SCOTT i-CSX 15 Nyte
Contents
1. 3 18 20 21 914 23 3 PA 22 24 2 gt a gg J JU IL JU 4 4 4 l q UI Docking station for iPod iPhone Y N button ALARM SET 1 2 button Speakers 2 x AUX IN jack FM antenna wire DC IN jack O VOLUME A Y buttons SNOOZE DISPLAY button 10 LED display 11 gt II PLAY PAUSE MONO STEREO button 12 TUNE SKIP buttons 13 FUNCTION button OONDAARWHNDY GB 3 26 5 6 MEM SET Memory Clock set button DIMMER button Headphones jack Q Clock back up battery compartment SLEEP button ALARM 1 2 LED indicators PRESET Shuffle button PRESET Repeat button FM STEREO LED indicator NAP button DST Daylight Saving Time ON OFF switch RESET button AM antenna socket e POWER SUPPLY Power supply for the unit Insert the AC DC adapter power cord into the AC mains outlet with a 100 240V AC 50 60Hz power source and the other end into the DC IN 10V e jack at the back of the unit Installing the clock back up battery The clock time can be maintained during a power failure by using 2 x2. button and the clock digits will flash 2 Press the TUNE SKIP buttons to set the time 3 Press the MEM SET button to confirm Alarm operation The unit allows you to wake up to the sound of the buzzer or to music Radio iPod iPhone Set the alarm time 1 Press and hold down the AL1 or AL2 button and the alarm time digits will flash 2 Press the TUNE SKIP buttons to set the alarm time 3 Press the AL1 or AL2 button to confirm GB 4 oe e Enable Disable the alarm function 1 Press the AL1 or AL2 button repeatedly to enable or disable the alarm function and select the following alarm modes buzzer b u radio Ad iPod or iPhone IP gd The corresponding indicator AL1 or AL2 will light up on the LED display 2 When the alarm function is on and the preset alarm time is reached the alarm will sound in the selected alarm mode for one hour 3 To stop the alarm press the b Em button The alarm will sound again at the same time the next day Note lf iPod iPhone mode is selected make sure the iPod or iPhone is inserted in the docking station and the volume is set to a suitable level Otherwise the unit will automatically switch to buzzer mode Snooze function When the alarm sounds press the SNOOZE DISPLAY button to stop the alarm temporarily and it will sound again after 9 minutes To cancel the SNOOZE function and repeat the alarm the next day press the corresponding AL1 or AL2 button Note The sn
3. A Y buttons to adjust the volume level Connecting headphones Plug the headphones not supplied into the headphones jack at the back of the unit for private listening The speaker output will be shut off automatically DIMMER control Press the DIMMER button to select the brightness of the display high or low DISPLAY function In radio mode the clock is always displayed You can press the SNOOZE DISPLAY button to display the frequency for 5 seconds RESET function Press the RESET button with a sharp object to reset the unit RADIO OPERATION Listening to the radio 1 When the unit is switched on press the FUNCTION button to select FM or AM radio mode 2 Press and hold down the TUNE SKIP button for more than 1 second and the unit will automatically search up down for a radio station For manual fine tuning you can press these buttons repeatedly to adjust the frequency step by step FM Stereo In FM mode press the MO ST button to select mono or stereo sound The FM STEREO indicator will light up when the unit receives a station with a strong signal and stereo sound Achieve optimum reception In FM mode extend and position the FM antenna to achieve optimum reception In AM mode connect the loop antenna and orientate the unit to achieve optimum reception Preset radio stations You can store up to 10 stations for FM and 10 stations for AM 1 Use the TUNE SKIP buttons to search for a desired station Press the MEM
4. AA LRO6 batteries supplied Battery insertion 1 Open the battery compartment on the back of the unit by pressing on the battery compartment catch whilst removing it 2 Remove the old batteries and insert 2 x AA LRO6 batteries alkaline batteries are recommended into the battery compartment following the correct polarities marked inside 3 Replace the battery cover Note For optimum performance the batteries should be replaced every year Precautions when using batteries 1 Replace only with the same or equivalent type 2 Do not mix different types of batteries together e g alkaline rechargeable and standard carbon zinc or old batteries with fresh ones 3 Exhausted batteries must be removed to prevent any battery leakage 4 Dispose of batteries properly according to environmental regulations BASIC OPERATION ON Standby mode After connecting the power supply refer to POWER SUPPLY the unit is in standby mode and the clock time will automatically be set correctly All you need to do is slide the DST switch to the ON or OFF position for daylight saving time in winter and summer Press the GIN button to turn on the unit and press it again to go to standby mode Setting the clock manually If a power failure occurs and the clock back up batteries are flat or have not been inserted into the unit you can set the time manually after inserting fresh batteries 1 In standby mode press and hold down the MEM SET
5. SET button and the station frequency will flash 2 Press the PRESET button to select a desired station number 3 Press the MEM SET button again to confirm the setting 4 Repeat steps 1 to 3 to store any other desired stations Listening to a preset station When listening to the radio press the PRESET buttons to select a preset radio station GB 6 e if Installing an adapter on the iPod iPhone docking station 1 Remove the cover of the docking station at the top of the unit and insert the adapter supplied with your iPod iPhone into the docking station with the two tabs facing forwards 2 To remove the adapter press the back of the adapter and pull it up Listening to your iPod iPhone 1 With the correct iPod iPhone adapter installed gently dock the iPod iPhone without the protective cover into the unit s docking station When the unit is switched on press the FUNCTION button to select iPod mode Press the BIT button to start playback Press it again to pause playback Press it again to resume normal playback Press the TUNE SKIP buttons repeatedly to skip to the previous or next track Alternatively you can use the controls on your iPod iPhone directly OA w N Note e The internal iPod iPhone battery will charge until it is fully charged e Adjust the volume control on the unit to the desired volume level using the VOL A Y buttons on the unit e To prevent sound distortion d
6. Ti LL HSCOTT i CSX 15 DUAL ALARM CLOCK FM AM PLL RADIO WITH iPod iPhone DOCKING STATION AND AUTOMATIC TIME SETTING SYSTEM t 4 Instruction Manual CE e mi e PRECAUTIONS Follow the advice below for safe and appropriate operations PLACEMENT Do not use the unit in places which are extremely hot cold dusty or humid Place the unit on a flat and even surface Do not restrict the air flow of the unit by placing it in a place with poor air flow by covering it with a cloth or by placing it on a carpet Do not place naked flame sources such as lighted candles on the apparatus Use the apparatus only in moderate climates not in tropical climates Do not expose the apparatus to dripping or splashing Do not place objects filled with liquids such as vases on the apparatus SAFETY When connecting and disconnecting the AC power cord from the AC mains outlet pull the plug and not the cord itself Pulling the cord may damage it and may be dangerous The mains plug must remain readily operable When you are not going to use the unit for a long period of time disconnect the AC power cord from the AC mains outlet AC VOLTAGE Before use check that the rated voltage of your unit matches your local vol
7. e the AM loop antenna to achieve optimum reception 4 1 Check that you have used the correct adapter 4 2 The EQ function in your iPod iPhone must be set to Off 4 3 Your iPod is not supported by the unit Connect your iPod to the unit via the AUX IN jack TECHNICAL SPECIFICATIONS FM 87 5 108 MHz AM 522 1620 kHz FM wire antenna AM loop antenna 4W 2x2 W 11W 2 x 2 8 Ohm AC 100 240V 50 60 Hz DC IN 10V 1 4A Oet DC 3V 2 x 1 5V AA LRO6G size batteries 118 H x 180 W x 96 D mm 0 9 kg GB 9 oe e
8. n the casing unplug the unit and wipe off dust and stains with a soft cloth moistened with a mild soap and water solution only Do not use benzene thinner or similar chemicals to clean the casing If at any time in the future you should need to dispose of this product please note that waste electrical products should not be disposed of with household waste Please recycle where facilities exist Check with your local authority or retailer for recycling advice Waste Electrical and Electronic Equipment Directive L e Problems 1 The player or display does not work properly No sound poor sound Recommendations 1 1 Press the em button to go to standby mode and press it again to turn on the unit 1 2 Press the RESET button with a sharp object to reset the unit 1 3 Reset the unit by unplugging the AC power cord for a few seconds then plug it back in 2 1 Check the cable connections 2 2 Use the FUNCTION button to select the correct mode Noise or distorted sound in radio mode No sound poor sound in iPod mode Radio Tuning range Antennas General Output power RMS Power consumption Speaker Power source AC DC Adapter Clock back up Dimensions Weight Note Due to continuing improvements the technical specifications are subject to change without notice 3 1 FM mode Extend and position the FM antenna to achieve the best reception 3 2 AM mode Orientat
9. ooze duration can be adjusted from 30 minutes to 1 minute by pressing and holding down the SNOOZE DISPLAY button and then using the TUNE SKIP buttons Sleep function You can program the unit so that the music you are listening to stops automatically after a certain amount of time up to 120 minutes 1 Press the SLEEP button repeatedly to select the duration from 90 60 30 15 10 minutes to off You can also use the TUNE SKIP buttons to set this duration minute by minute 2 When the preset sleep duration elapses the unit turns off automatically 3 To cancel the sleep function before the preset sleep duration elapses press the GIN button to turn off the unit immediately Nap function The unit allows you to wake up after a certain amount of time up to 120 minutes 1 Press the NAP button repeatedly to select the duration from 20 30 60 120 minutes to off You can also use the TUNE SKIP buttons to set this duration minute by minute from 10 to 120 minutes 2 When the preset nap duration elapses the buzzer will sound for one hour 3 To pause the alarm press the SNOOZE DISPLAY button and the alarm will sound again after the snooze duration has elapsed To stop the alarm press the em button FUNCTION select When the unit is switched on press the FUNCTION button repeatedly to select one of the following sources radio FM AM iPod iPhone P gd or AUX IN A uH GB 5 e Ti LL VOLUME control Press the VOLUME
10. tage CONDENSATION When there is condensation inside the unit it may not function normally Unplug the unit for 1 to 2 hours before turning the power back on or gradually heat the room up and dry the unit before use Ensure a minimum distance of 5 cm around the apparatus for sufficient ventilation Ensure that the ventilation is not impeded by covering the ventilation openings with items such as newspapers tablecloths curtains etc BATTERIES Pay attention to the environmental aspects of battery disposal CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightening flash ATTENTION To reduce the risk of The exclamation point with arrowhead symbol electric shock do not remove the cover within the triangle isa within the triangle isa There are no user serviceable parts warning sign alerting warning sign alerting inside the unit Refer all servicing to the user of important _ the user to the qualified persounnel instructions accompanying the presence of dangerous product voltage inside the unit GB 1 L e VAI EN ASIE at aaa e nia apara a a a ata San aa eer ORR a a sa a a E a a aga ak TROUBLESHOOTING GUIDE TEGHNIGAL SPEGIFICATIONS Se aca esse dena a aaa a ang a aa aa da ea aaa nan ude ete angka aad BOK CONTENTS 1 Unit and clock back up batteries 2 AC DC adapter 3 Instruction manual LOCATION OF CONTROLS Unit 4 AM loop antenna
11. uring iPod iPhone playback on this unit the EQ function in your iPod iPhone must be set to Off e The docking station is not designed for playing or charging an iPod Shuffle but it is possible to connect the iPod s headphones jack to the AUX IN jack on the unit In this case please select the desired tracks directly on your iPod Shuffle e Playback of the iPhone will be suspended when there is an incoming call You can pick up the call using your iPhone speaker phone function After you have finished the call playback will resume REPEAT playback Press the gt button once to repeat the current track Press it twice to repeat all the tracks Press it a third time to cancel the repeat function RANDOM playback Press the button to play the tracks in random order Press it again to cancel the function GB 7 e e AUX IN FUNCTION This unit has an AUX IN jack which allows you to connect your external audio devices such as MP3 players or an earlier iPod model 1 Connect a 3 5 mm stereo connection cable not supplied to the AUX IN jack on the back of the unit and the phones line out jack on your external audio device 2 When the unit is switched on press the FUNCTION button to select AUX mode 3 Operate your external audio device as usual to select and play the music 4 Adjust the volume controls on both your external audio device and this unit to the desired volume level MAINTENANCE Care and maintenance To clea
Download Pdf Manuals
Related Search