Technoline WS 9116 weather station
Contents
1. INTRODUCTION WS 9116 FEATURES e Four digit time display e 12 hour or 24 hour selectable time e Indoor temperature or F e Outdoor temperature or F e Minimum and Maximum temperature e Four level RF strength indicator e Wall hanging or free standing e Low battery indicator for receiver and transmitter SET UP NOTE This temperature station can receive one transmitter only e First insert batteries into the transmitter observing the correct polarity see marking inside battery compartment Keep transmitter 5 10 feet from the temperature station e Within 30 seconds of powering up the transmitter insert batteries into the Temperature Station observing the correct polarity see marking inside battery compartment Once the batteries are in place all segments of the LCD will light up briefly Following the indoor temperature will be displayed If the indoor temperature is not shown in the LCD after 60 seconds remove the batteries and wait for at least 60 seconds before reinserting them Once the indoor data is displayed you may proceed to the next step e After the batteries are inserted the Temperature Station will start receiving outdoor temp data from the transmitter The outdoor temperature should then be displayed on the Temperature station If this does not happen after 2 minutes remove the batteries from both units and start again from the beginning e In order to ensure sufficient 433 MHz transmission the outdo2. he MIX MAX button to move quickly through the numbers Press CF SET once and you are done MIN MAX RECORDING e VIEW MIN MAX Press the MIN MAX button to view indoor and outdoor MAX MIN and Current temperature e RESET MIN MAX Hold the MIN MAX button for 3 seconds to reset all MIN MAX readings to current temperatures RESET BUTTON The Temperature Transmitter has a RESET button Use a small pointed object to gently press and release to send a signal Follow the instructions for in SET UP regarding the display NOTE Removing power from the transmitter and display negates the need for the RESET button SPECIFICATIONS Indoor Temperature Range 0 C to 50 C 32 F to 122 F Resolution 1 F Outdoor Temperature Range 30 C to 60 C 22 F to 140 F Resolution 1 F Power Receiver 2 AAA Transmitter 2 AA Dimensions Receiver 65x30x95 7mm Transmitter 47x28 2x104mm
3. or transmitter should be placed a distance of no more than 100 feet 30 meters from the Temperature Station and the transmitter TEMPERATURE SELECTION FAHRENHEIT CELSIUS Press the CF SET button once to switch from Celsius to Fahrenheit FOUR LEVEL RF INDICATOR The temperature station will indicate strength of signal reception from the outdoor transmitter by the number of bars on the RF indicator icon 4 bars Shows after initial set up and stays when reception is at full strength 3 bars Indicates one reception failure from the outdoor transmitter 2 bars Indicates two reception failures from the outdoor transmitter 1 bar Indicates three reception failures from the outdoor transmitter 0 bars Indicates four reception failures from the outdoor transmitter The antenna symbol will flash on initial set while searching for the signal If it fails to receive a signal after 63 minutes the temperature station will display dashes The temperature station will search again for a signal for 3 minutes every next hour SET TIME e 12 24 HOUR TIME Hold the CF SET button until 12hr or 24hr flashes Press the MIX MAX button to switch between 12 hour and 24 hour time Press the CF SET button once to continue e HOUR The Hour will flash Press the MIX MAX button to change the hour Press the CF SET button once to continue e MINUTES The minutes will flash Press the MIX MAX button to change the minutes e NOTE Hold t
Download Pdf Manuals
Related Search