Edimax ES-5500S network switch
Contents
1. 1 Physical Description 1 Panel Power LED 000 100 10Mbps LED LED Panel Speed J 5 Port Gigabit Switch POWEFPLNKIA eco 345 5 Port Link Activity LED CI RJ45 Connecto Power Connector Power LED 000 100 10Mbps LED lt LED Panel PA Speed 8 Port Gigabit Switch powteiunxncn e e ee 0o o 8 Port Link Activity LED E n pa RJ45 Connecton Power Connector Figure 1 1 Panel description 2 LED 5 8 Port Gigabit Switch Color Description Lit Power is supplied Green Q myl Off No power Lit A valid link is established LNK ACT Link Activity Flash Green Data packets received Off No link is established This port runs at 10Mbps A EN This port runs at 100Mbps This port runs at 1000Mbps Table 1 1 LED description 2 Installation 1 Operating Environment This switching hub must be installed and operated within the limits of specified operating temperature 32 131 F and humidity 10 95 Noncondensing Do not place objects on top of the unit Do not obstruct any vents at the sides of the unit Do not position the unit near any heating source such as heater radiator or direct exposure to sun Prevent entering of water and moisture into the unit If necessary use dehumidifier to reduce humidity 2 Connecting to network devices The RJ 45 ports on the switch support Auto MDI MDI X function which a2. llows using straight through or cross over type cables to connect this switch to workstation or hub Connect one end of the network cable to the RJ 45 port on the rear panel and connect the other end of the network cable to the RJ 45 port on the network device Follow the same procedure to connect all the RJ 45 ports of the switch The UTP network cables must comply with EIA TIA 568 specifications and Category 5 standard for 1000Mbps data transmission Maximum length using UTP cable between the switch and connected device is 100 meters 300ft Once the network cable is connected to both ends and the attached network device is powered on the green LNK ACT LED should be lit External Power Adapter 3 Connecting the power S th SAC Power Connect the output end of the power lt lt gt adapter to the power connector on the rear panel of the unit Connect the power adapter to the power outlet Figure 2 1 Connect the power adapter The green Power LED on the front panel should be lit 3 Trouble shooting 1 Power LED is not lit Check if the power cord is properly connected to the external power adapter and the power outlet Make sure the power jack is firmly plugged into the power socket of the switch 2 Link Activity is not lit when connect to 1000 100Mbps device Check the power switch of the network device attached to the switch make sure it is turned ON Check the network cable make sure it is properly c
3. onnected to the switch and the network device Check the network cable make sure the UTP cables comply with EIA TIA 568 and Category 5 specification Contact your dealer if problem persist
Download Pdf Manuals
Related Search