Philips Hairclipper 5100
Contents
1. outlet Use only the cord provided EJ The Charging Light on the appliance will light up green continuously to indicate the Clipper is charging fig 2 D It will take approximately 8 hours to fully charge the Clipper for a cordless clipping time of up to 75 minutes E Disconnect the cord and unplug from electrical outlet Optimize the working life of the battery b After the Clipper has been charged for the first time do not recharge the Clipper between clipping sessions Continue using it until the battery is completely empty Do not charge for more than 24 hours Do not keep cord permanently plugged in Discharge run down the battery completely twice a year by letting the motor run until it stops If the Clipper hasn t been used for a long period of time it must be recharged for a full 8 hours Corded Hair Clipping Only use the Clipper corded when the battery is almost empty Clipper does not recharge during corded clipping El Connect cord provided to Clipper fig 1 and plug Clipper into electrical outlet PA If battery is completely empty wait a few minutes before switching clipper ON Ee Turn Clipper ON to begin clipping fig 3 EJ When finished clipping turn Clipper OFF and unplug Cordless Hair Clipping EE Charge according to directions Unplug Clipper from outlet and remove cord FJ Turn Clipper ON to begin clipping fig 3 EJ If the charge runs out while c2. ENGLISH IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance basic safety precautions should always be followed including the following Read all instructions before using this appliance DANGER To reduce the risk of electric shock 1 Do not reach for a clipper that has fallen into water Unplug immediately Use clipper only in dry condition Do not use while bathing or in a shower Do not submerge clipper in water Do not place or store clipper where it can fall or be pulled into a tub or sink Do not place in or drop into water or other liquid 5 Always unplug this clipper from the electrical outlet immediately after using except when clipper is re charging 6 Unplug clipper before cleaning 7 When discarding clipper unplug clipper to remove rechargeable battery See Battery Removal instructions WARNING To reduce the risk of burns fire electric shock or injury to persons ae NS 1 Close supervision is necessary when this appliance is used by on or near children or invalids 2 Use this clipper for its intended household use as described in this manual Do not use attachments not recommended by Philips Electronics North America Corporation 3 Never operate this clipper if it has a damaged cord or plug if it is not working properly if it has been dropped damaged or dropped into water For assistance visit our website www philips com norelco or call 1 800 243 3050 Do n
3. Y SPECIAL INCIDENTAL OR CONSEQUENTIAL DAMAGES In order to obtain warranty service simply go to wwwphilips com norelco or call 1 800 243 3050 for assistance It is suggested that for your protection you return shipments of product by insured mail insurance prepaid Damage occurring during shipment is not covered by this warranty NOTE No other warranty written or oral is authorized by Philips Electronics North America Corporation This warranty gives you specific legal rights and you may also have other rights which vary from state to state Some states do not allow the exclusion or limitation of incidental or consequential damages so the above exclusion and limitations may not apply to you Read enclosed instructions carefully Manufactured for Philips Consumer Lifestyle A Division of Philips Electronics North America Corporation PO Box 10313 Stamford CT 06904 This symbol on the product s nameplate means it is Listen listed by Underwriters Laboratories Inc Norelco is a Registered Trademark of Philips Electronics North America Corporation PHILIPS is a Registered Trademark of Koninklijke Philips N V 2013 Philips Electronics North America Corporation All Rights Reserved PHILIPS NORELCO 45 DAY MONEY BACK GUARANTEE If you are not fully satisfied with your Philips Norelco Clipper send the product back and we ll refund you the full purchase price The Clipper must be shipped prepaid by insured mail i
4. b off the Clipper fig 8 Be careful when you are clipping without comb attachment as when the Clipper is turned on it will remove every hair it touches BA To contour the hairline around the ears comb the hair ends over the ears eq Tilt the Clipper in such a way that only one edge of the cutter blades touches the hair ends when you shape the contours around the ears Only cut the hair ends The hairline should be close to the ear E1 To contour the nape of the neck or sideburns turn the Clipper and make downward strokes fig 9 EJ Move the Clipper slowly and smoothly following the natural hairline Clean the attachments after each use Always switch Clipper OFF unplug and remove power supply cord from Clipper before cleaning Do not use compressed air abrasive cleaning agents scourers or aggressive liquids such as alcohol benzene bleach or acetone to clean the Clipper and attachments Never clean replace or remove Clipper attachments with motor ON Never rinse or immerse the Clipper in water or any other liquid Do not apply pressure to cutters Do not touch cutters with hard objects as this may damage them During Use D If cut hairs have accumulated in the comb area remove hairs by shaking blowing or using cleaning brush provided After Each Use EE Make sure the Clipper is switched OFF and disconnected from the electrical outlet FJ Remove the hair clipping comb by pressi
5. ing hairs too short As you become familiar with the settings adjust the Hair Length Slide Switch to desired trimming length Trimming Length Settings Table Imm 3 64 in 13mm 1 2 in 3mm 1 8 in 15mm 5 8 in 5mm 3 16 in 17mm 11 16 in 7mm 9 32 in 19mm 3 4 in 9mm 3 8 in 21mm 13 16 in 11mm 7 16 in 23mm 7 8 in EJ Make sure that the flat part of the comb is always in full contact with the scalp to obtain an even result fig 7 KJ Since all hairs do not grow in the same direction move the appliance slowly over the crown from different directions i e upwards downwards and across to achieve an even result Always move the appliance against the direction of hair growth EJ Make overlapping passes over the head to ensure that all hair that should be cut has been cut EJ For best results with curly sparse or long hair use a styling comb to guide the hair towards the Clipper I Turn the Clipper off regularly during clipping and remove the hair clipping comb to blow and or shake out hair that has accumulated TIP Write down the settings you have used to create a certain hairstyle as a reminder for future clipping sessions Clipping without hair clipping comb Use the Clipper without a comb to clip hair very close to the skin 0 5mm 1 32 inch or to contour the neckline and area around the ears Ei Remove the hair clipping comb by pressing and sliding the com
6. lipping simply connect cord provided to Clipper and outlet to continue clipping Hair Clipping Use this Clipper for its intended household use as described in this manual p Make sure that the appliance is fully charged before you start clipping hair Before you start clipping make sure that the head of the person whose hair you are cutting is at the same level as your chest so that all parts of his her head are clearly visible and within easy reach Only use the appliance on clean dry hair Do not use on freshly washed hair Before you begin comb the hair in the direction of growth fig 4 To achieve optimal clipping results always move the appliance slowly through the hair against the direction of hair growth Clipping with hair clipping comb E Be certain the Clipper is in the OFF position BA Slide the hair clipping comb into the guiding grooves on both sides of Clipper and push until you hear it click into place fig 5 Make sure the comb locks properly into position EJ Turn the Adjustable Hair Length Setting Slide Switch to the desired setting fig 6 The Clipper can cut hair up to 13 different lengths See table below Ef The remaining hair length is indicated in millimeters on the adjustable slide switch When you are clipping for the first time start at the maximum clipping length setting 23mm 7 8 in to familiarize yourself with the appliance and prevent accidentally trimm
7. ng and sliding the comb off the Clipper fig 8 EJ Clean the comb with the brush supplied or rinse under warm water fig 10 E Press the release button 1 and remove the cutting unit 2 fig 11 EJ Clean the cutting unit with the brush supplied or rinse under warm water fig 12 EJ Clean the inside of the Clipper with the brush supplied fig 13 Shake off any excess water and allow to air dry EJ Reattach cutting unit by inserting the notch of the cutting unit into the guiding slot EJ Push the cutting unit back onto the Clipper I Clean the handle and the adapter with a soft dry cloth NOTE The Clipper does not need any lubrication Replacing the Cutting Unit If your cutters become damaged or worn do not continue using the Clipper Replace cutters immediately El Press the release button 1 and remove the cutting unit 2 fig 11 PJ Place the notch of the new cutting unit in the guiding slot 1 and push the cutting unit onto the Clipper 2 fig 14 You will hear a click This Clipper has no other userserviceable parts For assistance call 1 800 243 3050 Assistance For assistance call toll free 1 800 243 3050 or visit our website www philips com support Online information is available 24 hours a day 7 days a week Be sure Clipper is turned OFF Remove cord from outlet and Clipper before storing in a safe dry location where it will not be crushed banged or s
8. nsurance prepaid have the original sales receipt indicating purchase price and date of purchase and the money back guarantee return authorization form enclosed We cannot be responsible for lost mail The Clipper must be postmarked no later than 45 days after the date of purchase Philips Norelco reserves the right to verify the purchase price of the product and limit refunds not to exceed suggested retail price To obtain money back guarantee return authorization form call 1 800 243 3050 for assistance Delivery of refund check will occur 6 8 weeks AFTER receipt of returned product
9. o The Test Like many new products your Philips Norelco Hair Clipper may take a little getting used to If you are using an electric Clipper for the first time or if you ve been using a different brand take the time to acquaint yourself with your new Hair Clipper Your Hair Clipper features a double sharpened steel cutting element with reduced friction Throw your scissors away and put your new Hair Clipper to the test Ve guarantee precise results or Philips Norelco will refund you the full purchase price as long as the request is received within 45 days of purchase Features Hair Clipping Comb Cutting Unit Adjustable Hair Length Setting Slide Switch On Off Button Charging Light Socket for Appliance Plug Cleaning Brush Adaptor Appliance Plug Storage Case Full Two Year Warranty 45 Day Money Back Guarantee TILATMOOS gt Y OA 13 5 SNINE S CHN To Charge Recharge Fully charge Clipper before using for the first time or after non use for a long period of time Battery performance is best if you recharge only when the battery is almost completely empty Charging recharging or using Clipper at temperatures below 40 F or higher than 95 F adversely affects lifespan of the battery Continuously recharging Clipper will reduce lifespan of battery EE Be certain Clipper is OFF PJ Insert the appliance plug directly into the Clipper fig 1 and plug the adapter into any 120V AC
10. ot rinse or immerse the clipper handle in water or any other liquid Keep the clipper cord and any attachments away from heated surfaces Never drop or insert any object into any opening Do not operate charge or plug in clipper outdoors or where aerosol spray products are being used or where oxygen is being administered Always check cutters cutting unit and comb before using the clipper Do not use the clipper if cutters cutting unit or comb are damaged as injury may occur Always attach plug to clipper first then to outlet To disconnect turn on off switch to OFF position then remove plug from outlet 10 To prevent possible damage to the cord do not wrap cord around the clipper 11 Use only the cord provided to charge and re charge clipper 12 Never put clipper in direct sunlight or store at a temperature above 140 F 13 This clipper is for use on human hair only Do not use this clipper for any other purpose 14 Only use the power plug and other accessories supplied with the clipper SAVE THESE INSTRUCTIONS IMPORTANT The power plug contains a transformer Do not cut off the power plug to replace it with another plug as this will cause a hazardous condition Registration Congratulations on your purchase and welcome to Philips Norelco a ov oS go o To fully benefit from the support that Philips Norelco offers register your product at www norelco com register Put It T
11. ubject to damage Do not wrap cord around Clipper when storing Store cord in a safe location where it will not be cut or damaged Do not place or store Clipper where it can fall or be pulled into a tub or sink water or other liquid while plugged in Battery Removal D This Philips Norelco Clipper contains a rechargeable Nickel Metal Hydride battery which must be disposed of properly fig 15 Battery should only be removed when Clipper is to be discarded For assistance visit our website www philips com support or call toll free 1 800 243 3050 EE Unplug electrical cord from outlet and Clipper before dismantling Clipper PJ Allow Clipper to run until the battery is empty depleted EJ Turn Clipper OFF EJ Remove the hair clipping comb and cutting unit from the handle EJ Press the release button 1 and remove the cutting unit 2 fig 16 EJ Insert the screwdriver between the motor unit and the back panel of the appliance Press down the screwdriver as far as it will go fig 17 Tilt the handle of the screwdriver downwards 1 and separate the back panel from the appliance 2 fig 18 EJ Remove the back panel Pull the bottom part of the printed circuit board with the rechargeable batteries attached from the appliance fig 19 EJ Cut the wires to separate the rechargeable batteries from the appliance fig 20 M Do not attempt to replace battery Insulate battery ends by co
12. vering with tape and or place battery in a small plastic bag iJ Discard your Clipper Do not attempt to plug electrical cord into the outlet or recharge the Clipper after the battery has been removed fy Contact your local town or city officials for battery disposal information or call 1 800 8 BAT TERY or www rbrc com for battery drop off locations PHILIPS NORELCO HC3422 Rechargeable Cordless Cord Always here to help you Register your product and get support at www norelco com register 4222 002 8425 2 Full Two Year Warranty Philips Electronics North America Corporation warrants each new Philips Norelco product Model HC3422 except cutters and comb against defects in materials or workmanship for a period of two years from the date of purchase and agrees to repair or replace any defective product without charge IMPORTANT This warranty does not cover damage resulting from accident misuse or abuse lack of reasonable care the affixing of any attachment not provided with the product or loss of parts or subjecting the product to any but the specific voltage Use of unauthorized replacement parts will void this warranty PHILIPS ELECTRONICS NORTH AMERICA CORPORATION WILL NOT PAY FOR WARRANTY SERVICE PERFORMED BY A NON AUTHORIZED REPAIR SERVICE AND WILL NOT REIMBURSE THE CONSUMER FOR DAMAGE RESULTING FROM WARRANTY SERVICE PERFORMED BY A NON AUTHORIZED REPAIR SERVICE NO RESPONSIBILITY IS ASSUMED FOR AN
Download Pdf Manuals
Related Search