Home

Field Controls UV-18X Air Cleaner User Manual

image

Contents

1. a chet A Dimension inches unene uvasx iaaa Venier on Duet Housing UV 18X 13 1 2 10 5 16 l WARNING Never expose eyes or skin to UVC light from any source Looking directly at the UVC light may cause permanent eye damage or blindness Never operate the UV Aire Air Purifying System out of the plenum Avoid touching the glass portion of the lamp with your hands Page 6 V MAINTENANCE 1 Inspect and clean lamp at least every 6 months 2 Replace your UV Aire Air Purifying System lamp once a year to maintain the lamps maximum output intensity The lamp should operate continuously for maximum lamp life and light effectiveness VI REPLACEMENT PROCEDURE A VERY IMPORTANT Turn switch on unit to OFF position and unplug unit from outlet 1 Loosen two side screws on unit Remove cover 2 Unplug ballast plug from end of lamp 3 Remove wing nut on swivel bracket Swing bracket out clearing for lamp removal 4 Slide lamp out carefully NOTE When replacing the lamp always wipe off lamp before installing On Replace lamp following the appropriate procedure based on bracket selection in the installation section UV lamps contain a small amount of mercury like a typical fluorescent lamp Check with your local waste management authority for local disposal or recycling requirements According to the EPA s Universal Waste Rule these types of lamps may be disposed of into
2. See Figures 10 amp 11 g Using a screwdriver or pointed object locate mounting holes by poking holes through the duct tape See Figure 12 ee oper a ae Figure 3 Figure 4 Figure 7 Figure 9 Figure 10 Figure 11 Figure 12 Figure 8 WARNING Never expose eyes or skin to UVC light from any source Looking directly at the UVC light may cause permanent eye damage or blindness Never operate the UV Aire Air Purifying System out of the plenum Avoid touching the glass portion of the lamp with your hands Page 3 3 Remove base unit and cover from box 4 Apply supplied Duct Seal Kit according to instructions included in kit See Figure 12 5 Determine whether to use flat or angled bracket Refer to UV Aire Configurations in Section III for aid in this decision a Flat Bracket Installation i Remove the two hex nuts and flat bracket from included bagged hardware il Install the flat bracket and secure to the unit base with the hex nuts provided See Figure 13 Figure 13 b Angled Bracket Installation NOTE For angled bracket mounting refer to specifications outlined by Diagrams A amp B for mounting distances in the Angled Lamp Mounting Bracket Specifications in section Il i Remove the two hex nuts and angled bracket from included bagged hardware il Install the angled bracket and secure to the unit base with the hex nuts provided See Figure 14 NOTE Be sure to note l
3. Oy UV AIRE AIR PURIFYING SYSTEM j gt Model UV 18X ITEMS INCLUDED IN KIT 1 UV Aire power unit 4 Sheet metal mounting screws 2 Angled mounting brackets 2 Flat mounting brackets 1 Duct board mounting bracket 2 Ultra Violet lamps 1 Instruction Sheet 2 Wing nuts Caution Labels Gasket UV C light inhibits the growth and reproduction of germs and bacteria that circulate through a homes heating and air conditioning system The treatment is a safe silent and proven way to make your home a healthier place to live READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE PROCEEDING WITH THE INSTALLATION LEAVE THE INSTALLATION INSTRUCTIONS WITH THE OWNER OPERATOR OF THE DEVICE AFTER OPENING THE CARTON UNPACK AND INSPECT THE UNIT AND LAMP FOR DAMAGE DO NOT INSTALL THIS UNIT IF ANY DAMAGE IS NOTICEABLE SAFETY CONSIDERATIONS WARNING Never expose eyes or skin to UVC light from any source e Looking directly at the UVC light may cause permanent eye damage or blindness e Never operate the UV Aire Air Purifying System out of the plenum e Designed for a closed duct system Do not mount near a return air opening e All duct openings in direct line of site of the UV light must be sealed with duct tape or equivalent sealing methods WARNING UV light will break down plastic materials not rated for UV exposure Examples wire insulation flex duct drain pans and humidifiers e The unit must be mounted at least 30 from t
4. eyes or skin to UVC light from any source Looking directly at the UVC light may cause permanent eye damage or blindness Never operate the UV Aire Air Purifying System out of the plenum Avoid touching the glass portion of the lamp with your hands Page 2 2 Determine the type of duct you have For flex duct applications refer to Figure 21 on page 8 IF YOU HAVE METAL DUCT a Apply supplied wet and stick mounting template to air duct in either a vertical or horizontal position as shown in Figure Drill 1 8 Diameter Holes 2 a Typical 4 Places b Drill 1 8 diameter mounting holes at positions indicated on template Cut along dotted lines c Cut out rectangular hole on template using a pair of tin l with a jgsaw or tin snips snips or jigsaw See Figure 2 Remove template Mounting _ emplate IF YOU HAVE DUCT BOARD Mount unit either horizontal a Mount the supplied metal mounting plate onto the duct with or verica duct tape in either a vertical or horizontal position as shown Figure 2 in Figure 2 See Figure 3 b Bend tabs outward as shown in figure 4 c Using a knife or blade cut out a rectangle opening in the duct using the mounting plate as a template See Figure 5 d Remove the cut piece of duct See Figure 7 e Bend both tabs down and through duct at first bend point See Figures 8 amp 9 f Bend both tabs at the second bend point up or down to pinch the duct material and grip the duct material
5. he above stated type of materials e lf it is necessary to mount the unit in direct line of site of these types of materials they must be shielded with aluminum foil aluminum foil tape or sheet metal WARNING DO NOT mount this unit outdoors e This product is designed for indoor installation only i e attics crawl spaces basements etc gt eae 2630 Airport Road Kinston NC 28504 Phone 252 522 3031 FAX 252 522 0214 www fieldcontrols com I INDICATION FOR USE This product is not sold as a medical device and is not for the purpose of diagnosis of any disease or condition nor for use in the mitigation treatment or prevention of any disease or condition ll GENERAL INFORMATION There are different size units available depending on the square footage of your home See chart below for determining your homes needs i Bree a Volts Max Air Lamp Intensity at 1 Recommended Width Hz Temp F meter Max Sq Feet WARNING Before installing or servicing a humidifier air filter heat system or this unit etc always turn all power OFF and have units unplugged Electrical shock can cause personal injury or death Never expose eyes or skin to direct UVC light from any source WARNING To prevent water damage or electric shock do not mount unit under a humidifier Aa WARNING Designed for a closed duct system Do not mount near a return air opening WARNING This product is designed for indoor installation only
6. household waste 7 After replacing lamp make sure a new Lamp Replacement Label supplied with lamp replacement is applied to the housing and dated with the date of installation VII TROUBLESHOOTING GUIDE 1 If unit does not light up replace bulb 2 If unit still does not light up after replacing bulb replace ballast Vill REPLACEMENT PARTS LIST LAMP BALLAST ee Field Controls Part Number Field Controls Part Number UV 18X 46365402 46365503 For replacement parts contact your local heating service company Any questions please contact Field Controls at G Phone 252 522 3031 Fax 252 522 0214 Email sales fieldcontrols com WARNING Never expose eyes or skin to UVC light from any source Looking directly at the UVC light may cause permanent eye damage or blindness Never operate the UV Aire Air Purifying System out of the plenum Avoid touching the glass portion of the lamp with your hands Page 7 IX FLEX DUCT INSTALLATION For installations on duct systems with a metallic main duct and flex duct branches follow the instructions in figure 21 below GALVANIZED SUPPLY DUCT A FLEX DUCT HARE GALVANIZED DUCT PIPE BRANCH DUCT ATTACHMENTS A DUCT B EXT LENGTH C MIN DISTANCE GALVANIZED 90 ELBOW Figure 21 Limited Warranty Field Controls L L C warrants that the following Field Controls L L C products sold hereunder shall be free from defects in material and w
7. i e attics crawl soaces basements etc For A use on gas fired oil fired electric and split system heat pump forced air systems This product is NOT designed to be mounted outside on gas fired or heat pump packaged units Split system heat pumps are systems where the air handler and the air conditioning compressor are separate units Packaged units are systems where the air handler and the air conditioning compressor are built together and are installed outside of the building lll INSTALLATION 1 Locate a suitable location for the unit downstream from the A coil in the supply plenum or in the return plenum preferably downstream from the air filter For optimum cleaning effect on the A coil mount the unit in the supply plenum as close as possible to the A coil See Figure 1 Minimum _ Minimum Length or Width Length or Width UV 12 12 inches UV 12 12 inches UV 18 18 inches UV 18 18 inches UV 18HP 18 inches UV 18HP 18 inches UV 18X 18 inches UV 18X 18 inches UV 28 24 inches UV 28 24 inches with angled bracket with angled bracket 28 inches with 90 28 inches with 90 mounting bracket mounting bracket BEST LOCATION SUPPLY AIR N A COIL Z Lu A x lt Z xX D L 4 Note Seal joints and seams of the plenum near the mounting location to reduce any direct viewing of light OPTIONAL LOCATION Figure 1 WARNING Never expose
8. im on behalf of the customer but ultimately responsibility for disposition of the warranty claim lies with the manufacturer The health aspects associated with the use of these products and their ability to aid in disinfecting of environmental air have not been investigated by UL FIELDCONTROLS SOLUTIONS FOR THE GREAT INDOORS P N 46453300 Rev C 04 05
9. ocation of lamp hole in bracket relative to unit base 6 Mount the unit base to the duct using the four mounting screws provided See Figure 15 7 Remove tag and alcohol from lamp Wipe off lamp being sure not to touch lamp with bare hands The oils in your hands may cause the lamp to prematurely expire Figure 15 blindness Never operate the UV Aire Air Purifying System out of the plenum Avoid touching the glass portion of the lamp with your l WARNING Never expose eyes or skin to UVC light from any source Looking directly at the UVC light may cause permanent eye damage or hands Page 4 8 Insert lamp through hole until lamp cannot be inserted any further See Figure 16 Fiaure 16 9 Swing swivel bracket over end of lamp Hand tighten the wing nut on stud See Figure 17 Be careful not to over tighten the wing nut The porcelain at the lamp base may crack when over tightened Figure 17 10 Plug ballast plug into end of lamp See Figure 18 Figure 18 11 Replace cover on unit Tighten side screws See Figure 19 amp 20 12 Plug the power cord into a standard electrical outlet NOTE Seal the joints and seams of the plenum near the mounting or i Figure 19 Figure 20 location to reduce any direct viewing of light See Figure 1 13 Flip switch on box to the ON position Light on switch should be on indicating power 14 Look through view port in the box cover to be sure lamp is
10. orkmanship under normal use for eighteen 18 months from date of manufacturing by the consumer excepting the provisions numbered below UV LAMPS BULBS Field Controls L L C warrants that the following Field Controls L L C products sold hereunder shall be free from defects in material and workmanship under normal use for ninety 90 days from date of installation by the consumer excepting the provisions numbered below Provisions Field Controls shall have no obligation in the event the customer is unable to provide receipt showing the date the customer purchased the product s or accurate date code information The product must be properly installed maintained and operated under normal conditions Field Controls shall not be liable for any consequential and incidental damages resulting from failure of a Field Controls L L C product failure to deliver delay in delivery delivery in nonconforming condition or for any breech of contract or duty between Field Controls L L C and the customer Field Controls L L C products are often intended for use in specific applications Field Controls L L C makes no warranty if a Field Controls L L C product is used in applications other than intended Field Controls L L C makes no warranty of any kind in regard to any other manufacturer s products distributed by Field Controls L L C Field Controls L L C will pass on all warranties made by the manufacturer and where possible will expedite the cla
11. working You should see a blue glow The view port is covered with a plastic lens that blocks the UVC rays 15 If the lamp is not glowing follow steps 8 14 again If lamp still does not glow contact technical support at 1 252 522 3031 for further assistance WARNING Never expose eyes or skin to UVC light from any source Looking directly at the UVC light may cause permanent eye damage or blindness Never operate the UV Aire Air Purifying System out of the plenum Avoid touching the glass portion of the lamp with your hands Page 5 IV BULB MOUNTING BRACKET SELECTION AND INSTALLATION The UV AIRE units come with an angled mounting bracket and flat mounting bracket to position the bulb either straight or at an angle Choose one or the other bracket method best suited for your needs Refer to the configurations chart below when making your selection UV INTENSITY UV Aire Configurations Patent Pending 45 Installation Double Lamp Standard 90 Angled Bracket Installation Angle option allows longer lamps to fit Double Lamp in smaller ducts Flat Bracket 16 Duct 20 Duct ANGLED LAMP MOUNTING BRACKET SPECIFICATIONS Use the specifications below to determine allowable clearances for proper mounting of the UV Aire unit on the duct __ 5 Minimum On Center et Diagram A Center of Lamp Mount LAMP CENTER LINE FOR ANGLED Diagram B DOUBLE LAMP INSTALLATION LAMP OFFSET DIMENSIONS

Download Pdf Manuals

image

Related Search

Related Contents

  User Protocol WideScreenTM Human CVD Panel 6  Tote Vision LCD-900HDT User's Manual  Samsung GT-B2700 Керівництво користувача  CLC018 8 x 8 Digital Crosspoint Switch, 1.485  NEC ND-3570 DVD-RW Beige    courrier ci-joint (20/11/2013)  取扱説明書  USB Mass Storage Disk  

Copyright © All rights reserved.
Failed to retrieve file