Ergotech Group 100-D28-B11 flat panel desk mount
Contents
1. A kA ann LFA IRA MAAA LAr Ay a We nn TT ne A NT AA I TFA r Log f Wea at VATI P TP AA MWA AnNnITAr y j rY nO i f TT A Fi ala 1w Q NA lIT y Py f 1 er f LO i J www ergotechgroup com2. ERGOTECH GROUP INC 8 Westchester Plaza ERGOTECH Elmsford NY 10523 914 347 3800 Installation Instructions Product 100 D28 B11 Dual Vertical Desk Stand 1 Check to see that small hex set screw at rear of base is backed out enough to allow pole to seat down completely Insert pole into base Tighten set screw using 3mm Allen key provided 2 Loosen ratchet type handle on pole clamp monitor mounting block Slide clamp and block down pole and tighten Repeat for upper assembly Note position along pole will depend on size of monitors being mounted These heights can be Allen key adjusted after the monitors are mounted 3 Attach quick release pivots to back of each monitor with screws provided Be sure that silver release button is toward the top of the monitor Release Button 4 Place each monitor on its mounting block by tipping back approximately 45 degrees and then down until the silver release button engages hole on block It will click into place 5 Repeat for upper monitor To adjust monitors Left Right and Up Down Grasp monitor with both hands and adjust to desired position To tension the vertical adjustment to the weight of monitor Tighten the 5mm bolt on the right side of the pivot with the hex wrench provided To remove monitor Take the weight from the monitor with one hand on the bottom and tip back slightly while AA e ES f4 h f EN ALTEA m mairana le Gnn AA AA n A
Download Pdf Manuals
Related Search