Chief FPM4101 flat panel wall mount
Contents
1. INSTALLATION INSTRUCTIONS FPM SERIES SMALL FLAT PANEL DISPLAY PITCH ADJUSTABLE WALL MOUNT Exclusive Q2 Mounting System Prior to assembly unpack carton completely and verify contents If you are missing any of the following components please contact Customer Service at 1 800 582 6480 oo T junii e Figure 1 1 FPM Wall Bracket 4 Drywall Anchor 2 Wood Screw 2 Washer Flat 25 ID X 56 OD BEFORE PROCEEDING READ INSTALLATION INSTRUCTIONS COMPLETELY Flat Panel Displays are Extremely Fragile CAUTION IfMonitor Uses a Screw Size Other Than M4 X 10mm M4 X 20mm DO NOT USE M4 Screws Provided Monitor Damage Could Occur Interface Bracket Installation 1 See installation procedures accompanying your mounting bracket Optional Latching Flag Placement 1 Remove Phillips head screw Nylock nut and latching flag see Figure 2 2 Reposition latching flag and secure using Phillips head screw Nylock nut Remove screw and nut Move latch 3803 000034 Rev B Figure 2 05 05 CHIEF MANUFACTURING INC 1 800 582 6480 Fax 1 877 894 6918 Email chief chiefmfg com Drywall Installation Procedures C AUTION Minimum Sheetrock Thickness 12 Inch Using the wall bracket as a template at the desired mounting location mark the location of the four outer mounting holes 3 Using a 3 8 inch drill drill four pilot holes to a minimum depth of 1 1 2 at the locations marked in Step 2 4 Install an2. a WN
3. anchor bolt in one of the pilot holes and tighten anchor bolt until it is fully seated see Figure 3 5 Remove and retain bolt and washer from anchor and repeat Step 4 and 5 for three remaining anchor bolts 6 Using four bolts with washers installed secure wall bracket to wall Wood Stud Installation Procedures 1 Locate stud and using wall bracket as a template at the desired height mark the location of the two center mounting holes 2 Install a 25 ID x 06 OD flat washer on each of the two wood screws 3 Using the two wood screws with flat washers installed secure wall bracket to wall Mounting Display with Interface Bracket to Wall Bracket 1 Make sure the latching flag on the mounting bracket is in the unlocked position see Figure 4 2 Place your small flat panel display with interface bracket attached onto the wall bracket making sure it is securely seated 3 Lower the latching flag on the wall bracket locking small flat panel display in place see Figure 5 Locked Unlocked 10 24 Scre Anchor 0 375 Predrill Hole 9490375 Sic by Outer Mounting Holes INSERT ANCHOR INTOPPREDRILLED HOLE Insert anchor into predrilled hole Anchor Barb Stops anchor rotation Turn 10 24 screw clockwise until anchor fully seats against back side of wall CW Inner Mounting Holes Figure 3 Figure 4 Figure 5 v
Download Pdf Manuals
Related Search