APC SMX3000RMHV2U + WBEXTWAR3YR-SP-04 uninterruptible power supply (UPS)
Contents
1. a ofa ofa TO Q a bobo i Controllable outlet groups ni a I su0495a The outlets on the UPS are configured into groups To configure the controlled outlet features use the Advanced menus on the display interface and navigate to Main Menu gt Control gt Outlet1 Control Emergency Power Off Connection Refer to the user manual included on the CD that is supplied with the unit for more information on how to connect the Emergency Power Off EPO Switch 6 Installation Guide Smart UPS X Tower Rack Mount 2U 100 240 Vac 2000 2200 3000 VA Electrical connections CAUTION RISK OF EQUIPMENT DAMAGE e Adhere to all local and national electrical codes e Wiring should be performed by qualified electrician e Always connect the UPS to a grounded outlet Failure to follow these instructions can result in equipment damage Connect equipment to the outlets on the rear panel of the UPS Connect the UPS to the building utility power To use the UPS as a master ON OFF switch turn on all the equipment that is connected to the UPS Press the ON OFF button on the front panel of the UPS to turn on the UPS and all connected equipment An Fw YN Refer to the Switched Outlet Groups section in the Operation manual for information on how to use the switched outlet groups su0475a Display Interface Online LED UPS Output On Of2. on the UPS are not blocked Allow adequate space for proper ventilation e The battery typically lasts for two to five years Environmental factors impact battery life Elevated ambient temperatures poor quality utility power and frequent short duration discharges will shorten battery life e Connect the UPS power cable directly to a wall outlet Do not use surge protectors or extension cords e The batteries are heavy Remove the batteries prior to installing the UPS in a rack e Always install external battery packs XLBPs at the bottom of the rack The UPS must be installed above the XLBPs e The UPS display interface will recognize as many as 10 external battery packs connected to the UPS However there is no limit to the number of XLBPs that can be used with the UPS Inventory ETTI COON G toe Ws Not included with 2 2 SMX3000RMJ2U model 230 V models only 1 Documentation CD 1 PowerChute software CD not included with SMX3000RMJ2U model Models with preinstalled network cards High voltage models only 2 Installation Guide Smart UPS X Tower Rack Mount 2U 100 240 Vac 2000 2200 3000 VA Installation Remove the battery A CAUTION DAMAGE TO EQUIPMENT OR PERSONNEL e The equipment is heavy Always practice safe lifting techniques adequate for the weight of the equipment e Remove the battery before installing the UPS in a rack Failure to follow these instructions can result in equipment damage and minor or mod
3. APC by Schneider Electric Installation Guide Smart UPS X Tower Rack Mount 2U 2000 2200 3000 VA Important Safety Messages Read the instructions carefully to become familiar with the equipment before trying to install operate service or maintain it The following special messages may appear throughout this manual or on the equipment to warn of potential hazards or to call attention to information that clarifies or simplifies a procedure The addition of this symbol to a Caution product safety label indicates that an electrical hazard exists which will result in personal injury if the instructions are not followed The following safety messages may appear throughout this manual to warn of potential hazards A CAUTION CAUTION indicates a potentially hazardous situation which if not avoided can result in equipment damage and minor or moderate injury CAUTION CAUTION indicates a potentially hazardous situation which if not avoided can result in equipment damage Safety and General Information Inspect the package contents upon receipt Notify the carrier and dealer if there is any damage Read the Safety Guide supplied with this unit before installing the UPS e Adhere to all local and national electrical codes e This UPS is intended for indoor use only e Do not operate this UPS in direct sunlight in contact with fluids or where there is excessive dust or humidity e Be sure the air vents
4. erate injury Use the battery handle to pull the battery out of the unit su0473b su0477b Four post rack installation Use the APC Four Post Rail Kit supplied su0552a oncavcacago CECELCCECCCCELI su0440a l 8 8 su0469a apoouoODooDoODOG su0559a 5555550555558 wW su0478a i Al W su0479a su0563a CECECCCECEGEEEE Installation Guide Smart UPS X Tower Rack Mount 2U 100 240 Vac 2000 2200 3000 VA su0474b Two post rack installation su0470a TALIA su0472a 9 Ji Installation Guide Smart UPS X Tower Rack Mount 2U 100 240 Vac 2000 2200 3000 VA soo Se ee Rack to tower conversion su0558a su0557a su0556a Installation Guide Smart UPS X Tower Rack Mount 2U 100 240 Vac 2000 2200 3000 VA su0583a su0564a Start Up and Configuration Overview 2000 VA Low Voltage SmartSlot UPS input Chassis ground screw Controllable Outlet Group 1 Controllable Outlet Group 2 Controllable Outlet Group 3 External battery pack connector EPO connector Serial port USB port 000000000 su0493a su0494a i rr Sey
5. f On Battery LED Site Wiring Fault LED Replace Battery LED Display screen UP DOWN arrow keys ENTER key ESC key oO 2 17 9 su0343a Installation Guide Smart UPS X Tower Rack Mount 2U 100 240 Vac 2000 2200 3000 VA J Select models are ENERGY STAR qualified onustez For more information go to www apc com site recycle index cfm energy efficiency energy star ENERGY STAR 2013 APC by Schneider Electric APC the APC logo and APC the APC logo Smart UPS and EN 990 3650E 002 PowerChute are owned by Schneider Electric Industries S A S or their affiliated companies All other 04 2013 trademarks are property of their respective owners
Download Pdf Manuals
Related Search