EK Water Blocks EK-DDC X-RES 100 CSQ
Contents
1. label OUT engraved on the pump top housing 2 The INLET port s suction port are the two recessed ports with G1 4 threading on the EK DDC X TOP front face plane You may use any of these two ports as an INLET port It is necessary to use the enclosed EK Extender G1 4 underneath the INLET fitting Please refer to the picture on the right Do not forget to close off the unused INLET port using EK Plug G1 4 3 Make sure not to use fittings or barbs with G1 4 thread longer than 5mm All EK PSC and High Flow fittings are compatible This water pump amp EK DDC TOP combo can be used in vertical mounting configuration position only Mounting the pump upside down may result in pump running dry and eventually lead to premature failure of the pump REQUIRED TOOLS g Revision 1 0 Released on 10 of October 20122. Installation and mounting manual for EK DDC X RES CSQ This product is intended for installation only by expert users Please consult with a qualified technician for installation Improper installation may result in damage to your equipment EK Water Blocks assumes no liability whatsoever expressed or implied for the use of these products nor their installation The following instructions are subject to change without notice Please visit our web site at www ekwb com for updates Before installation of this product please read important notice disclosure and warranty conditions printed on the back of the box Before you start using this product please follow these basic guidelines 1 Please carefully read the manual before through before beginning with the installation process 2 The EK High Flow and EK PSC type fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured by the rubber o ring gaskets 3 The use of corrosion inhibiting coolants is always recommended for any liquid cooling system 1 Unscrew the four screws that attaches the Laing pump s original factory top and the main pump core housing with motor Store these four screws as well as factory pump top in a safe place Install the EK DDC X RES on to the pump main motor housing Make sure you re use the original o ring gasket Reseat the gasket if needed You can rotate the DDC X RES in and use it in any di
3. rection 90 step turns 2 Secure the DDC X RES using enclosed M4x25 ISO7985 screws using enclosed 2 5mm Allen key Do not over tighten the Screws as excessive force may strip the threading Remember to keep the original o ring gasket Factory original pump top E Pump impeller i amp Sealing gasket OR DDC pump body with motor EK DDC X RES CSQ series pump top reservoir comes preinstalled with EK DDC X RES Anticyclone by default In case your system suffers from excessive vortex issues air bleeding problems or if the pump is sucking in air you may replace the anticyclone with the enclosed polyether foam There are two ways to use the polyether anti vortex foam This is the default configuration of EK Use the foam as a whole to replace EK DDC Trim the foam to size to fit into the desired DDC X RES series reservoir X RES Anticyclone inlet recess on the X RES main body EK DDC X RES CSQ series reservoir pump combo featured 3 three G1 4 threaded opening on the main body of which 2 two are inlets and one is outlet clearly marked with OUT EKWB recommends using EK PSC fittings with the EK DDC X RES CSQ series reservoir pump combo units To ensure that the tubes are securely attached to the barb fittings please use hose clamps or an appropriate substitute EK Plug G1 4 It is mandatory to use the correct INLET and OUTLET ports 1 The OUTLET port pressure port is clearly marked with
Download Pdf Manuals
Related Search