Denver IFI-140 docking speaker
Contents
1. output volume on the device itself Plug the AC DC adaptor into wall outlet and plug the connector into the DC IN jack on the unit Volume level is set too high SPECIFICATIONS General Specifications Power Source of Main Unit DC 5V 2 5A Center positive or 6 x AA size batteries Not included AC DC Adaptor Input AC100 240V 50 60Hz 0 5A Output DC 5V 2 5A Center positive Audio Power 2x2W SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE 5 Accessories 1 x User s Manual 1 x AC DC Adaptor www facebook com denverelectronics DENVER ELECTRONICS www denver electronics com2. ave marks or a rubber residue on the furniture To prevent any damage to your furniture we strongly recommend that you purchase small self adhesive felt pads available at hardware stores and home improvement centers everywhere and apply these pads to the bottom of the rubber feet before you place the product on fine wooden furniture CARE AND MAINTENANCE 1 Avoid operating your unit under direct sunlight or in hot humid or dusty places 2 Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors 3 Unplug the unit from the electrical power outlet immediately in case of malfunction CLEANING THE UNIT To prevent fire or shock hazard disconnect your unit from the AC power source when cleaning xx The finish on the unit may be cleaned with a dust cloth and cared for as other furniture use caution when cleaning and wiping the plastic parts 3 If the cabinet becomes dusty wipe it with a soft dry dust cloth Do not use any wax or polish sprays on the cabinet 3 If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft cloth slightly dampened with a mild soap and water solution Never use abrasive cloths or polishes as these will damage the finish of your unit wide CAUTION Never allow any water or other liquids to get inside the unit while cleaning TROUBLESHOOTING GUIDE If you experience difficulties in the use of this Docking System please c
3. g station on the top of the unit The connecting iPod iPhone will start recharging You can also playback the music files in the iPod iPhone as follows 1 Remove the cover of the iPod iPhone Docking as Tha IPHONE IPOD shown on the figure below Fig1 4 2 Insert the iPod iPhone to the docking as shown cel l below If the power source of the unit is AC i EJ del U DC Adaptor When iPod iPhone is inserted it CI will recharge automaticallv Fig2 Fig 1 Fig 2 AUX IN To listen to the music from the external audio device or non dockable iPods as follows ix When insert the 3 5mm stereo plug to the AUX Jack on the rear of unit it will convert to Aux in automatically when extract the plug it will convert to iPod automatically 1 Connect the external audio device or iPods iPhone by an audio connection cable with 3 5mm stereo plug on both ends Cable not included 2 Insert one end to the AUX Jack on the real of unit Insert the other end to the Phones Jack Line Out Jack or AUX Jack on the external audio device or iPods Protect Your Furniture This model is equipped with non skid rubber feet to prevent the product from moving when you operate the controls These feet are made from non migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture However certain types of oil based furniture polishes wood preservatives or cleaning sprays may cause the rubber feet to soften and le
4. heck the following AC DC Adapter is not plugged into a wall outlet or The unit does the connector is note plugged not respond no into the DC IN jack on the back of the unit y Plug another device into the same outlet to confirm Wall outlet is not functioning the outlet is working Remove your iPod iPhone from the dock and iPod iPhone is not installed check for obstruction on the connectors in the dock iPod iPhone properly and on your iPod iPhone Then reseat it on the does not respond dock to the speaker Please make sure that your iPod iPhone is working system E A A properly before docking into the unit Your Jodi hone ts oeked up Please refer to your iPod iPhone manual for info on resetting the iPod iPhone a i Remove your iPod iPhone from the dock and check iPod iPhone is not installed for ob i h in the dock and iPod iPhonelproperly for ol struction on the connectors in the dock an WT oles not on your iPod iPhone Then reseat it in the dock h iPod iPhone is locked up Please make sure your iPod iPhone is working charge frozen iPod iPhone battery properly before docking into the unit Please refer has problem to your iPod iPhone manual for details on resetting If the iPod iPhone original sound source is of poor quality distortion and noise are easily noticed with high power speakers Try other file If you are using an external sound source Sound source is distorted like older generation of iPod try reducing the
5. i _ __ o na DENVER IFl 140 User Manual Docking system for iPhone IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lighting flash with arrowhead symbl within an equilateral triangle is intended to alert user to the presence of uninsulated dangerous voltage within the product s enclosure that may be of sufficient magnitude to constitute a risk of electric The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance servicing instruction in the literature accompanying the applicance Electric and electronic equipment contains materials components and substances that can be hazardous to your health and the environment if the waste material discarded electric and electronic equipment is not handled correctly Electric and electronic equipment is marked with the crossed out trash can symbol seen below This symbol signifies that electric and electronic equipment should not be disposed of with other household waste but should be disposed of separately All cities have established collection points where electric and electronic equipment can either be submitted free of charge at recycling stations and other collection sites or be collected from the h
6. ompartment A reversed battery may cause damage to the device 3 Do not mix different types of batteries together e g Alkaline and Carbon zinc or old batteries with fresh ones 4 If the batteries in the device are consumed or the device is not to be used for a long period of time remove the batteries to prevent damage or injury from possible battery leakage 5 Do not try to recharge the battery not intended to be recharged it can overheat and rupture Follow battery manufacturer s instructions 6 Do not dispose of battery in fire Battery may explodes or leak 7 Clean the battery contacts and also those of the device prior to battery installation AC DC Adaptor 1 Insert the DC Plug from the supplied AC DC Adaptor to the DC IN Jack on the rear of unit 2 Insert the AC DC Adaptor into wall outlet having AC 100 240 50 60Hz NOTES ix When AC DC Adaptor was connected the battery power will cut off automatically x This AC DC Adaptor is intended to be correctly orientated in a vertical or floor mount position IX When connected the iPod iPhone to the docking it will be charging automatically 3 If Apparatus will not be used in a long period of time To avoid damage the unit Unplug the AC DC Adaptor from the wall outlet and take out all batteries Docking and Charging The iPod iPhone This unit is designed with the same connector found in most iPod and iPhone docks When connecting the supported iPod iPhone to the dockin
7. ouseholds Additional information is available at the technical department of your city E CE LOCATION OF CONTROLS TOP VIEW REAR VIEW D AUXIN 7 8 9 POWER button Press the POWER Button to turn on the unit To power off Standby mode the unit press and hold the POWER Button until Power LED OFF then release the button 2 POWER indicator 3 iPod iPhone Docking Connector 4 Speaker 5 VOL VOL button Press VOL or VOL Button to adjust volume level desired 6 Handle 7 Aux in jack 8 DC Input Jack 9 Battery Door GETTING STARTED The unit is design to use the supplied AC DC adaptor or 6 x AA size batteries batteries not included Batteries To install or replace batteries 1 Open the battery door on the rear of unit 2 Install 6 six AA size batteries into the battery compartment as the polarity markings inside 3 Replace the battery door NOTES 1 Alkaline batteries are recommended for longer operation time 2 In battery operation mode for saving the battery power the connected iPod iPhone will not be charging BATTERY PRECAUTIONS Follow these precautions when using a battery in this device 1 Use only the size and type of battery specified 2 Be sure to follow the correct polarity when installing the battery as indicated in the battery c
Download Pdf Manuals
Related Search