Garmin 190-01492-00-0B GPS Receiver User Manual
Contents
1. 2 Turn on the other device and enable the Bluetooth component You can refer to the device s documentation for specific instructions about enabling Bluetooth wireless technology 3 Bring the sensor within 30 feet 10 meters of the mobile device 4 Using the mobile device pair the sensor with the mobile device The blue LED is solid blue when the sensor is connected to the other device lf the sensor has not established a Bluetooth connection for several minutes it turns off automatically Status LED LED Description Slow flashing orange Charging Solid orange Battery charged power connected Orange off Battery charged power disconnected Rapid flashing orange Low battery Alternating orange Faulty battery or and green system error Flashing green Searching for GPS satellites Solid green GPS satellite fix A t Satellite Signals Verify that the blue LED on the sensor is solid blue indicating a wireless connection Bluetooth LED LED Description Slow flashing Searching for mobile devices blue Rapid flashing Pairing blue Solid blue Connected to mobile device 2 Place the sensor where it has a clear view of the sky Acquiring satellite signals may take a few minutes The Status LED flashes green while searching for satellites and establishing your location The Status LED is solid green when it has established a fix on your location Using2. other compliance programs can be found at www garmin com aboutGarmin environment Declaration of Conformity Hereby Garmin declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999 5 EC To view the full Declaration of Conformity go to www garmin com compliance FCC Compliance This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and may cause harmful interference to radio communications if not installed and used in accordance with the instructions However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one of the following measures e Reorient or relocate the receiving a
3. the Portable Friction Mount The portable friction mount comes in some GLO packages and is available as an optional accessory 1 Wipe the mounting surface and the back of the mount with a wet cloth to remove dust and debris 2 Insert the sensor in the mount so the LEDs face up and the mini USB port is accessible 3 Place ona flat surface Periodically you should wipe the surface and the mount with a wet cloth to remove dust and debris to help prevent the mount from sliding Product Compatibility Made for iPod touch 4th generation iPod touch 3rd generation iPhone 4S iPhone 4 iPhone 3GS iPad 2 and iPad Made for iPod iPhone iPad means that an electronic accessory has been designed to connect specifically to iPod iPhone or iPad respectively and has been certified by the developer to meet Apple performance standards Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards Please note that the use of this accessory with iPod iPhone or iPad may affect wireless performance The GLO sensor is also compatible with many Android Windows or Blackberry smartphones tablets and notebook computers When using the GLO GPS GLONASS sensor with an Android device you may need to use an application to allow the sensor to properly communicate with the Android system over Bluetooth technology The application will allow the Android system t
4. E 815 69 555 00800 4412 454 44 2380 662 915 00 35 1214 447 460 Ma 00 34 902 007 097 00 46 7744 52020 Garmin and the Garmin logo are trademarks of Garmin Ltd or its subsidiaries registered in the USA and other countries Garmin International Inc GLO is a trademark of Garmin Ltd or its subsidiaries These 1200 East 151st Street trademarks may not be used without the express permission of Olathe Kansas 66062 USA Garmin Garmin Europe Ltd The Bluetooth word mark and logos are owned by the Bluetooth Liberty House Hounsdown Business Park SIG Inc and any use of such marks by Garmin is under license Southampton Hampshire S040 9LR UK iPad iPhone iPod and iPod touch are trademarks of Apple Garmin Corporation Inc registered in the USA and other countries Android is a No 68 Zhangshu 2nd Road Xizhi Dist trademark of Google Inc Windows is a registered trademark of New Taipei City 221 Taiwan R O C Microsoft Corporation in the United States and other countries BlackBerry is registered with the U S Patent and Trademark Office and may be pending or registered in other countries QO ce 2012 Garmin Ltd or its subsidiaries
5. GARMIN GLO GLONASS and GPS Sensor Instructions Made for iPod iPhone L iPad August 2012 190 01492 00_0B Printed in Taiwan Installing the Battery This product contains a lithium ion battery See page 5 for important battery safety information 1 With your thumbnail slide the battery cover release tab 1 NO Remove the battery cover Locate the metal contacts on the end of the lithium ion battery 4 Insert the battery so the metal contacts on the battery align with the metal contacts inside the battery compartment Press the battery down into place Insert the battery cover into the notches and press down os oOo oo The release tab locks the cover in place Replacement Battery You can purchase a replacement battery 010 10840 00 at http buy garmin com Charging the Battery You can use the sensor while you are charging it 1 Plug the small end of the power cable into the mini USB connector on the end of the sensor 2 Plug the other end of the power cable into an appropriate source of power for the cable type It takes about three hours to charge the battery A fully charged battery lasts about 12 hours NOTE If the battery has not been charged for a long period of time remove the battery connect the cable to the device and a power source and then replace the battery The battery will charge as usual Pairing the Sensor 1 Hold to turn on the sensor
6. ntenna e Increase the separation between the equipment and the receiver e Connect the equipment into an outlet that is on a different circuit from the GPS unit e Consult the dealer or an experienced radio TV technician for help This product does not contain any user serviceable parts Repairs should only be made by an authorized service center Unauthorized repairs or modifications could result in permanent damage to the equipment and void your warranty and your authority to operate this device under Part 15 regulations Industry Canada Compliance Category radiocommunication devices comply with Industry Canada Standard RSS 210 Category II radiocommunication devices comply with Industry Canada Standard RSS 310 This device complies with Industry Canada license exempt RSS standard s Operation is subject to the following two conditions 1 this device may not cause interference and 2 this device must accept any interference including interference that may cause undesired operation of the device Limited Warranty Garmin s standard limited warranty applies to this accessory For more information go to www garmin com support warranty html www garmin com support Bese 913 397 8200 0808 238 0000 1 800 800 1020 44 870 850 1242 1 866 429 9296 43 0 3133 3181 0 E 00 32 2 672 52 54 00 45 4810 5050 miin 00 358 9 6937 9758 E 00 331 55 69 33 99 0180 5 42 76 46 880 00 39 02 3669 9699 0800 0233937
7. o accept non system or mock GPS GLONASS signals Registering the Device e Go to http my garmin com e Keep the original sales receipt or a photocopy in a safe place Specifications Case Rugged but not water resistant Power Supply Rechargeable lithium ion battery 12 hours typical use 4 Update Rate 10 Hz but not all mobile devices support a 10 Hz update rate Vehicle Power Cable Input Voltage 12 28 Vdc available in some packages Operating Temperature 4 F to 140 F 20 C to 60 C Charging Temperature 32 F to 113 F 0 C to 45 C Short Term 1 month Storage Temperature 4 F to 122 F 20 C to 50 C Long Term 1 year Storage Temperature 4 F to 68 F 20 C to 20 C Important Safety and Product Information Installation Warnings When installing the device in a vehicle place the device securely so it does not obstruct the driver s view of the road or interfere with vehicle operating controls such as the steering wheel foot pedals or transmission levers Do not place unsecured on the vehicle dashboard Do not place the device in front of or above any airbag OK Battery Warnings If these guidelines are not followed the battery may experience a shortened life span or may present a risk of damage to the sensor fire chemical burn electrolyte leak and or injury Do not leave the sensor exposed to a heat source or in a high tempera
8. ture location such as in the sun in an unattended vehicle To prevent the possibility of damage remove the device from the vehicle or store it out of direct sunlight such as in the glove box e Do not use a sharp object to remove the battery Do not disassemble puncture incinerate or damage the battery Keep the battery away from children e f using an external battery charger only use the Garmin accessory approved for your product e Only replace the battery with the correct replacement battery Using another battery presents a risk of fire or explosion To purchase a replacement battery see your Garmin dealer or the Garmin website When storing the device for an extended time store within the following temperature range from 4 F to 68 F 20 C to 20 C e Do not operate the device outside of the following temperature range from 4 F to 140 F 20 C to 60 C e Contact your local waste disposal department to dispose of the device battery in accordance with applicable local laws and regulations Navigation Warnings Use this sensor only as a navigational aid Do not attempt to use the sensor for any purpose requiring precise measurement of direction distance location or topography This product should not be used to determine ground proximity for aircraft navigation Product Environmental Programs Information about Garmin s product recycling program and WEEE RoHS REACH and
Download Pdf Manuals
Related Search