user guide
Contents
1. a flip up headset The NVG 7 is available with a wide range of image intensifier options to meet a wide array of specification requirements The NVG 7 night vision goggles is a complex opticoelectronic system for individual use The device consists of the objective lens assembly eyepiece and the body The body contains a image intensifier tube assembly with an integrated high voltage power source and the battery housing Objective lens protective cover is intended to protect the objective lens from dust and scratches It also will act as a daylight filter allowing you to test the scope in daylight or other bright light situations The pinhole in the center of the protective cover allows the user to check the operation ability of the device in daylight conditions NOTE Do not test the scope in daylight conditions even with the daylight filter lens cap on for more than ten 10 minutes BATTERY INSTALLATION Install standard CR123A batteries as follows 1 Unscrew the battery cap A 2 Insert CR123 battery B observing the polarity as indi cated 3 Replace the battery cap and screw cap hand tight OPERATION e Take the NVG7 out of the case e Install the battery into the housing with the polarity order as shown on the scope Bat tery Type 3 V Lithium CR123A e To turn on the device rotate switch clockwise in first position Turn the unit on by the protective lens cover still attached to the lens Do not turn the unit on in2. the daytime without the protective lens cap on You should see green glow in the eyepiece e Observe the scene and adjust the diopter for optimal image clarity e You may now enter a dark environment or simply shut the lights off in order to darken the room 2 e Next remove the lens cap daylight filter Adjust the front lens for the distance of the focus You should not have to readjust the diopter e To turn the unit off rotate switch counter clockwise to initial position INTERPUPILLARY DISTANCE Adjusts for distance between eyes by slid ing the eyepieces either together or apart so each eye can observe the entire field at the same time FOCUSING To focus the NVG 7 first you will need to adjust the diopter Simply turn the diopter clockwise until it stops Then while looking through the diopter at an object slowly turn the diopter back counter clockwise until the grain in the image is sharp NOTE We suggest that you focus the diopter during daylight with the filter on Next focus the front lens until the image and the grain are both sharp When you are in low light conditions and the daylight filter is off you may focus the front lens to receive sharp image the diopter should not be adjusted Lens focus adjusting NOTE The front lens should be readjusted as you view objects at different distances INFRA RED ILLUMINATOR Infra red illuminators or IR illuminators are common to night vision The IR light grea
3. ATN NVG 7 NIGHT VISION GOGGLES MANUAL NVG7 REV 1 MARCH 2013 user s guide Important Export Restrictions Commodities prod ucts technologies and services contained in this manual are subject to one or more of the export control laws and regulations of the U S Government and they fall under the control jurisdiction of either the US Department of State or the US BIS Department of Commerce It is unlawful and strictly prohibited to export or attempt to export or otherwise transfer or sell any hardware or technical data or furnish any service to any foreign person whether AMERICAN abroad or in the United States for which a license or writ ten approval of the U S Government is required without TECHNOLOGIES first obtaining the required license or written approval NETWORK from the Department of the U S Government having CORP jurisdiction Diversion contrary to U S law is prohibited 5 Diopter Adjustment Mounting bracket Built in infra red illuminator Power and IR ON OFF switch Battery cap Lens protective cover 26 mm F1 1 2 lens for maximum clarity SPECIFICATIONS Magnification ccccsceeseeeeeeeeeeeeeees 1X 3X 5X 8X optional Lens SYS EMM datiactccatsavecaicesstivonalatings 26 mm F1 1 2 Pield Of VIEW s cisatanciteeenr yeandetennusesoutesenavtcs 40 Range Of FOCUS cccceesseeeeeeneeeeeeees 0 25 m to infinity Pow r Supply ecserin 3 V Lithium CR123A B
4. UNDER ANY EXCESSIVE LIGHT CONDITIONS MAY PERMANENTLY DAMAGE THE INTERNAL COMPO NENTS OF THE UNIT AND SAID DAMAGE WILL NOT BE COVERED UNDER THIS WARRANTY This warranty is extended only to the original purchaser Any breach of this warranty shall be waived unless the customer notifies ATN at the address noted below within the applicable warranty period The customer understands and agrees that except for the foregoing warranty no other warranties written or oral statutory expressed or implied including any implied warranty of merchantability or fitness for a particular purpose shall apply to the product All such implied warranties are hereby and expressly disclaimed LIMITATION OF LIABILITY ATN will not be liable for any claims actions suits proceedings costs expenses damages or liabili ties arising out of the use of this product Operation and use of the product are the sole responsibility of the Customer ATN s sole undertaking is limited to providing the products and services outlined herein in accordance with the terms and conditions of this Agreement The provision of products sold and services performed by ATN to the Customer shall not be interpreted construed or regarded either expressly or implied as being for the benefit of or creating any obligation toward any third party of legal entity outside ATN and the Customer ATN s obligations under this Agreement extend solely to the Cus tomer ATN s liability hereunder for damag
5. attery Life ccccccccsscesseeeesseeeeeeeees 50 60 hours w o IR illuminator CR123A type Operating Temperature 0006 40 C to 50 C Storage Temperature cccceeeeees 50 C to 70 C DIMENSIONS ccccsccccseeeseececseeeeeaaees 160 x 150 x 75 mm 6 3 x 6 x 3 NOY SVC saesc scence cxcanesorsGesevseatntesnacceeeeer 0 5 kg 1 1 Ib ATN reserves the right to change the above specifications at any time without notice CAUTION THIS PRODUCT CONTAINS NATURAL RUBBER LATEX WHICH MAY CAUSE ALLERGIC REACTIONS The information in this manual furnished for information use only is subject to change without notice is not to be construed as acommitment by ATN Corp ATN Corp assumes no responsibility or liability for any errors or inaccuracies that may appear in this book 2013 ATN Corp All right reserved FEATURES e Lightweight compact rugged Goggle system e Multi purpose hand held head mounted or helmet mounted e Comfortable flip up headgear e Multi coated all glass optics e Wide angle infrared illuminator e Adjustable Interpupillary Distance e Optional 3x 5x and 8x lenses available e Water and fog resistant e Limited Two Year Warranty APPLICATION Compact and lightweight rugged and a top notch performer the NVG 7 is an exceptional choice for hands free usage The NVG 7 goggles have a built in IR for total darkness with indicator ON light within the FOV and
6. es regardless of the form or action shall not exceed the fees or other charges paid to ATN by the customer or customer s dealer ATN shall not in any event be liable for special indirect incidental or consequential damages including but not limited to lost income lost revenue or lost profit whether such damages were foreseeable or not at the time of purchase and whether or not such damages arise out of a breach of war ranty a breach of agreement negligence strict liability or any other theory of liability PRODUCT WARRANTY REGISTRATION In order to validate the warranty on your product ATN must receive a completed Product Warranty Registration Card for each unit or complete warranty registration on our website at www atncorp com Please complete the included form and immediately mail it to our Service Center ATN Corporation 1341 San Mateo Avenue South San Francisco CA 94080 OBTAINING WARRANTY SERVICE To obtain warranty service on your unit End user must notify ATN service department by calling 800 910 2862 or 650 989 5100 or via e mail service atncorp com to receive a Return Merchan dise Authorization number RMA When returning please take or send the product postage paid with a copy of your sales receipt to our service center ATN Corporation at the address noted above All merchandise must be fully insured with the correct postage ATN will not be responsible for improper postage or missing or damaged merchandise d
7. otographic lens cleaning tissue e Keep lens cap daylight filter on when not in use e The NVG 7 is not harmful to the user or the environment e Do not disassemble except to clean the front lens and eyepiece it will void your warranty e Evaluate the scope function by looking through it in a lit environment with the daylight filter lens cap on Never use in daylight without the daylight filter lens cap on e Never point the NVG 7 at a bright light source e Adverse atmospheric conditions such as fog smog or haze and a lack of ambient light moon or starlight may diminish the effective viewing distance e If you use the rubber eyecaps for a long period of time you may suffer skin inflammation If you develop any symptoms consult a doctor immediately TROUBLESHOOTING Q Flashes flickers or clicking occur while operating S If it occurs within the first five minutes of inserting new batteries it is normal and the device will resume normal operation soon thereafter If it occurs for more than 10 minutes contact for service instructions Q Dark spots on screen S These are either cosmetic blemishes in the intensifier tube or dust particles Q Screen becomes darker than at previous use S Replace batteries If problem persists contact your dealer or other authorized service repre sentative for service instructions Q Image not clear S Adjust objective lens and or the eyepiece 2 YEAR PRODUCT WARRANTY This produc
8. ount as shown on the figure Slide the goggles rearwards until the alignment boss aligns with the align ment groove on the head helmet mount Push until the goggles locks into the head helmet mount 5 Place the head helmet mount with pape Top edge NVG 7 onto your head of mount 6 Adjust the eye relief distance by press down on side lever and sliding Mount NVG7 fore or aft to obtain a full field of view of the image Reset the diop ter adjustment for best image The NVG 7 headset has a flip up mechanism Rotate the tilt adgustment lever and lift the unit up Release Tilt Adjustment Lever Side lever INTERCHANGEABLE LENS coptionat The NVG 7 with 3X 5X or 8X front lens can be used as a powerful night vision bi ocular To install 3X Afocal Lens screw it into the front lens of NVG 7 3X Lens 5X Lens 8X Lens To install 5X 8X lens unscrew the objective lens of NVG 7 from the body Please note to hold the ridged edge of the lens with one hand and then grasp the neck of the unit with the other and twist in opposite directions Itis very important not to grasp the eyepieces but grasp the neck of unit To install lenses screw 5X 8X lens to the free place make sure that the unit is turned off STORAGE AND CARE e f the device is not to be used for extended period of time more than 10 days remove the bat tery e Avoid touching lenses If fingerprints or traces of dirt or dust appear clean their surface with a Ph
9. t is guaranteed to be free from manufacturing defects in material and workmanship under normal use for a period of 2 two years from the date of purchase In the event a defect that is covered by the foregoing warranty occurs during the applicable period stated above ATN at its option will either repair or replace the product and such action on the part of ATN shall be the full extent of ATN s liability and the Customer s sole and exclusive remedy This warranty does not cover a product a used in other than its normal and customary manner b subjected to misuse c subjected to altera tions modifications or repairs by the Customer of by any party other than ATN without prior written consent of ATN d special order or close out merchandise or merchandise sold as is by either ATN or the ATN dealer or e merchandise that has been discontinued by the manufacturer and either parts or replacement units are not available due to reasons beyond the control of ATN ATN shall not be responsible for any defects or damage that in ATN s opinion is a result from the mishandling abuse misuse improper storage or improper operation including use in conjunction with equipment which is electrically or mechanically incompatible with or of inferior quality to the product as well as failure to maintain the environmental conditions specified by the manufacturer CUSTOMER IS HEREBY NOTIFIED THAT OPERATION OF THE EQUIPMENT DURING DAYLIGHT HOURS OR
10. tly enhances the performance of the NVG 7 while remaining almost totally invisible to the naked eye The NVG 7 goggles have a built in IR with indicator ON light within the FOV To turn the IR on rotate power swith clock wise in first position It is important to remember that the IR illuminator is simply an infra red light source and like any D l light source it may loose its effectiveness over a great dis Built in Infra red Illuminator tance To turn the IR off push the button again by long press more than 1 5 sec NOTE The IR will automatically turn off when the unit s power is tumed off FLIP UP HEADSET FITTING THE HEADGEAR 1 Fitthe headgear to your head size Adjust the headgear first before attaching the NVG 7 to it 2 Loosen all the straps and place the headgear on your head 3 Tighten the straps until the headgear fits firmly GOGGLES INSTALLATION AND ADJUSTMENT Now you are ready to mount the NVG 7 on to your headgear 1 Remove the already adjusted headgear from your head Diopter adjusting 2 Insert the head helmet mount adapter to mounting bracket of NVG7 Head helmet mount then tighten adapter screw firmly adapter 3 Insert the top edge of the mount Mounting bracket under the keeper on the head helmet mount bracket and rotate downward until the latch engages To release the mount from the helmet bracket press the release and pull forward and down 4 Align the adapter and the head helmet m
11. uring shipment When sending product back please clearly mark the RMA on the outside of the shipping box Please include a letter that indicates your RMA Name Return Address reason for service return Contact information such as valid telephone numbers and or e mail address and proof of purchases that will help us to establish the valid start date of the warranty Product merchandise returns that do not have an RMA listed may be refused or a significant delay in processing may occur Estimated Warranty service time is 10 20 business days End user customer is responsible for post age to ATN for warranty service ATN will cover return postage shipping to continental USA end users customers after warranty repair only if product is covered by aforementioned warranty ATN will return product after warranty service by domestic UPS ground and or domestic mail Any other requested required or international shipping method the postage shipping fee will be the responsibility of the end user customer For customer service and technical support please contact American Technologies Network Corp 1341 San Mateo Avenue South San Francisco CA 94080 phone 800 910 2862 650 989 5100 fax 650 875 0129 www atncorp com 2013 ATN Corporation
Download Pdf Manuals
Related Search