseessseessees 7 Cleaning and Maintenance eeesseesseeessseesseesssesssessseesssesssessseeoseeesseosseesssessecosseesssesseeoseesssesseeoseeesseessses 11 DERCOS searen A A A EE E A EA 12 Service and Warranty Information essseesessoossessseesnssseeessssessssseeensssrensssseoonssesonssserensssrensssereessssesessses 12 Apple iPad iPad Air iPad mini iTunes Lightning Retina and Macintosh are trademarks of Apple Inc registered in the U S and other countries Made for iPad means that an electronic accessory has been designed to connect specifically to iPad and has been certified by the developer to meet Apple performance standards Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards Please note that the use of this accessory with iPad may affect wireless 888 24 272 G
6. crewdriver to remove the two screws located on the interior sides of the module save screws to reinsert later 888 24 272 G 00 rev Be 05 14 7 of 12 need to unplug two cables before sliding the drawer completely out Open the strap to access the two cables 3 Partially slide out the module drawer You ll d 4 Unplug the USB and DC power cables push up on the lever under the DC connector to release The drawer can now be removed t AD 5 Unwind and remove the existing USB cables from drawer NOTE Please recyle or dispose the removed cables in a responsible manner Bof12 0 888 24 272 6 00 rev B 05 14 6 Connect the USB cable to the USB port the cart top and route the USB cable through the slot on the back of the drawer and under the hooks toward the front Make sure there is no slack in the cable All excess cable should hang from the hooks F Place the drawer upside down on Repeat USB cabling steps 6 through 8 for the rest of the iPad devices going into this module 8 888 24 272 G 00 rev Be 05 14 9 of 12 Reconnect the USB and DC cables and wrap the straps around the cables 9 Slide the drawer partially into the module Slide the drawer completely into the module Insert the screws removed in step 2 and tighten Insert iPad devices into module Connect the tablet USB charging cables to the iPad devices I0of12 TT 888 24 272 6 00 tev B 05
7. ect sevice switching power off and on A CAUTION Changes or Modifications not expressly approved by Ergotron could void the user s authority to operate the equipment Cart Use Safety There are specific risks associated with the use of Cart when moving or stationary for charging or storage You must be aware of and avoid these risks when the Cart is located in close proximity to children A WARNING Failure to observe the following Cart Use Safety notices may result in serious personal injury or equipment damage Only Adults should move this cart e Do not allow anyone to sit stand or climb on the Cart e Do not lift the Cart from the bottom e Do not block the fans and vent openings To prevent overheating leave at least 127 mm 5 inch clearance around fans and vents The Cart is designed to be used indoors only e Do not use the Cart to transport or store equipment other than what has been noted in this guide e Do not use the Cart to store liquids or cleaning supplies e Do not place heavy objects on the Cart surface or shelf The maximum weight capacity of the top surface is 11 4 kg 25 Ib The maximum weight capacity of the shelf is 16 kg 35 2 Ib 888 24 272 G 00 rev Be 05 14 Moving the Cart e Before moving the Cart 1 Disconnect the power cable from the wall 2 Make sure the cable is wrapped and secure 3 Close and lock the doors 4 Remove items from the top work surface 5 Unlock the cast
8. ers e Push do not pull the Cart for optimum maneuverability and to prevent muscle strain e Do not move the Cart across rough uneven or irregular surfaces such as gravel Parking the Cart Observe these safety alerts for times when the cart is stationary e Do not park the Cart in areas of heavy traffic e Do not run cables through doorways holes in ceilings walls or floors e Do not run cables across hallways classrooms or other areas where they will be walked on e Do not leave Cart unattended in areas where children have access e Keep Cart doors closed and locked whenever it is unattended or parked for charging or storage e Keep Cart casters locked whenever it is unattended TABLET J ERGOTROT MANAGEMENT CART Input Output 220 230 240 V 5 5 A 50 60 Hz ON Product was piac ed N13508 S ae ust 2005 f ERGOT ROT brn SANTCEMENT CART Input Output 100 120 V 12 A 50 60 Hz Aus 35MR Listen UL60950 ACCESSORY This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference 2 This device must accept any interference received including interference that may cause undesired operation This Class A digital apparatus complies with Canadian ICES 003 Cet appareil num rique de la classe A est conforme la norme NMB 003 du Canada Only Adults should move this cart N E e CAUTION This cart is intended for use
9. n region and model of Cart Individual tablet dimensions including cover up to 10 8 H x 7 7 W x 0 95 in D 27 4 x 19 6 x 2 4 cm Tip Test Angle 10 degrees Individual tablet weight up to 2 2 Ib 1 kg Environmental Temperature range LED status indicators ISI Optional feature Operating 0 to 30 C 32 to 86 F Lights indicate power status and syncing activity Storage 40 to 60 C 40 to 140 F 32 Unit Cart 32 LED lights Relative humidity maximum 48 Unit Cart 48 LED lights Operating 10 90 non condensing Storage 5 95 non condensing Cooling ventilation Altitude maximum 2000 m 6 562 ft One 12 volt DC continuous operation fan in each module Compatibility External power outlet s Made for One or two outlets depending on region iPad Air 100 120 V 3A 50 60 Hz or iPad 4th generation 220 230 240 V 1 5A 50 60 Hz iPad mini with Retina display iPad mini Service and Warranty For Service on the Ergotron Tablet Managing Cart for iPad Visit www ergotron com www ergotron com MADE IN CN NOTE When contacting customer service reference the serial number 12 345 678 UNDO VOUQIVQLIQQUUE AT UN TECT 1234567 1234 Americas Sales and Yercor 2013 Ergotron Inc Corporate Headquarters EMEA Sales pT Ne SEINE St Paul MN USA Amersfoort The Netherlands While Ergotron Inc makes every effort to provide accurate and complete information on the installation 800 888 845
10. ng cables to the iPad devices Repeat Steps 1 10 for the other modules 7 Insert iPad devices into To begin charging the tablets plug in the Cart power cord ES The power cord is used to turn the Cart power on and off Charging occurs whenever the cart power cord is connected UNLESS a Macintosh or PC notebook USB cable is connected to the cart for syncing F NOTE the cart power cord acts as the connect disconnect device switching power off and on A of 12 888 24 272 G 00 rev B 05 14 LED Indicators Power Indicator communicates sync and charge status with the following signals r Orono Computer is plugged into auxillary USB outlet and iPad devices are ready to sync or are syncing Fault Status Please make sure all cables are seated correctly with On fast blink in cable drawer and cart is operating within specified operating temperature Contact Ergotron Customer Support if problem continues Individual Status Indicators ISI sequentially numbered LEDs corresponding to each tablet in the module i Green Fully charged f Amber Charging in progress ida NOTE if module is syncing all ISIs will be green Tablet Syncing Vy NOTE Complete the Tablet Charging instructions before syncing iPad devices should be charged at least 50 before starting the rA syncing process Syncing can be done using iTunes or the Apple Configurator program available for the Macintosh computer Please
11. reference www Apple com for more information NOTE The devices will not charge while syncing is in process To return to charge mode unplug the USB cable from the Tablet Management Cart USB port when syncing is complete The iPad devices will mount as USB devices when the A to B USB cable not included is connected to a host notebook via the USB port on the exterior of the Tablet Management Cart If using iTunes please see separate iTunes setup instructions available on the Ergotron website Tablet Management Cart product page 888 24 272 G 00 rev Be 05 14 5 of 12 Syncing Place your Apple device power adaptor and a USB cable on the cart work top 2 Plug the USB and power adaptor cables into the notebook route the ends of the cables down the side of the cart and strap the power adaptor into the recessed area to store 2 Connect the notebook USB cable to the port on the side of the cart Connect the Apple device power 4 adaptor into the auxilary outlet on the side of the cart Tuck the access cables into the recessed area Switch on the notebook power to begin syncing 6 of 12 888 24 272 G 00 rev B 05 14 Cable Replacement Instructions Make sure the Module power cord is disconnected from wall power supply before proceeding Unlock the module and open the doors F NOTE the Module power cord acts as the connect disconnect device switching power off and on 4 Use a Phillips s
Download Pdf Manuals
Related Search