Draper FocalPoint 226"
Contents
1. each piece into extrusions on the adjoining piece see Fig 1 Tighten by turning color coded attachment knobs see Fig 2 Figure 2 Re leg pieces from case and place in the appropriate locations on the tarp Assemble leg according to color coded assembly map by inserting forks of front extension into extrusion on the leg base and tighten color coded attachment knobs Also attach vertical frame members in the same man ner Do not yet attach the back extension to the leg base see Fig 3 Place the screen frame on top of the legs see Fig 4 Figure 4 Caution S N B f OJ pinch pants Z d 411 S Pearl St Spiceland IN 47385 USA I 765 987 7999 www draperinc com I fax 765 987 7142 Copyright 2012 Draper Inc Form FocalPoint_Inst12 Printed in U S A Patent Pending Attach legs to frame see Fig 4 using provided Leg Cranks as follows Package A 3 cranks per leg Package B 4 cranks per leg and Package C 5 cranks per leg Leg Cranks should be placed as follows 1 at the low est attachment point 1 at the highest attachment point and the rest evenly spaced between the two Attach viewing surface to frame see Fig 5 Figure 5 Raise FocalPoint into place this step requires at least two people depend ing on screen size see Fig 6 Q Figure 6 Attach the back extensions to the leg bases see Fig 7 Figure 7 If provided attach Anti Sway2. Assembly Instructions FocalPoint Projection Screen by Draper A Caution Read instructions through completely before proceeding retain for future reference Handle viewing surface with care do not allow it to come in contact with sharp or dirty objects These instructions are based on assembly by a minimum of two people Make sure screen is level Do not write on viewing surface The ideal temperature range for assembling folding screens to prevent damaging the surface is 68 78 F 20 26 C Assembling below recommended temperatures may damage surface and void warranty Do not permit screen fabric to contact border material or loops when folded Store in pouch provided Frame Screen Assembly Remove tarp from case and place on the ground Remove frame pieces from case and place in the appropriate locations on the tarp Please Note For screens with Viewing areas of 18 or larger Draper ships a special corner labeled Large Screen corner If you did not order a complete screen do not use the standard corner for the large screens Contact Draper if needed Please Note Each piece is color coded refer to FocalPoint Assembly Map included with screen for correct layout see reverse side Please Note Frame pieces should be placed with forks running counter clockwise and DuraLoop Attachment Lugs facing out Figure 1 Assemble frame by inserting forks of
3. Stabilizers to the frame and legs First unhook the viewing surface from the bottom of the frame near the attach ment points Attach ends with threaded hole through the square extrusion to the fifth visible hole in from each end of the screen Attach end with metal extension to the closest leg extrusion hole see Fig 8 Figure 8 Please Note You may need to use the built in adjustment knob to short en or lengthen the Anti Sway Stabilizer so it will reach holes see Fig 9 X Adjustment Knob Figure 9 If provided attach HD Leg Braces to frame and legs Attach ends with threaded hole through the square extrusion to the frame Attach end with metal extension to the back foot extrusion see Fig 10 Figure 10 Warning This product is intended for indoor use only Failure to follow warning may result in product damage or personal injury due to unforeseen acts of nature If you encounter any difficulties assembling your FocalPoint call your dealer or Draper Inc in Spiceland Indiana 765 987 7999 or fax 765 987 7142
Download Pdf Manuals
Related Search