Sun IB Switch 9P Hardware Installation Guide
Contents
1. Note Without the second power supply unit the switch has no failover function v To Replace the Power Supply 1 Holding the PSU by the front edge slide it into the slot 2 Gently but firmly push the power supply into the switch until you hear it click into place Installing the Hardware 11 3 Switch the power supply switch to on aa 4 Remount the front panel 12 Sun IB Switch 9P Hardware Installation Guide September 20062. M6 or 10 32 screws a Adjust the rear rail to the depth of the rack you re using and install it using the two M6 or 10 32 screws on each side The illustration shows the rails being installed in a rack that requires separating the rails For most racks the rails can be adjusted to the correct depth by loosening the screws and expanding the rails to fit the rack 4 Sun IB Switch 9P Hardware Installation Guide September 2006 b Attach the left pair of rails then the right pair leaving rear screws loose so you can adjust the depth of the rails after you slide the switch onto the rails The rear ends of the rails have flanges that must overlap the back corners of switch to secure the back end of switch to the rails 2 Slide the switch onto the rails Installing the Hardware 5 3 Mount the front to the rack using two 10 32 or M6 screws to secure the front of the switch to the front rack rails The system rear is constrained by rack rails Rack bracket tabs are printed black so they aren t so visible Chassis tabs are silver so that you can differentiate which screw to remove if you need to remove the switch from the rack Slide the back ends of rack rails toward switch so that rear rail flanges overlap switch rear corners Tighten the rear rail screws to the rear rack posts e PONT AN D A 5 Install the cable management bar to the rack rails using captive screws on each side of the cable management b
3. amp Sun microsystems Sun IB Switch 9P Hardware Installation Guide Sun Microsystems Inc www sun com Part No 819 7246 10 September 2006 Revision A Submit comments about this document at http www sun com hwdocs feedback Copyright 2006 Sun Microsystems Inc 4150 Network Circle Santa Clara California 95054 U S A All rights reserved Sun Microsystems Inc has intellectual property rights relating to technology that is described in this document In particular and without limitation these intellectual property rights may include one or more of the U S patents listed at http www sun com patents and one or more additional patents or pending patent applications in the U S and in other countries This document and the product to which it pertains are distributed under licenses restricting their use copying distribution and decompilation No part of the product or of this document may be reproduced in any form by any means without prior written authorization of Sun and its licensors if any Third party software including font technology is copyrighted and licensed from Sun suppliers Parts of the product may be derived from Berkeley BSD systems licensed from the University of California UNIX is a registered trademark in the U S and in other countries exclusively licensed through X Open Company Ltd Sun Sun Microsystems the Sun logo Java AnswerBook2 docs sun com and Solaris are trademarks or registered trade
4. de fabrique ou des marques d pos es de SPARC International Inc aux Etats Unis et dans d autres pays Les produits portant les marques SPARC sont bas s sur une architecture d velopp e par Sun Microsystems Inc L interface utilisateur graphique OPEN LOOK et Sun a t d velopp e par Sun Microsystems Inc pour ses utilisateurs et licenci s Sun reconnait les efforts de pionniers de Xerox dans la recherche et le d veloppement du concept des interfaces utilisateur visuelles ou graphiques pour l industrie informatique Sun d tient une license non exclusive de Xerox sur l interface utilisateur graphique Xerox cette licence couvrant galement les licenci s de Sun impl mentant les interfaces utilisateur graphiques OPEN LOOK et se conforment en outre aux licences crites de Sun LA DOCUMENTATION EST FOURNIE EN L TAT ET TOUTES AUTRES CONDITIONS DECLARATIONS ET GARANTIES EXPRESSES OU TACITES SONT FORMELLEMENT EXCLUES DANS LA LIMITE DE LA LOI APPLICABLE Y COMPRIS NOTAMMENT TOUTE GARANTIE IMPLICITE RELATIVE A LA QUALITE MARCHANDE A L APTITUDE A UNE UTILISATION PARTICULIERE OU A L ABSENCE DE CONTREFA ON Ob ass A Adobe PostScript Contents Installing the Hardware 1 Contents of Package 1 List of Contents 1 Contents Cable and Rackmount Kit 3 Preparing the Switch for Rack Mounting 3 Y To Prepare the Switch for Rack Mounting 4 Removing and Replacing the Power Supply 9 v To Remove the Power Supply 10 v To Replace the
5. Power Supply 11 iv Sun IB Switch 9P Hardware Installation Guide September 2006 Installing the Hardware This chapter describes how to mount the Sun IB switch into a rack and plug in the cables This chapter contains the following sections m Contents of Package on page 1 m Preparing the Switch for Rack Mounting on page 3 m Removing and Replacing the Power Supply on page 9 Contents of Package When you unpack your Sun IB switch the box should contain the following items List of Contents m The Sun IB switch m Cable Bracket and Rackmount kit Documentation this manual Sun IB Switch 9P Hardware Installation Guide FIGURE 1 Contents Included in the Box 2 Sun IB Switch 9P Hardware Installation Guide September 2006 FIGURE 2 Contents of Cable and Rackmount Kit Contents Cable and Rackmount Kit Cable management bracket Two pairs of rack rails Ten M6 screws to attach the rails to the rack if necessary m m m Ten 10 32 screws to attach the rails and switch to the rack if necessary Preparing the Switch for Rack Mounting The Sun IB switch fits into any 19 inch rack The rack rails can be adjusted to fit into a rack depth of 560mm 22 05 to 920mm 36 22 These dimensions are from outside the front post to outside the rear post Installing the Hardware 3 v To Prepare the Switch for Rack Mounting 1 Attach the two pairs of rails to the rack Use M6 or 10 32 screws se
6. allation is now complete Note Refer to the Sun InfiniBand Switch Nine Port Administration Guide for instructions on how to configure and manage the Sun IB switch You can download the administration guide from the following URL http www sun com products n solutions hardware docs Network_Connectivity Removing and Replacing the Power Supply The power supply units are the only customer replaceable units CRUs in the switch Installing the Hardware 9 Vv 1 5 6 To Remove the Power Supply Identify the power supply unit PSU you want to remove PSUs are identified as PSO or PS1 Access the ALOM command line interface CLI You can access the ALOM CLI either through the serial port console or by telnet Issue a removefru command from the ALOM CLI sc gt removefru ps0 Are you sure you want to remove PSO y n y The removefru command lights the blue Ready to Remove LED on the designated PSU preventing confusion about which PSU to remove Unscrew the screws in the front panel Remove the front panel of the switch The switch contains two removable PSUs If the blue Ready to Remove LED is lit pull out the PSU 10 Sun IB Switch 9P Hardware Installation Guide September 2006 Latches 7 Press the latches toward the center of power supply and pull forward to remove it One power supply can be missing from the switch indefinitely without damage to the switch or loss of use
7. ar 6 Sun IB Switch 9P Hardware Installation Guide September 2006 SS Oe ee EE ee ort LEDs Link LEDS 6 Identify the ports you want to connect to A single Sun InfiniBand switch can be connected to nine HCA ports with 12x to 4x cable to another switch with 12x to 12x cable or a combination thereof No pair of connected ports can belong to the same NodeGUID that is the same HCA instance Note To the right of each port are two LEDs one amber and one green The amber LED lights only when the port requires attention A steady light from the green LED shows that the link is up blinking indicates InfiniBand activity For more information about both port and link LEDs refer to the Sun IB Switch 9P Administration Guide available at the following URL http www sun com products n solutions hardware docs Network_Connectivity Cable clamp release screw 7 Loosen the cable clamp release screw and pivot the clamp outward so you can plug in the cables placing the cord into the slot in cable management bar Installing the Hardware 7 Cable clamp release screw 8 Pivot the cable clamp back over the slot and tighten the captive screw 8 Sun IB Switch 9P Hardware Installation Guide September 2006 RJ 45 serial port Ethernet port 9 Connect one end the RJ 45 serial cable to the serial port of the switch and the other end to the console you will use to manage the switch Your hardware inst
8. e propri t intellectuels relatifs la technologie d crite dans ce document En particulier et sans limitation ces droits de propri t intellectuels peuvent inclure un ou plusieurs des brevets am ricains list s sur le site http www sun com patents un ou les plusieurs brevets suppl mentaires ainsi que les demandes de brevet en attente aux les Etats Unis et dans d autres pays Ce document et le produit auquel il se rapporte sont prot g s par un copyright et distribu s sous licences celles ci en restreignent l utilisation la copie la distribution et la d compilation Aucune partie de ce produit ou document ne peut tre reproduite sous aucune forme par quelque moyen que ce soit sans l autorisation pr alable et crite de Sun et de ses bailleurs de licence s il y en a Tout logiciel tiers sa technologie relative aux polices de caract res comprise est prot g par un copyright et licenci par des fournisseurs de Sun Des parties de ce produit peuvent d river des syst mes Berkeley BSD licenci s par l Universit de Californie UNIX est une marque d pos e aux Etats Unis et dans d autres pays licenci e exclusivement par X Open Company Ltd Sun Sun Microsystems le logo Sun Java AnswerBook2 docs sun com et Solaris sont des marques de fabrique ou des marques d pos es de Sun Microsystems Inc aux Etats Unis et dans d autres pays Toutes les marques SPARC sont utilis es sous licence et sont des marques
9. marks of Sun Microsystems Inc in the U S and in other countries All SPARC trademarks are used under license and are trademarks or registered trademarks of SPARC International Inc in the U S and in other countries Products bearing SPARC trademarks are based upon an architecture developed by Sun Microsystems Inc The OPEN LOOK and Sun Graphical User Interface was developed by Sun Microsystems Inc for its users and licensees Sun acknowledges the pioneering efforts of Xerox in researching and developing the concept of visual or graphical user interfaces for the computer industry Sun holds a non exclusive license from Xerox to the Xerox Graphical User Interface which license also covers Sun s licensees who implement OPEN LOOK GUIs and otherwise comply with Sun s written license agreements U S Government Rights Commercial use Government users are subject to the Sun Microsystems Inc standard license agreement and applicable provisions of the FAR and its supplements DOCUMENTATION IS PROVIDED AS IS AND ALL EXPRESS OR IMPLIED CONDITIONS REPRESENTATIONS AND WARRANTIES INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY FITNESS FOR A PARTICULAR PURPOSE OR NON INFRINGEMENT ARE DISCLAIMED EXCEPT TO THE EXTENT THAT SUCH DISCLAIMERS ARE HELD TO BE LEGALLY INVALID Copyright 2006 Sun Microsystems Inc 4150 Network Circle Santa Clara Californie 95054 Etats Unis Tous droits r serv s Sun Microsystems Inc poss de les droits d
Download Pdf Manuals
Related Search