Coby CX-CD250
Contents
1. COBYe MODEL NO CX CD250 PORTABLE CD RADIO STEREO CASSETTE PLAYER RECORDER with REMOTE CONTROL Please read instruction manual before use LOCATION OF CONTROLS 1 Function Selector 2 Volume Control 3 Cassette Operation Buttons 4 Cassette Compartment 5 CD Display 6 Remote Sensor 7 CD Operation Buttons 8 Tuning Indicator Window 9 CD Compartment Open Close Button 10 Tuning Control 11 Band Selector 12 CD Compartment 13 Telescopic Antenna 13 12 ti 10 9 8 Z 7 6 KS 5 2 4 REMOTE CONTROL ATTN PLAY button STOP button REW button F ANDON e RANDOM button PROG Button m REPEAT button Ree IMPORTANT SAFEGUARDS Always operate the product from a power supply of the same voltage frequency and rating as indicated on the product identification plate Do not operate product with a damaged cord or plug Never install the unit where there are heat sources such as radiators heat registers stoves direct sunlight excessive dust or where there is mechanical vibration or shock Switch off and unplug from AC outlet when not in use IMPORTANT The CD mechanism and the sensitive circuitry may cause interference to a radio tuner nearby Do not operate this unit while operating other radio devices Danger This product utilizes invisible laser radiation Avoid direct exposure to the beam Caution Use of controls adjustments or procedures not listed in this manu2. ROP 65 WARNING Handling the coated electrical wires of this product exposes you to lead a chemical known to the State of California to cause cancer birth defects and other reproductive harm Wash hands after use
3. al may result in hazardous radiation exposure CONCERNING COMPACT DISCS Only compact discs identified with this mark can be used with this player CARE and MAINTENANCE Handle your unit with care to extend the life of the unit Use a softand clean cloth damped with plain lukewarm water to clean the exterior of the unit Never use solvents such as benzene or other strong chemical cleaners since these could damage your unit Itis important that no liquid reaches the inside of the unit Do not touch the CD laser part or look directly at it COMPACT DIGITAL AUDIO INTRODUCTION Please read and follow the instruction manual carefully be fore operating in order to avoid any damage to the unit POWER SUPPLY 1 By using AC power Insert one end of the AC power cord into the AC socket on the rear of the unit and the other end into a standard wall socket 2 By using batteries Insert 8x D size batteries not included in the battery compartment in the back of the unit by matching the polarities The unit will not operate on battery power when the AC power cord is plugged into the AC socket Replace batteries when the power indicator dims the volume decreases or the sound distorts Use batteries of high quality and check them regularly Alkaline batteries are recommended Do not mix new batteries with old or used batteries Use only batteries of the same brand and type Batteries should not be left in the unit if th
4. ce to repeat all tracks 3 Press Repeat buton again to cancel repeat track repeat light will dim eTracking Mode 1 To go back to beginning of current track press monce 2 To go back to previous tracks press Mrepeatedly 3 To go to next track press once or repeatedly to play your desired track e Remote control You can also play with remote control there are Play pi Stop gg REW 4 F F W Repeat one and all PROGRAM RANDOM buttons on the remote you can operate the unit with corresponding button CASSETTE TAPE OPERATION 1 Set the FUNCTION Selector to the TAPE OFF position 2 Press STOP EJ ECT to open the tape deck door Insert a tape and close the door 3 Press PLAY to start play the tape will stop automatically at the end 4 Press Mto rewind or press to fast forward tape 5 Press STOP EJ ECT to stop play 6 Press STOP EJ ECT one more time to open the cassette door and take the tape out 7 Adjust the sound with the VOLUME control We recommend that you use only typel Normal Bias cassette tape with your tape player RECORDING FROM RADIO CD This unit is equipped with ALC Automatic Level control cir cuitry that automatically sets the recording to the optimum level Adjusting the VOLUME control does not effect the recording We recommend that the unit be powered by AC house current when recording since this function uses the most power We re commend that you use Type 1 normal bias cassette ta
5. ey are exhausted or if the unit is not to be used for a long period of time as they may leak and damage the unit Battery leakage is not covered under the warranty HEADPHONES Not included You can use headphones with 3 5mm diameter stereo plug and have impedance of 320hms When the headphones are con nected the speakers are disconnected automatically Set the VOLUME to a low level before using headphones and gradually adjust the Volume Control to the comfortable listening level Do not play the VOLUME too loud for extended periods of time to avoid any damage your hearing RADIO OPERATION 1 Slide the Function Selector switch to radio 2 Select the desired AM or FM with the band switch 3 Tune the desired station by turning the Tuning Control 4 Adjust the volume with Volume Control as desired 5 Extend Telescopic Antenna and adjust the direction and angle to obtain the optimum reception 6 Set the Function Switch to Tape for power standby mode CD OPERATION Set the FUNCTION Selector to the CD position and insert a CD Play Stop Pause Mode 1 Press PLAY PAUSE button to play 2 Press PLAY PAUSE button to pause while in play mode 3 Press PLAY PAUSE button once more to resume play 4 Press STOP to stop play 5 Always press STOP and wait for complete stop to remove CD from CD player e Repeat Mode 1 Press Repeat button once to repeat current track repeat light will flash 2 Press Repeat buton twi
6. pes only Recording from Radio 1 Set the FUNCTION Selector to the RADIO position 2 Set the BAND Selector to AM or FM 3 Turn the TUNING Dial to tune in a radio station 4 Open the cassette deck door and insert the blank tape 5 Press PAUSE then press RECORD the PLAY key is automati cally engaged with RECORD button 6 Release the PAUSE button to begin recording You can use the PAUSE button to edit any unwanted commercials or programs during your recording 7 Recording will stop automatically at the end of the tape or press STOP to end the recording manually Recording from CD 1 Set the FUNCTION selector to the CD position 2 Insert a CD 3 Open the cassette deck door and insert the blank tape 4 Press RECORD and the PLAY key is automatically engaged 5 Press the PLAY PAUSE button on the CD player the Play Pause indicator will illuminate 6 Press the STOP button to manually end recording or it will stop automatically at the end of recording SPECIFICATIONS Power Sourc AC 110 220V 60 50Hz 10W DC 12V 8x D size batteries not included Speakers 3 Wide range 8 ohm Output Power 2x2W Dimensions 5 3 4 x16 1 4 x8 1 4 WHD Weight 8 lbs without batteries Tape Player Recorder Tape Standard normal bias Frequency Response 125 10 000Hz Radio Frequency Response FM 88 108MHz AM 530 1600KHz CD Player Laser Wavelength 760 800NM Tracking Method 3 spot error detection 3 86mm lens P
Download Pdf Manuals
Related Search