Peerless MIS488 mounting kit
Contents
1. INCH BUCKLE PC CLEARSTRIPS BELT WITH CINCH BUCKLE BELT WITHOUT CINCH BUCKLE BELT GUIDE TRI BAR BELT CLIP 4of4 ISSUED 11 19 07 SHEET 124 9135 2 01 06 11 2011 Peerless Industries Inc All rights reserved All other brand and product names are trademarks or registered trademarks of their respective owners2. peerless Installation and Assembly Pole PC Mount Model MIS488 ALL Max Load Capacity 25 Ib 11 3 kg Note Read entire instruction sheet before you start installation and assembly A WARNING Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet If you have any questions regarding any of the instructions or warnings please call Peerless customer care at 1 800 729 0307 This product should only be installed by a qualified professional Make sure that the wall will safely support the combined load of the equipment and all attached hardware and compo nents Never exceed the Maximum Load Capacity of 25 Ib 11 3 kg Always use an assistant or mechanical lifting equipment to safely lift and position equipment Tighten screws firmly but do not overtighten Overtightening can damage the items greatly reducing their holding power 2300 White Oak Circle Aurora IL 60502 800 729 0307 or 708 865 8870 Fax 708 865 2941 www peerlessmounts com ISSUED 11 19 07 SHEET 124 9135 2 01 06 11 Note Read instruction sheet before you start installation and assembly Parts List Description Qty Part 3 8 16 hex nut 530 9310 washer 540 9407 PC bracket 124 T1133 3 8 16 x 3 25 u bolt 560 1060 1 4 20 nylock nut 530 9413 PC mounting bracket 124 T1134 bumper 590 1159 1 4 20 x 5 8 carraige bolt 520 1175 safet
3. y belt 170 8039 1 N a AO A a N l N Q S T U Ww Y Z Qi CM UCT BELT WITH BELT WITHOUT TRI BAR BELTCLIP CLEARSTRIPS BELT GUIDE CINCH BUCKLE CINCH BUCKLE Note Some parts may appear slightly different than illustrated 2 of 4 ISSUED 11 19 07 SHEET 124 9135 2 01 06 11 A WARNING e Installer must verify that the supporting surface will safely support the combined weight of all attached equipment and hardware Attach PC mounting bracket U to existing pole Attach six bumper strips W to PC bracket Q using four washers N and four hex nuts I EXISTING POLE e Attach PC bracket Q to PC mounting bracket U using four 1 4 20 nylock nuts T and four 1 4 20 x 5 8 carraige bolts Y 3 of 4 ISSUED 11 19 07 SHEET 124 9135 2 01 06 11 NOTE Use safety belt Z instruction in conjuction with this step Fasten clear strips to the two slots in PC bracket Q Set HD box into computer plate B Fasten belt with cinch buckle to belt without cinch buckle Place tri bar belt clips and belt guide onto belt as shown in the safety belt instructions Feed the ends of the belt through the PC bracket Q slots and through tri bar belt clip Cinch the end of the belt so that the PC is securely held NOTE Trim off the end of the belt if necessary then lightly burn the end of the belt to prevent fraying BELT WITH CINCH BUCKLE BELT WITHOUT C
Download Pdf Manuals
Related Search