Chief SLB196 mounting kit
Contents
1. INSTALLATION INSTRUCTIONS SSB 196 SSM 196 SLB 196 and SLM 196 Interface Brackets SSB 196 SSM 196 SLB 196 and SLM 196 Interface Brackets are designed for use with Chief Series Projector Mounts See the specific installation instructions provided with the mount for additional installation information Unpack carton and verify kit contents If any listed parts are missing immediately contact a Chief Customer Service representative WARNING IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT substitute hardware Use only hardware supplied by manufacturer 1 Interface Bracket 2 Screw Phillips Pan Head M4 x 20mm 4 10 24 Thumb Nuts 1 Screw Phillips Flat Head M4 x 20mm 1 All Points Security Kit 2 Washer Flat M4 3 Spacer Nylon 1 2 x 194 x 1 2 a S Towards front of Towards front of projector projector SLB 196 SLM 196 Note SSB style interface bracket connections Note SSM style interface bracket connections are encircled are encircled Only used when installing SLB SSB interface brackets NOTE Specific to SSB style and SSM style interface bracket installation all appropriate screws come pre installed as reflected in the encircled locations above DO NOT attempt to substitute and USE ONLY this pre installed hardware for SSB style and SSM style interface bracket installation Installation Instructions WARNI2. NG OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE TO EQUPIMENT DO NOT over tighten screws when installing interface brackets NOTE Step 1 is only required when installing an SLB SSB interface bracket If an SLM SSM bracket is being installed proceed to step 2 Screw thumb screws onto 10 24 x 5 8 Phillips pan head screws DO NOT fully tighten thumb screws at this time Turn projector upside down on a flat surface Place 1 2 nylon spacers over the threaded inserts in the bottom of the projector Place the interface bracket onto the 1 2 nylon spacers on the bottom of the projector and align the mounting holes in the bracket with the nylon spacers FON a 5 Place and screw M4 x 20mm pan head screws with M4 washers into the side holes and the M4 x 20mm flat head screw into the counter sink hole Tighten all fasteners at this time securing the bracket to the projector NOTE Security screws can be substituted when mounting interface bracket to projector by using the parts and installation instructions in the All Points Security Kit Pr Chief is a registered trademark of Milestone AV Technologies All rights reserved Ko consuman S Milestone AV Technologies and its affiliated corporations and subsidiaries collectively Milestone intend to make this manual accurate and complete However Milestone makes no claim that the information contained herein covers all details conditions
3. or variations nor does it provide for every possible contingency in connection with the installation or use of this product The information contained in this document is subject to change without notice or obligation of any kind Milestone makes no representation of warranty expressed or implied regarding the information contained herein Milestone assumes no responsibility for accuracy completeness or sufficiency of the information contained in this document PJ o Chief Manufacturing a products division of Milestone AV Technologies 8802 000265 RevB ICJ ll E 8401 Eagle Creek Parkway Savage MN 55378 2009 Milestone AV Technologies e P 800 582 6480 952 894 6280 F 877 894 6918 952 894 6918 a Duchossois Group ara Our Mounts Your Vision
Download Pdf Manuals
Related Search