Pyle PylePro PDWM2450
Contents
1. SPECIFICATION Audio Frequency Response Dynamic Range System Distortion Signal to Noise Ratio Operating Range Operating Temperature Range Carrier Frequency Range Receiver Sensitivity S N 30dB Image Rejection De Emphasis Audio Output Impedance Audio Out put Level Power Supply Transmitter hand held Frequency Stability RF Output power Spurious Rejection Modulation Mode Maximum Deviation Range Microphone Mode Pre Emphasis Power Supply Transmitter Lapel Microphone Frequency Stability RF Output power Spurious Rejection Modulation Mode Maximum Deviation Range Microphone Mode Pre Emphasis Power Supply X Design and specification are subject to change without notice 50 15000Hz 280dB lt 1 280dB 50m 80m 5 C 45 C 180 280MHz gt 2mV gt 40dB 50vS 6002 10 0 0 5V AC 110V 60Hz 0 005 lt 30mW gt 40dB FM 75KHz Dynamic 509S 2X1 5V 9V Battery 0 005 10mW gt 40dB FM 75KHz Dynamic 501S 9V Battery PYLE SPRO www pyleaudio com PDWM2450 Wireless 2 Channel VHF Microphone System With 2 Microphones User Manual 1 Operating on VHF high band frequency within 180 to 280MHz The other frequency is not easy to bother 2 Crystal controlled circuit And the antenna inside the unite 3 Dual channel receiver one receiver can receiver two transmitter at the same time 4 There is a companding function 5 Audio ou2. unit the place where cool and dry do not install beside the window and near the place where is too hot or too wet or too much vibration or dust est 2 Do not use force on switches knobs or cords When moving the set first turn the unit off 3 Do not attempt to clean the unit with chemical solvents this might damage the finish Use a clean dry cloth 4 If you use several unit at the same time you must use these unit in different frequency 5 Do not break the receiver and transmitter of microphone
3. tput is adjustable with volume control 6 Audio Display RECEIVER REMARK Ge ile nie 1 Power Switch 5 Audio Output Jack of A amp B CH 2 Audio Display 6 Audio Output Jack of ACH 3 Audio Volume 7 Audio Output Jack of BCH 4 Antenna 8 AC Power Jack TRANSMITTER REMARK 1 Microphone Head 7 Microphone Jack 2 Grip 8 Microphone Input Jack 3 Power Switch 9 Power Sensitivity Switch 4 Power Indicator Low Voltage Indicator 10 Belt Clip 5 Battery Canister 11 Battery Compartment Cover 6 Microphone Wire 12 Microphone Clip OPERATION 1 First of all hook up power to the receiver of this system Turn switch ON and Power Indicating light will come on indicating that power is on then hook up the connecting wires attached as shown in the drawing and draw antenna fully 2 Open the battery compartment cover of transmitter load in battery 3 Tum on the power switch of microphone and the power indicator will be light that the transmitter send the signal to the receiver 4 You can adjust the volume to the middle or more through the volume knob then adjust the audio amplifier to the right position 5 When the transmitter is not used turn the powfer off 6 When the receiver is not used turn the power off 7 If the unit does not use for a long time you must take out the battery 1 You had better install your
Download Pdf Manuals
Related Search