Breville VKJ142 electrical kettle
Contents
1. t stay in the on position wait a few seconds before trying it again Always keep your Hot Cup topped up with water between the MIN and MAX markings That way you ll ensure that it s always ready to use and don t forget unlike an ordinary kettle this will have no effect on the energy your Hot Cup uses A Beware of accidentally operating the on off switch If you do immediately switch it off again Alf your Hot Cup has been switched on for more than 15 seconds hot water will still be dispensed Do not attempt to move your Hot Cup from the base Allow the water to escape into the drip tray Beware of hot water splashing from the drip tray Alf you have started the boil procedure and then decide to switch off your Hot Cup always allow it to stand for 1 minute before removing it from the power base for refilling etc A Always switch off and unplug your Hot Cup and allow it to completely cool before cleaning Never immerse the base unit power cord or plug in water or any other liquid Do not use harsh abrasives chemicals or oven cleaners Emptying your Hot Cup 1 GE ON o After your Hot Cup has completely cooled down unplug it from the mains supply socket Press the lid release button Hold your Hot Cup sideways over a sink Then tip your Hot Cup upside down Still holding your Hot Cup over the sink turn it the right side up and allow any water to drain out of the dispensing nozzle Repeat steps 3 4 and 5 unti2. the sound of the internal valve operating after the boil cycle finishes The Hot Cup is still too hot after the last boil cycle Wait a few seconds for it to cool slightly before trying again Check the Hot Cup is plugged in and switched on at the supply socket Check that the dispensing nozzle is positioned centrally over the drip tray Check the fuse in the plug Allow the Hot Cup to cool down completely then refill it with water e Fill with water between the MIN and MAX markings then restart the boil cycle Descale your Hot Cup Allow it to finish the boil cycle and dispense any water into the drip tray Allow any water in the drip tray to cool down then empty it This is normal operation There is a residual amount of This is normal operation water left inside the Hot Cup after the boil cycle Steam is being vented in a controlled manner through designed vents This is normal operation connection to the mains supply This appliance is fitted with either a moulded or rewirable BS1363 13 amp plug The fuse should be rated at 13 amps and be ASTA approved to BS1362 If the fuse in a moulded plug needs to be changed the fuse cover must be refitted The appliance must not be used without the fuse cover fitted If the plug is unsuitable it should be dismantled and removed from the supply cord and an appropriate plug fitted as detailed below If you remove the plug it must not be connected
3. to a 13 amp socket and the plug must be disposed of immediately The wires of the mains lead are coloured in accordance with the following code GREEN YELLOW EARTH BLUE NEUTRAL BROWN LIVE The wire which is coloured GREEN YELLOW must be connected to the terminal in your plug which is marked with an E or by the earth symbol or coloured GREEN or GREEN YELLOW The wire which is coloured BLUE must be connected to the terminal in your plug which is marked with the letter N or coloured BLACK The wire which is coloured BROWN must be connected to the terminal in your plug which is marked with the letter L or coloured RED If any other plug is used a 13 amp fuse must be fitted either in the plug or adaptor or at the distributor board Plug should be BS1363 approved Fit a 13 Amp Fuse GREEN YELLOW Earth 13 Amp Fuse BLUE Neutral Ensure that the outer sheath of the cable is firmly held by the clamp 13 after sales service These appliances are built to the very highest of standards There are no user serviceable parts Follow these steps if the unit fails to operate 1 Check the instructions have been followed correctly 2 Check that the fuse has not blown 3 Check that the mains supply is functional If the appliance will still not operate return the appliance to the place it was purchased for a replacement To return the appliance to the Customer Service Department follow the steps below 1
4. Breville gt HOT clip g Instructions for use product safety This product can be used by children aged 8 years and above and persons who require supervision provided e they are familiar with the hazards associated with the product and e they receive instruction by a competent person on how to safely use the product Children must not play with the product Cleaning and user maintenance must not be done by children unless they are aged 8 or older and are supervised Never use a power base other than the one supplied with the appliance Never fill the kettle above the MAX marking If the kettle is overfilled boiling water may be ejected If the supply cord is damaged it must be replaced by the manufacturer its service agent or similarly qualified persons in order to avoid a hazard Please read these instructions before operating the appliance and retain them for future use A This appliance generates heat during use Adequate precaution must be taken to prevent the risk of burns scalds fires or other damage to persons or property caused by touching the exterior whilst in use or during cooling A Never use this appliance for anything other than its intended use This appliance is for household use only Do not use this appliance outdoors A Always ensure that hands are dry before handling the plug or switching on the appliance A Always use the appliance on a stable secure dry and
5. Pack it carefully preferably in the original carton Ensure the unit is clean 2 Enclose your name and address and quote the model number on all correspondence 3 Give the reason why you are returning it 4 If within the guarantee period state when and where it was purchased and include proof of purchase e g till receipt 5 Send it to our Customer Service Department at the address below Customer Service Department Jarden Consumer Solutions Europe Limited Middleton Road Royton Oldham OL2 5LN UK Telephone 0161 621 6900 Fax 0161 626 0391 e mail info pulse uk co uk 14 guarantee Please keep your receipt as this will be required for any claims under this guarantee This appliance is guaranteed for 1 year after your purchase as described in this document During this guaranteed period if in the unlikely event the appliance no longer functions due to a design or manufacturing fault please take it back to the place of purchase with your till receipt and a copy of this guarantee The rights and benefits under this guarantee are additional to your statutory rights which are not affected by this guarantee Only Jarden Consumer Solutions Europe Limited JCS Europe has the right to change these terms JCS Europe undertakes within the guarantee period to repair or replace the appliance or any part of appliance found to be not working properly free of charge provided that you promptly notify the place o
6. f purchase or JCS Europe of the problem and e the appliance has not been altered in any way or subjected to damage misuse abuse repair or alteration by a person other than a person authorised by JCS Europe Faults that occur through improper use damage abuse use with incorrect voltage acts of nature events beyond the control of JCS Europe repair or alteration by a person other than a person authorised by JCS Europe or failure to follow instructions for use are not covered by this guarantee Additionally normal wear and tear including but not limited to minor discoloration and scratches are not covered by this guarantee The rights under this guarantee shall only apply to the original purchaser and shall not extend to commercial or communal use If your appliance includes a country specific guarantee or warranty insert please refer to the terms and conditions of such guarantee or warranty in place of this guarantee or contact your local authorized dealer for more information Waste electrical products should not be disposed of with Household waste Please recycle where facilities exist E mail us at info pulse uk co uk for further recycling and WEEE information Jarden Consumer Solutions Europe Limited Middleton Road Royton Oldham OL2 5LN UK 15 Breville 2013 Jarden Consumer Solutions Europe Limited All rights reserved Imported and distributed by Jarden Consumer Solutions Europe Limited Roy
7. ing your hot cup Before using your Hot Cup for the first time e Remove your Hot Cup carefully from the box Remove any packaging and promotional material and position your Hot Cup on a dry level secure work surface away from the edge e Follow the instructions below on using your Hot Cup and discard the first five measures of boiling water i e the first full tank of water This will remove any residues that may remain from the manufacturing process Using your Hot Cup A Always position your Hot Cup in such a way that the on off switch cannot be accidentally operated especially by children 1 Press the lid release button 2 Fill the water reservoir from your cold tap The water level should be between the MIN and MAX markings 3 Close the lid and position your Hot Cup on the power base Make sure the on off switch is in the off position then plug your Hot Cup in to a mains supply socket Place a suitable cup or container with a tea bag coffee sugar etc below the dispensing nozzle Never operate your Hot Cup without a cup or suitable container placed below the dispensing nozzle 4 Press the on off switch down to its on position The switch will light up blue 5 Afew seconds before the water has finished dispensing the on off switch will automatically switch to its off position 6 Boiling water will be dispensed into the cup Your Hot Cup is now ready to use again If after just having boiled the on off switch doesn
8. l the water has been emptied from your Hot Cup If your Hot Cup will not be used for an extended period e g if you are on holiday we recommend that you first empty it Before using your Hot Cup again carry out several boil cycles discarding the water each time Cleaning Clean the exterior surface of the kettle with a damp cloth and then polish with a soft dry cloth Do not use steel wool pads or harsh abrasive cleaners safety and efficiency To ensure the safe and efficient operation of your Hot Cup it is important to descale it regularly The harder your water the more regularly it will need doing Your water company should be able to tell you how hard the water is in your area Untreated scale deposits prevent the element conducting heat efficiently therefore wasting electricity Scale can also cause your Hot Cup to malfunction or even cause premature failure Descaling using a proprietary descaling product 1 Fill your Hot Cup to the MAX fill level and place an empty cup on the drip tray Set the on off switch to the on position and wait for the water to be dispensed into the cup 2 Add a citric acid based proprietary descaling product to the hot water in the cup and stir 3 Tip the contents of the cup into your Hot Cup and close the lid 4 Place the empty cup on the drip tray and set the on off switch to the on position 5 Wait for the water to be dispensed into the cup 6 Discard the water from the cup 7 Repea
9. level surface A This appliance must not be placed on or near any potentially hot surfaces such as a gas or electric hob A Do not use the appliance if it has been dropped if there are any visible signs of damage or if it is leaking A Ensure the appliance is switched off and unplugged from the supply socket after use and before cleaning A Always allow the appliance to cool before cleaning or storing A Never immerse any part of the appliance or power cord and plug in water or any other liquid A Never let the power cord hang over the edge of a worktop touch hot surfaces or become knotted trapped or pinched A Never leave the appliance unattended when in use A Beware of steam coming from the spout or lid especially during refilling Never open the lid during the boiling cycle A Never fill the appliance when it is positioned on the power base A Never use the kettle without sufficient water in the kettle for it to operate correctly A Never allow the appliance to boil dry identifying the parts SNS 0 On Off button Lights up blue when in the on position Lid Lid release button Press to open the lid and fill the water tank Illuminated water reservoir Easy fill water reservoir holds up to 1 5 litres Heating chamber Dispensing nozzle Stainless steel drip tray cover Removable drip tray No mess just lift it out and rinse under the tap Holds over 1 cup of water before it needs emptying Power base us
10. resh water to the MAX fill level and place an empty cup on the drip tray 6 Set the on off switch to the on position and wait for the water to be dispensed into the cup 7 Discard the water in the cup Repeat steps 6 and 7 until the water level is at the MIN mark Open the lid and empty any remaining water into the sink 8 Finally rinse your Hot Cup several times with clean water 10 troubleshooting The on off switch will not stay The Hot Cup has not reset in the on position The water tank does not illuminate and the Hot Cup does not dispense boiling water The Hot Cup produces excess steam but does not dispense boiling water The on off switch has been manually switched off during the boil cycle but hot water is still dispensed The Hot Cup makes a noise and there is a clunk sound after water has been dispensed Water drips from the dispensing nozzle after the boil cycle has finished Steam comes out from behind the on off button and behind the dispensing nozzle 12 itself after the boiling cycle The Hot Cup is not plugged in The Hot Cup is not positioned correctly on its power base The fuse has blown The Hot Cup has boiled dry The water level has dropped below the MIN level The Hot Cup has excessive scale The Hot Cup is designed to boil a set volume of water Once the temperature of the water reaches a certain level it will automatically be dispensed This is
11. t steps 4 5 and 6 until the water level is at the MIN mark Open the lid and empty any remaining water into the sink Rinse your Hot Cup by filling it with clean water and emptying it into the sink see Emptying your Hot Cup on page 6 Fill your Hot Cup with fresh water to the MAX fill level and place an empty cup on the drip tray 8 Set the on off switch to the on position and wait for the water to be dispensed into the cup 9 Discard the water in the cup Repeat steps 8 and 9 until the water level is at the MIN mark Open the lid and empty any remaining water into the sink see Emptying your Hot Cup on page 6 Descaling using vinegar or citric acid 1 You can use ordinary vinegar white or malt or citric acid to descale your Hot Cup Inexpensive ordinary vinegar can be purchased in large bottles from any supermarket Citric acid can be bought from pharmacies home brewing winemaking suppliers or on line retailers 2 If you are using vinegar make up a solution of 1 cup of vinegar to 1 cup of water If you are using citric acid mix 30g of the citric acid with 500m of water 3 Pour the solution into your Hot Cup close the lid and allow it to stand for 1 hour 4 Cycle your Hot Cup as described in steps 4 6 above until the level is at the MIN mark Open the lid and empty any remaining solution into the sink Rinse your Hot Cup several times by filling it with clean water and emptying it into the sink 5 Fill your Hot Cup with f
12. ton Oldham OL2 5LN United Kingdom The product you buy may differ from the one shown due to continuing product development One 1 Year Limited Warranty see inside for details Jarden Consumer Solutions Europe Limited is a subsidiary of Jarden Corporation NYSE JAH Made in PRC www breville co uk VKJ142_VKJ256_Iss_7 09 13 92846 6
Download Pdf Manuals
Related Search