Kenwood DDX5036 GPS Receiver User Manual
Contents
1. o rear left speaker Green Purple Blacl d o 90 To rear right speaker Purple English 5 System Connection USB device USB terminal commercially available T lt Rear View Camera input Visual input Yellow Audio Visual output Visual output Yellow Audio left output White Audio right output Red Visual input iPod AV input 2 switchable Resistance free mini plug 3 50 Audio input iPod AV input 2 switchable Resistance free stereo type mini plug 3 50 Rear Preout Audio left output White Audio right output Red Front Preout Audio left output White Audio right output Red Subwoofer Preout Audio left output White Audio right output Red 6 DNX SERIES DDX SERIES Optional Accessory Connection iPod commercially available rm KCA iP301V Optional Accessory Audio Output Black Navigation System Optional Accessory ri KCA BT200 Optional Accessory input Connection cable Included in the Navigation System TV Tuner Optional Accessory E Navigation units that can be connected to this unit As of December 2009 KNA G630 KNA G630CN For latest information access the www kenwood com cs ce Connection cable2. Acquiring GPS Signals The first time you turn on DNX SERIES you must wait while the system acquires satellite signals for the first time This process could take up to several minutes Make sure your vehicle is outdoors in an open area away from tall buildings and trees for fastest acquisition After the system acquires satellites for the first time it will acquire satellites quickly each time thereafter After the Installation After the installation perform the Initial Setup by referring to the instruction manual N Mounting and wiring this product requires skills and experience For safety s sake leave the mounting and wiring work to professionals Make sure to ground the unit to a negative 12V DC power supply Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity Also avoid places with too much dust or the possibility of water splashing Do not use your own screws Use only the screws provided you use the wrong screws you could damage the unit If the power is not turned ON PROTECT is displayed the speaker wire may have a short circuit or touched the chassis of the vehicle and the protection function may have been activated Therefore the speaker wire should be checked If your car s ignition does not have an ACC position connect the ignition wires to a power source that can be turned on and off with the ignition key If you connect the ignition wire
3. temperature Do not mount the unit in a place where the cooling fan of the unit are blocked Blocking these openings will inhibit the cooling of the internal temperature and result in malfunction Cooling fan IN CAUTION Install this unit in the console of your vehicle Do not touch the metal part of this unit during and shortly after the use of the unit Metal part such as the heat sink and enclosure become hot English 3 Connection If you connect the ignition wire red and the battery Ignition key wire yellow to the car chassis ground you may switch cause a short circuit that in tum may start a fire Always through the fuse box yo ACC A connect those wires to the power source running Car fuse box Main fuse Battery Connect to the vehicle s parking brake detection switch harness Parking sensor wire Light Green B A 4 Ignition wire Red Batt ire Yell n Car fuse box Be attery wire Yellow er Antenna Cora FM AM Ground wire Black antenna input To car chassis Ce PRK SW ne Connect to vehicle s reverse lamp harness when using the optional rear view camera To steering remote To use the steering wheel remote control feature you need to an exclusive remote adapter not supplied matches your car is required When this termin
4. Included in the TV tuner English 7 Installing the GPS Antenna DNX SERIES only GPS antenna is installed inside of the car It should be installed as horizontally as possible to allow easy reception of the GPS satellite signals To mount the GPS antenna inside your vehicle 1 Clean your dashboard or other surface 2 Peel the backing off of the adhesive on the bottom of the metal plate accessory 3 Press the metal plate accessory down firmly on your dashboard or other mounting surface You can bend the metal plate accessory to conform to a curved surface if necessary 4 Place the GPS antenna accessory on top of the metal plate accessory Accessory Accessory 3 Depending on the type of car reception of the GPS satellite signals might not be possible with an inside installation The GPS antenna should be installed at a position that is spaced at least 12 inch 30 cm from cellular phone or other transmitting antennas Signals from the GPS satellite may be interfered with by these types of communication Painting the GPS antenna with metallic paint may cause a drop in performance 8 DNX SERIES SERIES Installing the Escutcheon Installing the Escutcheon 1 Attach accessory to the unit Accessory For General Motors 1 Cut out accessory 8 to meet the shape of the opening of the center console 2 Attach accessory 8 to the unit Cu
5. KENWOOD GPS NAVIGATION SYSTEM DNX SERIES DNX5360 DNX5360M MONITOR WITH DVD RECEIVER DDX SERIES DDX5036 DDX5036M INSTALLATION MANUAL Kenwood Corporation B54 4766 10 01 MW M2W XW Accessories Accessory of DNX5360M This accessory is used when connecting an external device to AV IN jack on the front panel of this unit For how to use this accessory refer to the instruction manual of this unit 2 DNXSERIES DDX SERIES Installation Procedure 1 To prevent a short circuit remove the key from the ignition and disconnect the battery 2 Make the proper input and output wire connections for each unit 3 Connect the speaker wires of the wiring harness 4 Connect the wiring harness wires in the following order ground battery ignition Connect the wiring harness connector to the unit Install the unit in your car Reconnect the battery Press the reset button Perform the Initial Setup Refer to the Instruction Manual O o lt i o WARNING If you connect the ignition wire red and the battery wire yellow to the car chassis ground you may cause a short circuit that in turn may start a fire Always connect those wires to the power source running through the fuse box Do not cut out the fuse from the ignition wire red and the battery wire yellow The power supply must be connected to the wires via the fuse
6. al is not in use leave its cap on To car light control switch Connect to the terminal that is grounded when either the telephone rings or during conversation To connect the Kenwood navigation system consult your navigation manual Depending on what antenna you are using connect either to the control terminal of the motor antenna or to the power terminal for the booster amplifier of the film type antenna When using the optional power amplifier connect to its power control terminal For the sake of safety be sure to connect the parking sensor Reveres sensor wire Purple White Steering remote control wire Light Blue Yellow Dimmer control wire Orange White Mute control wire Brown Motor antenna control wire Blue Power control wire Blue White N If no connections are made do not let the cable come out from the tab 4 DNX SERIES SERIES FUSE 15 REVERSE STEERING WHEEL F REMOTE CONT REMOTE INPUT ILLUMI MUTE ANT CONT P CONT GPS Antenna Accessory see page 8 Accessory D White Blac H o front left speake e Whit Gray Blacl H k Gray Green Blac SHI
7. t out to meet the shape of the opening in the vehicle Accessory For Toyota Scion 1 Cut out accessory as illustrated Cutting line 2 Fold double sided adhesive accessory along the slit and attach it to accessory cut out against the center rib as illustrated Use 2 pieces of accessory for 1 accessory cut out 3 Attach accessory 5 cut out to the unit Accessory English 9 Installation for Monitor Player Unit Installation on Toyota Nissan or Mitsubishi Car using Brackets Accessory M5x6mm or Accessory 8 M5x7mm Car Bracket Accessory M5x6mm or Accessory 8 M5x7mm 10 DNX SERIES DDX SERIES English 11
8. to a power source with a constant voltage supply as with battery wires the battery may die lt If the console has a lid make sure to install the unit so that the faceplate will not hit the lid when closing and opening lt If the fuse blows first make sure the wires aren t touching to cause a short circuit then replace the old fuse with one with the same rating Insulate unconnected wires with vinyl tape or other similar material To prevent a short circuit do not remove the caps on the ends of the unconnected wires or the terminals Connect the speaker wires correctly to the terminals to which they correspond The unit may be damaged or fail to work if you share the wires or ground them to any metal part in the car When only two speakers are being connected to the system connect the connectors either to both the front output terminals or to both the rear output terminals do not mix front and rear For example if you connect the connector of the left speaker to a front output terminal do not connect the connector to a rear output terminal After the unit is installed check whether the brake lamps blinkers wipers etc on the car are working properly Mount the unit so that the mounting angle is 30 or less Do not press hard on the panel surface when installing the unit to the vehicle Otherwise scars damage or failure may result This unit has the cooling fan to decrease the internal
Download Pdf Manuals
Related Search