Argoclima HI FAN HIFI
Contents
1. CE E CERAMIC FAN HEATER alga alii hfs OPERATING INSTRUCTIONS Read the instructions carefully before installing and operating the appliance or performing maintenance operations Observe all the safety instructions failure to observe the instructions may cause accidents and or damages Store these instructions for future reference V 07 11 7 GENERAL SAFETY INFORMATION Use this ceramic fan heater only as outlined in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons Ensure that the mains power complies with the voltage specified on the fan heaters data plate 230V 50Hz This product is not a toy Children should be adequately supervised to ensure that they do not play with the appliance This appliance is not suitable for use by persons including children with reduced physical sensory or mental abilities or without the necessary experience and knowledge unless they have been adequately supervised and instructed concerning use of the appliance by a person responsible for their safety Do not cover the appliance or restrict the air inlet and outlet grilles to prevent overheating Ensure that all objects are at least 1 meter from the front and sides of the appliance Disconnect the mains power when the appliance is not used or for cleaning operations Avoid using the fan heater in dusty environments or in the presence of inflammable vapours e g in w2. the fan heater is covered or incorrectly positioned Upon initial start up the fan heater may emit a slight harmless smell This smell is a normal effect of the initial heating up of the internal heating elements and should not recur later on Non posizionare il termoventilatore sotto una presa WARNING DO NOT DEPEND ON THE ON OFF BUTTON SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN SERVICING OR MOVING THE HEATER ALWAYS UNPLUG THE POWER CORD ASSEMBLY INSTRUCTIONS Open the box and remove the 3 parts of the appliance body base and remote control unit 1 2 Combine the two halves of the base as shown in the diagram Unit Fastening element 3 Insert the base onto the lower part of the appliance and tighten the fastening element Unit Base Fastening element 4 Stand the appliance up vertically on a level surface before switching on V 07 11 9 DESCRIPTION OF PARTS 1 Soft touch control panel 2 Liquid crystal display 3 Air delivery grille 4 Carry handle 5 Intake grille with filter that can be removed for cleaning 6 On off button FRONT BACK HOW TO USE THE FAN HEATER Set up the fan heater in a vertical position on a level and stable surface Connect the power cord
3. to a suitable electrical socket 230 V On off button at the base of the rear cover below the removable air filter Bring the on off button to the I position When the appliance emits a beep this means that the fan heater is ready for use Bring the button to the O position to switch off the fan heater LCD DISPLAY High power display u Temperature display pas Timer display Low power display Zz Oscillation display Status display ON OFF STAND BY V 07 11 10 CONTROL PANEL TIMER TEMPERATURE Button Buttons When the appliance is operating the operating time Allow you to adjust the temperature and timer settings of the appliance can be set by touching the button the timer display shows a flashing 0 and the buttons can be OSCILLATION Button operated to set the desired time between 1 and 12 hours with each touch corresponding with 1 hour The display shows the set time wait 5 for the setting the button to make the appliance to be confirmed The unit will switch off automatically oscillate automatically shifting the air flow at the end of the programmed time from left to right The LED is switched on simultaneously When the unit is operating touch After the timer has been set touching the button once again will allow you to set the temperature Touch they button once again to interrupt the display will show the default temperature of the oscillation and switch off
4. It is not advisable to use extension cords as these may overheat and cause the risk of fire Do not use a single extension cord to operate multiple appliances Do not immerse the cord plug or any other element of the appliance in water or other liquids Do not touch the plug with wet hands Do not place the fan heater above or near another heat source WARNING AVOID COVERING THE FAN HEATER TO PREVENT IT FROM OVERHEATING The symbol below signals the above warning V N ya The fan heater may cause the risk of fire if while in operation is covered by or comes into contact with inflammable material including curtains drapery blankets etc KEEP THE FAN HEATER AWAY FROM THESE MATERIALS Do not connect the appliance to the mains power before it has been properly assembled and positioned V 07 11 8 The appliance heats up slightly when in use In order to avoid burns do not let bare skin touch hot surfaces Do not run the cord under carpets Do not cover the cord with blankets carpets or similar materials Place the cord far away from busy areas or where it cannot be accidentally pulled out Do not operate the fan heater in close proximity to bathtubs showers washbasins or pools Do not position the fan heater below a socket outlet Do not operate the appliance outdoors WARNING do not use the fan heater with a controller or any other external device that activates the appliance automatically as there may be a risk of fire if
5. a mild detergent at a temperature lower than 50 C Let the fan heater dry completely before use Do not use corrosive detergents or solvents such as petrol Do not wash the appliance with water Do not use oils chemical substances or other items to clean that may damage the surface Use a vacuum cleaner to remove dust from the air inlet outlet grilles Cleaning the filter Clean the filter frequently based on the environmental conditions under which the appliance is used a dirty filter may reduce the air flow rate and prevent the fan heater from working properly Remove the filter by pulling as shown in the diagram below Clean the filter using a vacuum cleaner and wash in water using a neutral detergent at a temperature below 30 C Leave the filter to dry after washing and refit it on the fan heater Aa UL a Ata Si 0000 Q Ae iij ANN l ii M Q Appliance casing Filter cover Air filter STORAGE If the appliance is not used for prolonged periods it must be stored together with this manual in its original packaging in a cool and dry place Information for correct disposal of the product in accordance with the Eu
6. orkshops or garages or paint vapours Do not use the appliance to dry clothing Use the appliance in a well ventilated area Avoid placing fingers or foreign objects in the air inlet outlet grilles as this may lead to electric shock or fire and may damage the appliance To avoid the risk of fire do not block the grilles or tamper with them in any way while the ceramic fan heater operates Do not use the appliance if the cord or plug are damaged If the power supply cord is damaged it must be replaced by the manufacturer dealer or a similarly qualified person so as to avoid any safety risks Do not operate the appliance if it has fallen from a height or has suffered damage in any way Contact qualified technical personnel to examine the appliance or perform any electrical or mechanical repairs The most common cause of overheating is the build up of dust in the appliance Remove dust deposits by unplugging the appliance and cleaning the air outlets and grilles with the aid of a vacuum cleaner Do not use abrasive detergents for cleaning this appliance Clean the appliance with the aid of a damp not wet cloth rinsed in hot soapy water Always remove the plug from the mains socket before cleaning To disconnect the ceramic fan heater push the switch to OFF and remove the plug from the socket Pull on the plug only Avoid pulling on the cord when disconnecting the ceramic fan heater Do not place any objects on the cord and do not bend it
7. rective no 2006 66 CE supplied with the remote control HOW TO INSERT REMOVE THE REMOTE CONTROL BATTERIES refer to the diagram below Open the battery cover at the rear of the remote control press and pull the cover Place the battery into the cover observing the correct polarity Insert the cover onto the remote control PER TIRA NE gt PREMI Ta W Inserimento pila Information for correct disposal of the battery in accordance with the European Directive 2006 66 EC Please replace battery when its electricity charge is used up please do not eliminate this battery together with normal household waste It must be taken to special local community waste collection centres or to a dealer providing this service Disposing of a battery separately avoids possible negative effects on the environment and human health deriving from an inappropriate disposal and enables its components to be recovered and recycled to obtain significant savings in energy and resources In order to underline the duty to dispose of this equipment separately the battery is marked with a crossed out dustbin V 07 11 11 MAINTENANCE ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE IMPORTANT DO NOT SUBMERGE THE CERAMIC FAN HEATER IN WATER Cleaning the outside surface of the appliance Use a soft cloth to remove any dust from the fan heater If the fan heater is excessively dirty use a soft cloth moistened with water and
8. ropean Directive 2002 96 EC At the end of its working life this equipment must not be disposed of as an household waste It must be taken to special local community waste collection centres or to a dealer providing this service Disposing of electrical and electronic equipment separately avoids possible negative effects on the environment and human health deriving from an inappropriate disposal and enables its components to be recovered and recycled to obtain significant savings in energy and resources In order to underline the duty to dispose of this equipment separately the product is marked with a crossed out dustbin improve your life www argoclima com MADE IN CHINA V 07 11 12
9. the LED 25 C and by operating the buttons the desired temperature can be set between 15 and 35 C Once the desired temperature has been set wait 5 for the setting to be confirmed After 5 the display will show the ambient temperature once again If no settings are made the default temperature is ON OFF STAND BY Button 25 C When the ambient temperatureiss 10 C the LED indicatorwill display LO when the ambient temperatureis gt 40 C the LED indicatorwill display HI When the ambient temperature isbetween 10 Cand 40 C the LED indicatorwill displaythe ambient temperature Touching the button will cause the low power LED to light and the appliance will begin to operate at low heating power 1500W Touching the button once again will lock all functions and place the unit in stand by The power LED will switch off To switch off the fan Heat completely place the POWER LEVEL SELECTION Button on off button in the 0 position l When the appliance is operating at the low heating power setting touch the WY button to switch to the high power setting and activate the LED at 2500W Press the button once again to switch back to the low power setting and light the LED at 1500W REMOTE CONTROL The remote control has six membrane buttons whose functions are identical to those on the control panel already illustrated in detail Use Lithium Manganese button cells model no CR2032 3 V compliant with Battery Di
Download Pdf Manuals
Related Search