Crosley Country Kitchen Wall Phone
Contents
1. WAL MOUNTING HOLES DALMODE L TONE FOGE RECEVER VOLUME Yj 1w LNE CORD JACK SPEAKER ya2. Wah philips screwdriver begin tightening the screw CLOCKWISE Stop turning when you feel frm resistance Turn the screw counter clockwise until the screw head is about 1 4 out of the wall Install the 7 foot line cord at back of the telephone Adjust the switches to your preference Position the line cord through the slot on the bottom of the cabinet Line up the holes with the two screws Place the telephone onto these two screws and gently pull down This may require a ite fine tuning until the phone is seated securely p vm mt fe armen nataan INSTRUCTION TO USE FCC Registration Information This equipment complies with Part 68 of the FOC rules On the lower side of the equipment is alabel tnat contains among other information the FOG registrator number and the Finger quivalence Number REN for this equipment if requested provide this information to your telephone company The REN is useful to determine the quantity of devices you may connect to your telephone line Excessive REN s on the telephone line may result in the devices not ringing in response to an Incoming call In most areas but not all areas the sum of the REN s should not exceed five 5 0 To be certain of the number of devices you may connect to you lines as determined by the REN you should call your local telephone company to determine the maximum REN for your calling area If your telephone equipment causes harm to the te
3. allows you to tum the ringer OFF or set it to ring at either LOW or HIGH volume You can still make or receive calls with the ringer in the OFF position however you will not hear the incoming ring RECEIVER VOLUME The RECEIVER VOLUME CONTROL switch located on the rear of the telephone body allows you to adjust the volume of the receiver earphone from LO and Hl HANDSET CORD To assemble insert one end of handset cord into the HANDSET CORD JACK and the other end to the HANDSET CORD JACK located on the left side of the telephone body INSTALLATION MODULAR WALL JACK To install the telephone directly on modular wall jack 1 Connect the 15 inch line cord to the LINE CORD jack on the rear of the telephone body 2 Tuck the line cord into the channel on the cabinet rear 3 Peel and stick the rubber pads on rear of telephone cabinet in designated areas 4 Hold the telephone body up next othe modular jack and plug the Ine cord into ihis jock 5 Tuck the excess line cord into the recess provided on the rear of the telephone body 6 Li Pa le mounting holes of the telephone body with the mounting studs screw heads on the modular jack or wall 7 Push the telephone body ac pot the wall jack and down until it is held securely in place by the mounting stu WALL Ifyou are not mounting directly onto a modular wall jack proceed as follow 1 Install the 7 foot line cord into the LINE CORD jack on the rear of the tel body I
4. use detergent waxes solvent spray alcohol or excessive water HOLD LINE MUTE H you want to talk privately to someone else in the room without the distant party hearing you you con press hold button once You will still be able to hear the distant party but anyihing yov say will not be heard When you press the button again the distant party will be able to hear your voice again ANSWERING CALLS WITH SPEAKER Press Speaker button when the phone rings You can adjust the s sliding Speaker HI MID LOW switch Changing answering method from Handset fo Speaker Frost Speaker Bonon and place te handeet back onthe cradle simultaneously LAST NUMBER REDIALING The last number dialed can be redialed using either peaker phone or the normal telephone This is especiali sel if the dialed ine was busy Pres he redial buton e unit will automatically redial the lost dialed number ble volume level by PARTS INCLUDED Your new telephone includes the following items 1 Telephone handset lepton cod Telephone bod 1 7 Feat line cord 1 15 Inches line cord 2 Screws with wall archors 1 Wall mounting template 4 Rubber spacer pads 2 Tapping screw 1 Template See above picture and instructions LOCATION OF PARTS HANDSET CRADLE PEAKER HOLD INDICATOR GRANK SH HANDLE west us SPEAKER SWITCH L Himinnow HANDSET CORD STORAGE COMPAREMENT
5. AID via standard UPS or its equivalent CROSLEY RABIO ATTN RETURNS DEPT 2001 PRODUCTION DRIVE BAY283 LOUISVILLE KY 40299 CROSLEY RADIO assumes no responsibilty for units sent without prior Retur Authorization The purchaser s bil of sale is the only proof of warranty entitlement and must accompany the unit The warranty does not cover damage due to acts of naturo accident misuse abuse negligence commercial Use ot modification of or to any part of the product Ths warranty does nol cover damage due to improper Spetaton or mainienance connection to mproper volage supply or altempted repair by anyone other han 2 faciity authorized by Crosley Radio to service the product ThS warranty does not cover products sold AS IS or consumables Such as fuses or batteries This warranty is vald only in the United States This warranty gives the purchaser specified legal rights in addition to any rights which may vary from state to state In accordance with the Mose Magnuson Warranty Act of July 10 1975 this is termed a imited warranty which in no way compromises Crosley Radio high standards of Quality and Workmanship SET UP DIAL MODE Locate the DIAL MODE switch on the rear of the telephone body Slide the switch to Tone unless you have Dial Pulse Rotary telephone service in your area in which case slide the switch fo the PULSE position RINGER CONTROL The RINGER CONTROL switch is on the rear of the telephone body It
6. TOP KEY HOLE A USE THIS TEMPLATE TO DETERMINE THE POSITION OF TELEPHONE ON WALL AND WHERE TO LOCATE SCREW HOLES REMOVE TEMPLATE FROM WALL BEFORE INSERTING PLASTIC ANCHORS OR SCREWS USE ONLY FOR WALL INSTALLATION OF TELEPHONE SET KEY HOLE B z IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment basic safety precautions should always be followed to reduce the risk of fire electric shock and injury to persons including the following Read and understand alll instructions Follow all warnings and instructions marked on the product Unplug this product from the wall outlet before cleaning Do not use liquid cleaners or aerosol cleaners Use a damp cloth for cleaning Do not use this product near water for example near a bathtub wash bow kitchen sink or laundry tub in a wet basement or near a swimming pool Do not place this product on an unstable cart stand or table The product may fall causing serious damage to the product Slots and openings in the cabinet and back or bottom are provided for ventilation to protect it from overheating these openings must not be blocked or covered The openings should never be blocked by placing the product on the bed sofa rug or other similar surface This product should never be placed near or over a fadiator or heat register This product should not be placed in a built in installation unless proper ventilation is provided 7 This product shou
7. f the desired location is further than 7 foot from a wall jack you will have to obtain a longer line cord available at most hardware stores 2 Place the provided TEMPLATE against the wall in the position desired 3 Mark the wall by poking ether a pen or pencil rough the indicated spots on the template 4 If there is no stud at this location it will be necessary to install the provided wall gnchors Dril a small pilot hole at the marked locations Tap the anchors into the hol ert screws but DO NOT TIGHTEN Leave the screw heads protruding about Ms inch 5 If there is a stud at this location simply install the two screw into the stud REMEMBER Leave screw head protruding 6 Telephone is then mounted according to procedure detailed in MOUNTING TO MODULAR PLUG NOTE If you encounter difficulty fitting the telephone body onto the screw or the telephone wobbles when installed either fighten or loosen the screws to adjust TO INSTALL WALL ANCHORS It the location you have chosen to mount your telephon will Nave to use the included wall anchors To install place the template against the wall where you wish to place your telephone Mark the wall atthe location of the two on the template by pushing a pen or pencil through the template Drill a 1 4 hole at each mark a hollow wall without any beams you Push the wall anchor into the hole and gently tap until it is flush with the wall
8. ld be operated only from the type of power source indicated on the marking label If you are not sure of the type of power supply to your home consult your dealer or local power company 8 Do not allow anything to rest on the power cord Do not place this product where the cord will be abused by persons walking on it 9 Some telephones require AC power from the outlet Do not overload wall outlets or extension cords as this can result in the risk of fire or electric shook 10 Never push objects of any kind into the product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock Never spill liquid of any kind on the product 11 To reduce the risk of electric shock do not disassemble this product but take itto a qualified serviceman if service or repair work is required Opening or removing covers may expose you to dangerous voltages or other risks Incorrect reassembly can cause electric shock when the appliance is subsequently used 12 Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions A When the power supply cord or plug is damaged or frayed B If liquid has been spilled on the product C f the product has been exposed to rain or water D Ifthe product does not operate normally by following the operating Instructions adjust only those controls that are covered by the operating instruc
9. lephone network the telephone company will notify you In advance that temporary discontinuance of service may be required But if advance notice le nol practical the telephone company wil notify the customer as soon as possible Aiso you will be advised of your right to file a complaint with the FOC if you believe it is necessary MAKING AND ANSWERING CALLS Te get a cial tone or answer an incoming call ift the handset fo hang up either replace the handset or simply press the HANDSET CRADLE IN CASE OF DIFFICULTY Hf you are having problems with your telephone try the following suggestion NO DIAL TONE T Moles sure that all plugs aes conocia pipah Chiaki caise al the Wall Jack thetlolankane cobwatand yarata 2 Try another modular jack within your home which you know to be working properly CALLS CANNOT BE DIALED OR DIALED SLOWLY Check to make sure that the DIAL MODE switch is in the correct position for the type of service available in your area TELEPHONE DOES NOT RING Check that RINGER CONTROL switch is not set to OFF If there are several telephones connected to the same line try disconnecting some of the other telephones Having too many telephones connected fo the same line can cause low ringer volume or poor sound quality during calls CARE AND MAINTENANCE Avoid rough treatment fo the telephone Do not drop the handset and always replace igeni onto the cradle Clean only with a cloth slightly dampened with water only Do not
10. tions Improper adjustment of other controls may result in damage and will often require extensive work by a qualify technician to restore the product to normal operation E If the product has been dropped or the cabinet has been damaged F If the product exhibits a distinct change in performance 13 Avoid using a telephone other than a curdies type during an electrical storm There may be a remote risk of electric shock from lightning 14 Do not use the telephone to report a gas leak in the vicinity of the leak oo SAVE THESE INSTRUCTIONS Country Kitchen Phone WARRANTY Crosley Radio Products are warranted against defects in material and workmanship for a period of 90 days beginning from the date of sale to the original purchaser Should the unit fail under normal usage during the 90 day warranty period a request for RETURN AUTHORIZATION FLA must be made by the original customer before returning the unit Call Crosley Radio customer service for tum Authorization at 502 583 4246 from 9 AM to 5 PM EST Monday to riday Upon receiving the RETURN AUTHORIZATION number from the Customer Service Department properly pack your unit in its original packaging Include any adapters parts amp accessories which were originally provided with the product along with a check or money order for 19 95 made out to Crosley Radio to cover the handling and return postage Display the R A on the outside of the carton and ship PREP
Download Pdf Manuals
Related Search