Premier PDS-028 project mount
Contents
1. PDS 028 Projector Bracket Installation Instructions M4 x 10mm Phillips Head Screws PDS 028 Bracket P Qty 4 Qty 1 E M4 x 10mm Security Head Screws Qty 4 Premier Mounts 3130 E Miraloma Ave Anaheim CA 92806 Phone 800 368 9700 Fax 800 832 4888 techsupport mounts com www mounts com 1 Invert the projector and place it on a soft and flat surface Remove any foot levelers that might possibly prevent the correct installation of the bracket 2 Locate the four mounting points located on the bottom of the projector 3 Line up the mounting points on the projector with the mounting holes on the PDS 028 mounting bracket Installation Instructions IN PDS028 RO PDS 028 Projector Bracket y D PREMIER Cad MOUNTS The original holding company Using a screwdriver secure the PDS 028 mounting bracket using four 4 M4 x 10mm Phillips Head screws Do not over tighten these screws Overtightening the screws may result in damaging the threaded inserts on the projector NOTE Please refer to the PDS Base Box Installation Instructions to attach the PDS Base Box to the PDS 028 mounting bracket NOTE The projector shown above is for illustration purposes only Page 1 4 D LOCK IT Security System 24 a PREMIER P MOUNTS The original holding company LOCK IT Security System Premier Mounts 3130 E Miraloma Ave Anaheim CA 92806 Phone 800 368 9700 Fax 800 832 4888 techsupport mou2. nts com www mounts com NOTE To utilize the LOCK IT Security System all M6 x 12mm Phillips Pan Head screws A must be removed prior to installing the M6 x 12mm Security Screws D Ca 1 Remove all pre installed M6 x 12mm Phillips Pan Head screws a A 6 total ke 9 2 Use the M5 Security Wrench B supplied to install and tighten the oe S se p M6 x 12mm Security Screws D amp Oy A 3 Using the security wrench supplied remove the M6 x 8mm standard i W D set screw and replace it with the M6 x 8mm security set screw C f 4 Insert the nylon washer G 1 4 flat washer H and the M6 x 12mm A Security Screw D into the pivot point I 5 5 Attach bracket to projector using security screws ow l N 6 Once the Phillips Pan Head screws have been replaced with the i aX LE security screws re attach the bracket E to the mount F SJ P i amp 7 Insert the four tilt adjustment security screws two per side Od 8 Follow the instructions in the PDS Manual to complete the installation Mounting Bracket Security Screws 1 Using a security wrench supplied secure the PDS 028 mounting bracket using four 4 M4 x 10mm Security Head screws Do not over tighten these screws Overtightening the screws may result in damaging the threaded inserts on the projector Page 2 Installation Instructions
Download Pdf Manuals
Related Search