Coby MPCD451 CD radio
Contents
1. DIGITAL AUDIO Use a soft and clean cloth damped with plain lukewarm water to clean the exterior of the unit Never use solvents such as benzene or other strong chemical cleaners since these could damage your unit It is important that no liquid reaches the inside of the unit Do not touch the CD laser part or look directly at it 2 INTRODUCTION Please read and follow the instruction manual carefully be fore operating in order to avoid any damage to the unit POWER SUPPLY 1 By using AC power Insert one end of the AC power cord into the AC socket on the rear of the unit and the other end into a standard wall socket 2 By using batteries Insert 6x D size batteries not included in the battery compartment in the back of the unit by matching the polarities The unit will not operate on battery power when the AC power cord is plugged into the AC socket Replace batteries when the power indicator dims the volume decrease or the sound distorts Use batteries of high quality and check them regularly Alkaline batteries are recommended Do not mix new batteries with old or used batteries Use only batteries of the same brand and type Batteries should not be left in the unit if they are exhausted or if the unit is not to be used for a long period of time as they may leak and damage the unit Battery leakage is not covered under the warranty HEADPHONES Not included You can use headphones with 3 5mm diam2. COBY Portable Mp3 CD AM FM Stereo Tuner MODEL NO MP CD 451 Please read instruction manual before use LOCATION OF CONTROLS Handle resssssereeeeeey CD Door eewseereeed Frequency Dial Phone Jack K 3 EECTECETEECETECETETLEI A ntenna Function Selector AAAA Sara esseeeeeeeeseeseey Band Switch DIGIT a auimnsimtooeeCieiis MODE ss PROGRAM se LCD Display Tuning Control IMPORTANT SAFEGUARDS Always operate the product from a power supply of the same voltage frequency and rating as indicated on the product identification plate Do not operate product with a damaged cord or plug Never install the unit where there are heat sources such as radiators heat registers stoves direct sunlight excessive dust or where there is mechanical vibration or shock Switch off and unplug from AC outlet when not in use IMPORTANT The CD mechanism and the sensitive circuitry may cause interference to a radio tuner nearby Do not operate this unit while operating other radio devices Danger This product utilizes invisible laser radiation Avoid direct exposure to the beam Caution Use of controls adjustments or procedures not listed in this manual may result in hazardous radiation exposure CONCERNING COMPACT DISC Only compact discs identified with this COMPACT mark can be used with this player a CARE and MAINTENANCE Handle your unit with care to extend the life of the unit
3. eter stereo plug and have impedance of 320hms When the headphones are con nected the speakers are disconnected automatically Set the VOLUME to a low level before using headphones and gradually adjust the Volume Control to the comfortable level Do not play the VOLUME too loud for extended periods of time to avoid any damage your hearing RADIO OPERATION 1 Slide the Function Selector switch to radio 2 Select the desired AM or FM with the band switch 3 Tune the desired station by turning the Tuning Control 4 Adjust the volume with Volume Control as desired 5 Extend Telescopic Antenna and adjust the direction and angle to obtain the optimum reception 6 Set the Function Switch to OFF position to stop radio CD MP3 OPERATION Set the FUNCTION Selector to the CD position and insert a CD or a MP3 disc Play Stop Pause Mode 1 Press PLAY PAUSE button to play LCD screen will display LCD screen will display NO dISC if CD is not in the unit When CD track data has been read LCD SCREEN will display the last track number with the total play time and then the unit will play from the first track gt 1000 2 Press PLAY PAUSE button to pause while in play mode 4 3 Press PLAY PAUSE button once more to resume play 4 Press STOP to stop play LCD will display the last track TRACKING mode 1 Press the 4 button once to get the beginning of current track 2 Repeatedly press the I lt button
4. isappears and the memory will be erased TROUBLE SHOOTING Should your player develop a problem please check below before requesting service Symptom Check and Action System does not function at all Check if the power cord has been properly connected to the power outlet Be sure to select a sound source Unplug the main unit and then reconnect it This allows the unit to reset itself after a power surge or power interruption Increase the volume No sound Disconnect any headphones No disc Load a disc Disc has been loaded upside down Place the disc withthe label side up CD does Disc is damaged or dirty Clean the disc or try not play another one Moisture may be condensed inside the player Remove the disc and leave the unit power on for one or two hours Disc is incorrect type for the player Radio dogs You may be in an area of weak signal coverage SPECIFICATION Power Supply 110V 60Hz 220V 50Hz dual voltage Applicable disc CD CD R MP3 Power Consumption 4 2W Output Power Speaker Dimensions Weight RADIO Frequency Range CD Player Laser Wavelength Tracking Method 1W x2 8 OHM 210 L x143 5 H x220 W mm main unit 1650g main unit AM 530KHz 1700KHz FM 88MHz 108MHz 760 800 nm 3 spot error detection 3 86 mm lens Design and specifications are subject to change without notice 7
5. to go to the previous tracks 3 Press the button to go to the next track 4 To fast backward fast forward through the disc press and hold the l 4 gt gt I button LISTEN TO DESIRED TRACK 1 Under the stop mode or the playback mode repeatedly press the DIGIT button the digit starts flashing for each time DIGIT button is pressed For MP3 there are three digits and CD two digits XZ 2 Press SEARH button to enter the desired track and press PLAY PAUSE button to start playback wes gt O JA 0208 REPEAT PLAY Press MODE button once to repeat one track 080208 Press MODE button twice to repeat all tracks L 380309 INTRO PLAY Press MODE button three times during play and INTRO will flash Ds Nino gt 590738 Press PLAY PAUSE I button to start INTRO Play RANDOM PLAY Press MODE button four times during play and RANDOM is displayed and flash wea MAON Press PLAY PAUSE _ MI button to play tracks in random order PROGRAM PLAY 1 Press the PROGRAM button at stop mode Program indicator a m gt OOP 0 2 Press the I or gt i button to select the desired track and appears on the screen then press PROGRAM to confirm Repeat step 2 to set up to 20 tracks Press the PLAY PAUSE button to start playing To stop the program play press the STOP button once O a A O To exit program mode press the STOP button twice program indicator d
Download Pdf Manuals
Related Search