How to use up to three FIREPOD`s with Windows XP
Contents
1. name 10 Active Units Panel The Active Units Panel can be used to change the name of the units for easy recognition click on the unit you wish to rename and click on Edit name and to change the order in which the units will appear in your software For instance if you have one Firepod in a rack above another one and you would like it to appear first in the chain inputs outputs 1 10 in your DAW software you can move it to position 1 in the Active Units Panel if it is not already there To change the position of any Firepod click on it in the Active Units Panel and click on Up or Down guide you through a single install screen Once the new Firepod is installed disconnect all Firepods except for the Add a Third Firepod anytime If you already have two Firepods you can very easily add another to your system Just chain the new Firepod to the open Firewire port on your existing Firepod and turn it on The new driver will automatically install the new unit and will newest Firepod wait until you see a blue sync light and then run the Firmware updater from the Programs list PreSonus 1394 Audio Driver V 2 14 0 Firepod Firmware Updater When the firmware updater is finished reconnect all Firepods and turn them on Once all are in sync you should see them listed in the Active Units Panel in the Control Panel as well as in your DAW software PreSonus Audio T 225 216 7887 www presonus com2. PreSonus How to use up to three FIREPOD s with Windows XP You can use up to three Firepods on the same system over a single Firewire connection In order to use multiple Firepods together you must first download and install the latest driver and run the firmware updater included with that driver for each Firepod Once the drivers and firmware are up to date using multiple Firepod s is easy Note Multi FIrepod operation is limited to sample rates of 24 bit 44 1k or 24 bit 48k SPDIF is disabled in any multi FIREPOD system Control Panel PreSonus FIREPOD GO x The control panel includes drop down menus to select samplerate latency and clock source as well as an Active Hardware Settings Caute KANE Sample Rate Latency Which Unit is Which J44 1 kHz fioo ms To determine which position each Firepod is in you will Clock Source need to switch the clock source to SPDIF 1 SPDIF 2 or internal SPDIF 3 and look at the Firepods to see which one has a sync light that is flashing red blue indicating that it 1s Active Units searching for SPDIF sync make sure no SPDIF connections are made yet The number behind each Jon s Firenod 1 SPDIF selection refers to the position of the unit in the If son sFirepod2 oo0A9200co000000 Active Units Panel The position of each unit will Down determine which set of inputs outputs the unit provides in your DAW software ex position 1 inputs outputs 1 Edt
Download Pdf Manuals
Related Search