Timex T317 Clock Radio
Contents
1. or other appliances including amplifiers that produce or emit heat Power Sources The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance Grounding or Polarization This unit is equipped with a two pronged polarized alternating current line plug a plug having one blade wider than the other This plug only fits into your power outlet in one direction This is a safety feature If you are having difficulty inserting the plug fully into your outlet try reversing the plug blades do not force the plug into the outlet If you are still having difficulty contact your electrician to replace your obsolete outlet Power Supply Cord Protection Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them paying particular attention to areas at the outlet and where they exit from the unit Overloading Do not overload wall outlets extension cords or integral convenience receptacles as this can result in a risk of fire or electric shock Cleaning The unit should be cleaned only as recommended by the manufacturer See the Maintenance section of this manual for cleaning instructions Periods of Nonuse If the unit is to be left unused for an extensive period of time such as longer than a month the power cord should be unplugged from the outlet Object and Liquid Entry Care sho2. TIMEX AM FM Alarm Clock with Digital Radio Display Controls and Indicators Snooze Backlight Button Q Band Switch Tuning Control xul no mo Wo Mi Se Rae tos 106 108 Niz n Mode Switch Volume Control Alarm Hand Battery Compartment Alarm Set Thumbwheel Clock Set Thumbwheel Dimmer Switch OOOOOOOOOOOOOOOOOO0O000 OOOOOOOOOOOOOOOOOOOOOO0 OOOOOOOOOOOOOOOOOOOOOOO OOOOOOOOOOOOOOOOOOOOOO0O0 D C Power Cord D Wire Antenna Maintenance and Setup ls 2 Place the unit on a level surface away from direct sunlight or sources of excessive heat Protect your furniture when placing the unit on natural wood or wood with a lacquered finish A cloth or other protective material should be placed between the unit and the furniture Clean the casing with a soft cloth moistened only with mild soap and water Stronger cleaning agents such as thinner benzine or similar materials are not recommended as they may damage the surface of the case If the unit is not to be used for a prolonged period such as a month or longer remove the batteries to prevent possible corrosion Should the battery compartment become corroded or dirty clean the compartment thoroughly and replace all the batteries Power Sources Note This alarm clock radio operates on two power sources l To Replace the Battery 1 2 Close the battery compartment one AA ba
3. TION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE The lightning flash with arrowhead in an equilateral triangle is intended to alert the user of the presence of uninsulated dangerous voltage within the product s enclosure that may be of sufficient magnitude to constitute a risk of electric shock The exclamation point within an equilateral triangle is intended to alert the user of the presence of important operating and maintenance servicing instructions in the literature accompanying the appliance The symbols above are located at the bottom of the cabinet CAUTION To prevent electric shock do not use this Polarized plug with an extension cord receptacle or other outlets unless the blades can be fully inserted to prevent blade exposure ATTENTION Pour pr venir les chocs lectriques ne pas utiliser cette fiche polaris e avec un prolongateur Une prise de courant ou une autre sortie de courant sauf si les lames peuvent tre ins r es fond sans en laisser aucune partie decouvert This device complies with part 15 of the Federal Communications Commission Rules Operation is subject to the condition that this device does not cause harmful interferenc
4. e Note The manufacturer is not responsible for any radio or TV interference cause by unauthorized modifications to this equipment Such modification could void the user s authority to operate the equipment A Consumer Guide to Product Safety When used in the directed manner this unit has been designed and manufactured to ensure your personal safety However improper use can result in potential electrical shock or fire hazards Please read all safety and operating instructions carefully before installation and use and keep these instructions handy for future reference Take special note of all warnings listed in these instructions and printed on the product T 15 12 13 14 15 Water and Moisture The unit should be kept dry and away from water or other liquids If liquid is spilled on the unit or if the unit should fall or be accidentally placed in or on a wet or damp area immediately unplug the unit Ventilation The unit should be set up in an area and position that does not interfere with its proper ventilation Check to see where the ventilation opening is on the product Do not set up the unit on a bed sofa rug or similar surface that may block the opening Do not keep the unit in a tight fitting installation such as a bookcase or cabinet which impedes the flow of air through the ventilation openings Heat The unit should be situated away from heat sources such as radiators space heaters stoves
5. hase Should this product fail to function in a satisfactory manner it is best to first return it to the store where it was originally purchased Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period SDI Technologies will repair or at its discretion replace this product without charge except for a 3 00 charge for handling packing return UPS postage and insurance This decision is subject to verification of the defect or malfunction upon delivery of this product to the Factory Service Center listed below The product must include proof of purchase including date of purchase The fee for service after the warranty period or without proof of purchase is 6 00 Before returning this product for service please first replace the batteries if applicable with fresh ones as exhausted or defective batteries are the most common cause of problems encountered If service is still required 1 Remove batteries if applicable and pack the unit in a well padded heavy corrugated box 2 Enclose a photocopy of your sales receipt credit card statement or other proof of the date of purchase 3 Enclose a check or money order payable to the order of Soundesign for the sum of 3 00 or 6 00 if after the warranty period or without proof of purchase 4 Send the unit prepaid to the Factory Service Center listed below Consumer Repair Department SDI Technologies I
6. nc Timex Audio Products Division 1401 Pullman Drive Suite A El Paso TX 79936 7726 NOTE This warranty is valid only if the product is used for the purpose for which it was designed It does not cover i products which have been damaged by negligence misuse or accident or which have been modified or repaired by unauthorized persons ii cracked or broken cabinets or units damaged by excessive heat iii damage to tape cassettes if applicable iv the cost of shipping this product to the Factory Service Center and its return to the owner This warranty is valid only in the United States of America and does not extend to owners of the product subsequent to the original purchaser Any applicable implied warranties are also limited to 90 days and SDI Technologies will not be liable for consequential damages Some states do not allow limitations on implied warranties or exclusion of consequential damages so these restrictions may not apply to you This warranty gives you specific legal rights and you may also have other rights which vary from state to state For questions or comments regarding this or other products please call our toll free number 1 800 888 4491 TIMEX is a registered trademark of Timex Corporation in the United States and other countries T317 011204 0 Printed in China
7. s the clock backlight will also flash 4 When the alarm sounds you may turn off the alarm or activate the Snooze feature To turn off the alarm set the Mode Switch to Off Note When the alarm sounds it will play for a maximum of 40 minutes or until manually stopped before turning off automatically This cycle will repeat every 12 hours until the alarm is deactivated 5 To use the snooze feature press the amp Snooze Backlight Button The alarm will turn off for approximately nine minutes before sounding again You may repeat this process several times during the 40 minute snooze cycle Listening to the Radio Notes The radio will only play when the AC Power Cord is plugged in Extend the FM wire antenna fully for best FM reception Rotate the unit as required for best AM reception 1 Set the Mode Switch to On position to turn on the radio 2 Select a station by setting the Band Switch to either AM or FM and rotating the Tuning Control to desired station 3 Adjust volume using Volume Control thumbwheel 4 To turn off the radio set the Mode Switch to Off position Operating the Backlight Use the Dimmer Switch to set the backlight to either a High or Low brightness setting or to turn off the backlight completely To activate the backlight for a brief period in order to better see the display press the Snooze Backlight Button This activates the backlight for approximately five seconds CAU
8. ttery included for the clock and AC power for the radio and backlight The clock and an alarm will operate with only the battery For full operation of all features both power sources must be in use Please see A Consumer Guide to Product Safety specifically the Polarization and Power Supply Cord Protection notes for instructions on plugging in the AC Power Cord Open battery compartment cover Install 1 AA battery making sure that the polarity is correct as shown within the battery compartment cover and latch securely Setting Clock Time and Alarm Time Setting Clock Time Rotate the Clock Set Thumbwheel control to set the clock to the current time Setting Alarm Time Rotate the Alarm Set Thumbwheel control to position the Q Alarm Hand to the desired alarm time Note his is an analog clock with a 12 hour display The time and alarm can not distinguish between AM and PM times so if the Mode Switch is activated the alarm will sound during both AM and PM times Operating the Alarm and Snooze Features 1 Set the alarm time as indicated above in Setting Alarm Time 2 To wake to the radio set the Mode Switch to the AUTO position When the alarm sounds the radio will play the station the clock is set to see Listening to Radio The radio will only play when the AC Power Cord is plugged in 3 To wake up to the buzzer set the Mode Switch to the ALARM position When the buzzer alarm sound
9. uld be taken so that objects do not fall and or liquids do not spill into any openings or vents located on the product Attachments Do not use attachments not recommended by the product manufacturer Damage Requiring Service The appliance should be serviced by qualified service personnel when the power supply cord or plug has been damaged objects have fallen and or liquid has been spilled into openings or vents the unit has been exposed to rain the unit has been dropped or the enclosure damaged the unit exhibits a marked change in performance or does not operate normally Antenna The user should not connect an external antenna to the unit Servicing The user should not attempt to service the unit beyond those methods described in the operating instructions Any servicing not covered in the instructions should be left to qualified service personnel Please also see the Warranty Information for more information on product servicing moomg This device complies with Part 15 of the Federal Communications Commission Rules Operation is subject to the condition that the device does not cause harmful interference Limited 90 Day Warranty Information Timex Audio Products a division of SDI Technologies Inc hereafter referred to as SDI Technologies warrants this product to be free from defects in workmanship and materials under normal use and conditions for a period of 90 days from the date of original purc
Download Pdf Manuals
Related Search