Home

Sony LMP-H700

1. T AEE Oe eet 1 2 ee T A NE z ao zei IN A S
2. t S 6 3 3 7 2 Z 8 2
3. ra ee pe an ae 5 E lis THERLTSRS Q e S i i gt re BE Operating Instructions 5 7E PRAL AzA AA o LMP H700 A o WMM O rg 1 Sony Corporation 2003 Printed in Japan 4101187050 eee 2 2
4. rae ee FAX 0120 333 389 8 108 0075 1 7 1 http www sony net Printed on recycled paper e This lamp is designed for use with the Sony projector e Be sure to confirm that this lamp is usable with your projector before using it by reading the Operating Instruction or Installations Manual for Dealers supplied with your projector About lamp replacement Attaching the lamp may cause fire or injury to persons Users should ask a qualified Sony representative to attach the lamp Replacing the lamp unit e Before replacing the lamp unit be sure to turn off the projector and disconnect the power cord of the projector When replacing the lamp unit after using the projector wait at least one hour to allow the lamp unit to cool e Whenever you replace the lamp unit be sure to replace the air filter with a new one The illustrations below show the case of replacing the lamp unit with the projector installed on the ceiling 1 Loosen the two screws fixing the top panel at the rear
5. 4 S ONY 4 101 187 05 1 a Pr ojector Lamp Anh 1 lt lt
6. 9 10 RESET ENTER 5 Ait A pO OE A ECS ttp Awww sony co jp support kk Swe OOS BY eae AN BAHNA FEO TEE KACANE E E di20333020 1 8 kg PHS IP 0466 31 2511 OAT ai 1 1 Bae 99g9gj f 0120 222 330 ene gt PHS IP 0466 31 2531 oN KER eo T is
7. ents
8. of the projector using the supplied screwdriver then slide the top cover backward and lift it to remove 2 Loosen the two screws fixing the lamp cover using the supplied screwdriver to remove the lamp cover 3 Loosen the three screws with a Phillips screwdriver 4 Holding the lamp unit with your hand push back the stoppers on the left and right sides then pull out the lamp unit 5 Insert the new lamp unit straight all the way in until it is securely in place and pull out both the stoppers until you hear a click 6 Tighten the three screws loosen in step 3 to secure the lamp unit to the projector 7 Replace the lamp cover and tighten the two screws 8 Replace the top panel and tighten the two screws 9 Connect the power cord and set the projector to standby mode 10 Press the RESET gt and ENTER buttons on the remote control in this order for less than five seconds each Specifications 180 x 157 x 163 mm 7 Vsx6 1 4 x 6 1 2 inches w h d Mass 1 8 kg 3 Ib 15 oz Supplied accessories Screwdriver 1 Operating Instructions 1 Dimensions The manufacturer of this product is Sony Corporation 1 7 1 Konan Minato ku Tokyo 108 0075 Japan The Authorized Representative for EMC and product safety is Sony Deutschland GmbH Hedelfinger Strasse 61 70327 Stuttgart Germany For any service or guarantee matters please refer to the addresses given in separate service or guarantee docum

Sony LMP-H700

Contents

Download Pdf Manuals

Related Search

Related Contents