Fisher-Price H7181 Swing Sets User Manual
Contents
1. the battery compartment door and pry the battery compartment door off e Insert four C LR14 alkaline batteries as indicated inside the battery compartment e Replace the battery compartment door Battery Safety Information Batteries may leak fluids that can cause a chemical burn injury or ruin your product To avoid battery leakage e Do not mix old and new batteries or batteries of different types alkaline standard carbon zinc or rechargeable nickel cadmium Insert batteries as indicated inside the battery compartment Remove batteries during long periods of non use Always remove exhausted batteries from the product Dispose of batteries safely Do not dispose of batteries in a fire The batteries may explode or leak Never short circuit the battery terminals Use only batteries of the same or equivalent type as recommended Do not charge non rechargeable batteries Remove rechargeable batteries from the product before charging If removeable rechargeable batteries are used they are only to be charged under adult supervision Setup and Use WARNING To prevent serious injury or death from falls and being strangled in the restraint system e Always use the restraint system e Not recommended for children who can sit up by themselves 6 months approximately until 9 kg 20 Ibs e Never leave the child unattended e lt is dangerous to use this product on an elevated surface IMPORTANT Before e2. Fisher Price www fisher price com H7181 Product features and decorations may vary from picture above A N WARNING IMPORTANT KEEP INSTRUCTIONS FOR FUTURE REFERENCE e Please read these instructions before assembly and use of this product e Adult assembly is required e Tool needed for assembly Phillips Screwdriver not included e Requires four C LR14 alkaline batteries for operation not included e Weight Limit 9 kg 20 Ibs IMPORTANT The maximum weight limit for this product is 9 kg 20 Ibs If your child weighs less than 9 kg 20 Ibs but is really active and appears to be able to climb out of the swing immediately discontinue its use WARNING To prevent serious injury or death from falls and being strangled in the restraint system e Always use the restraint system e Not recommended for children who can sit up by themselves 6 months Seat Back Tube approximately until 9 kg 20 Ibs e Never leave the child unattended e It is dangerous to use this product on an elevated surface Lower Swing Arm Assembly with Restraint System CAUTION This package contains small parts in its unassembled state Adult assembly is required 2 Base Tube Front Tube 3 Link Toys Rana 6 x 1 9 cm Screw 4 Shown Actual Size NOTE Tighten and loosen all screws with a Phillips screwdriver Do not over tighten the screws IMPORTANT Before assembly inspect th
3. ach use inspect this product for damaged hardware loose joints missing parts or sharp edges DO NOT use if any parts are missing or broken Contact Mattel for replacement parts and instructions if needed Never substitute parts Securing your Child e Place your child in the seat Position the crotch pad between your child s legs e Fasten the waist belts to the crotch pad Make sure you hear a click on both sides e Check to be sure the restraint system is securely attached by pulling it away from your child The restraint system should remain attached IMPORTANT Do not lift this product while your child is in it Setup and Use Anchored End Free End Free End To tighten the restraint straps e Feed the anchored end of the restraint strap up through the buckle to form a loop Pull the free end of the restraint strap To loosen the restraint straps e Feed the free end of the restraint strap up through the buckle to form a loop Enlarge the loop by pulling on the end of the loop toward the buckle Pull the anchored end of the restraint strap to shorten the free end of the restraint strap Starting the Swing e Turn the power dial to any of eight settings e Give the seat a light push to start the swinging motion Adjust the swing power dial to the desired swing motion setting Hint As with most battery powered swings a heavier child will reduce the amount of swinging motion on all settings In most case
4. is product for damaged hardware loose joints missing parts or sharp edges DO NOT use if any parts are missing or broken Contact Mattel for replacement parts and instructions if needed Never substitute parts Upper Frame Tube e Rotate the upper frame tube until it snaps into an upright position as shown Short Tubes e While pressing the button on the base tube insert it into a short tube on a frame tube e Push the base tube until it clicks into place e While pressing the button on the other end of the base tube insert it into the short tube on the other frame tube e Push the base tube until it clicks into place Hint You may need the help of another adult to hold the frame tubes while you assemble the base tube to them Press Button on Front Tube Press Button on Lower Frame Tube Rubber Feet Down e Position the front tube so that the rubber feet are flat on the surface e While pressing the button on the lower frame tube insert it into an end of the front tube Continue to insert the lower frame tube into the front tube until you hear a click e While pressing the button on the front tube insert it into the end of the lower frame tube Continue to insert the front tube into the lower frame tube until you hear a click Front Tube e Pull the front tube to be sure it is secure to each lower frame tube Press Button on Upper Frame Tube e Insert the upper frame tubes into the frame unti
5. l you hear a click on both sides e Check to be sure the upper frame tubes are secure in the frame If you can remove the upper frame tubes from the frame you have not properly inserted the tubes into the frame Repeat Assembly step 5 Upper Swing Arms Lower Swing Arm Assembly with Restraint System e Fit the lower swing arm assembly to the outside of each upper swing arm e Insert two 6 x 1 9 cm screws through each upper swing arm and into each lower swing arm Tighten the screws Seat Back Tube Buttons Swing Arm Short Tubes e Position the seat back tube so that it curves toward the back of the swing e While pressing the buttons on the seat back tube fit the seat back tube into the short tubes on the swing arms e Push the seat back tube until it clicks into place e Pull up on the seat back tube to be sure it is secure to the swing arms Upper Pocket Lower Pocket 0 Seat Back Tube Seat Bottom Tube e Fit the upper pocket on the pad over the seat back tube Q e Lift the seat bottom tube Fit the lower pocket on the pad over the seat bottom tube e From behind the seat insert the waist belts into the slots in the pad e Push to fasten the restraint system to the pad Assembly is now complete Battery Installation Hint We recommend using alkaline batteries for longer battery life 1 5V x 4 C LR14 Shown Actual Size Battery Compartment e Insert a coin into
6. outh Tower World Finance Centre Harbour City Tsimshatsui HK China MALAYSIA Diimport amp Diedarkan Oleh Mattel SEA Ptd Ltd 993532 P Lot 13 5 13th Floor Menara Lien Hoe Persiaran Tropicana Golf Country Resort 47410 PJ Tel 03 78803817 Fax 03 78803867 Fisher Price Inc a subsidiary of Mattel Inc East Aurora New York 14052 U S A PRINTED IN CHINA 2005 Mattel Inc All Rights Reserved H7181pr 0726 and designate U S trademarks of Mattel Inc
7. s the low setting works best for a smaller child while the high setting works best for a larger child e If swinging stops while using a lower setting try a higher setting Give the seat a light push to start the swinging motion again e Be sure to turn this product off when not in use Turn the power dial to the off setting O IMPORTANT The maximum weight limit for this product is 9 kg 3 Link Toys 20 Ibs If your child weighs less than 9 kg 20 Ibs but is really active and appears to be able to climb out of the swing immediately discontinue its use e Fit the link toys to either of the hanging toys on the swing Setup and Use Baby Activated Parent Activated 0 O Lights and N Lights and Music Switch ee Volume Dial Music Switch Hint Your baby can enjoy lights and music with or without swinging e Slide the lights and music switch to When baby pulls either toy on the arch one tune plays along with twinkling lights 4 On this setting six tunes approximately 10 minutes play along with dancing lights d On this setting music plays for about 10 minutes O Turns lights and music off e Turn the volume dial to a comfortable listening level IMPORTANT Low battery power may cause this product to operate erratically no sounds movement and the product may not turn off Remove and throw away all four batteries and replace with four new C LR14 alkaline batteries Take Along Lift Seat Bottom Lo
8. wer Frame Tube Lift Seat Back Seat Back e Rotate the lower frame tube around to the top of frame as shown To set the swing back up for use e Rotate the lower frame tube around until it snaps into place e Place the swing on a non elevated flat surface e Tip the swing backwards with the seat back down e Press both buttons on the frame at the same time to release the frame base e The frame pad and toys may be wiped clean using a mild cleaning solution and a damp cloth Do not immerse the frame e This product has no consumer serviceable parts Do not take this product apart IMPORTANT Never use this product without the provided pad Be sure to re attach the provided pad with restraint system to this product Upper Pocket Lower Pocket Waist Belts To remove the pad e Push the waist belts back through the slots in the pad e Unfasten and slide the pad upper pocket off of the seat back e Unfasten and slide the pad bottom pocket off of the seat bottom To replace the pad e Refer to Assembly steps 10 and 11 Consumer Information GREAT BRITAIN Helpline 01628 500302 Or write to Mattel UK Ltd Vanwall Business Park Maidenhead SL6 4UB AUSTRALIA Mattel Australia Pty Ltd 658 Church Street Locked Bag 870 Richmond Victoria 3121 Australia Consumer Advisory Service 1300 135 312 NEW ZEALAND 16 18 William Pickering Drive Albany 1331 Auckland ASIA Mattel East Asia Ltd Room 1106 S
Download Pdf Manuals
Related Search