Emerson EM529S Headphones User Manual
Contents
1. After successfully pairing my mobile phone and headset when I shut the phone and turn it on again the headset did not automatically reconnect e Try turning the headset OFF and then turning it ON again e Many mobile phones have an auto reconnect option when first attempting to reconnect to a newly paired Bluetooth device Make sure you accept this option so that the headset automatically reconnects to your mobile phone check the user guide of your mobile phone for more information regarding this option e Try unpairing the headset from your phone and repeat the pairing procedure I hear distortion and the sound quality is poor e For the best audio quality always wear the headset onthe same side of the body as your mobile phone e Check that the battery is charged enough The sound is very low e Try adjusting the volume by using the Volume Up or Volume Down button on the headset make sure the volume on your mobile phone is turned up as well FCC Part 15 This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 15 of the Federal Communications Commission FCC rules These requirements are intended to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful inter2. Redialing the last number called Dependent on your phone supporting this feature Press the Call button twice The last number called will be redialed Call button Press twice to redial Volume To adjust the in call volume press the Volume Up or Volume Down button Volume Up Volume Down NOTE You may also adjust the volume from your mobile phone s volume control Mute Press the Volume Up and the Volume Down button simultaneously until you hear a beep repeat to unmute the call to mute and unmute Volume Up gt Press simultaneously AANS gt Volume Down For added comfort and noise suppression 3 silicone cushions are included with the headset Choose the silicone cushion S M L which fits most comfortably in your ear and insert it on the headset as shown in the diagram below S ML DDD Silicone cushions You may wear the headset with or without the provided earhook If you choose to use the earhook connect it to the headset as shown in the diagram below Earhook Right ear Left ear NOTE For the best audio quality always wear the headset on the same side of your body as your mobile phone Connect the Stereo earphone to the Bluetooth Headset s charging socket as shown below Stereo earphone Charging socket 60000000 Insert the Bluetooth Headset in one ear and wrap the Stereo Earph
3. and you also may have other rights that vary from state to state ge amp mersor www emersonphones com Distributed by Southern Telecom Inc Brooklyn NY 11232 2011 Southern Telecom Inc All rights reserved Emerson and the G Clef logo are registered trademarks of Emerson Radio Corp Parsippany New Jersey USA The Bluetooth word markand logos are owned by the Bluetooth SIG Inc SONY PlayStatiion amp PS3 are either trademarks or registered trademarks of SONY All other trademarks are trademarks of their respective owners
4. beep Indicator light Charging Socket Headset AC Charger Car Charger About noise cancellation technology This headset uses a dual microphone design to filter out wind and unwanted external noise Using Noise Cancellation Technology the headset compares the sound from the twin built in microphones and is able to recognize the difference between voice and unwanted background noise Noise cancel microphone 1 NN ANNT AANO WAS ANODO Sd Noise cancel microphone 2 Noise Cancellation Technology Enables the other end of your conversation to hear you clearly Pairing the headset Manual Pairing 1 Make sure the Bluetooth Headset is within 3 feet of your mobile phone or Bluetooth enabled device 2 Set the Power switch to the ON position 3 Press and HOLD the Call button until the indicator light flashes RED and BLUE alternately 4 The headset is now in Pairing Mode and is ready to connect to your mobile phone or Bluetooth enabled device Power Switch Power ON OFF Green ON Red OFF within 3 feet Indicator light Red and Blue flashing NOTE To enter Pairing Mode at any time you must press and HOLD the Call button for approximately 10 seconds 5 Set your mobile phone to search for Bluetooth devices Bluetooth Enabled Paired Devices 6 When the phone finds the headset confirm by selecting EM529 from the list Bluet
5. GEME son WIRELESS HEADSET AAAA 1900000 OHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHOHHHHHHHHHHO888C8OH8888O88 0000000 OOOHOHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHOH8O8O8OHOO8CO88O8O1 AAAA JIII KIJ RARAARARRARRRRRRRR OO eR JI JII 0000 OOHHHOOHHHHOOEHO8HHHHHHHHHHHHHHHHHHHOOOSHHHHHOHHHHHOHHHHHHHHOOH8EECt gt 09O0O000OHOOOHOH88HHHOHHHHHHHHHHHHHHHHHHHHH888O 00000008000 OOOG8OHHHHHHHHHHHHHHOHHHHH888O8O8 9020000008008 08888CC8 AA AAA 0000 8008008008888808 0000 88880800808808808O4 00080808008008 LAKARRARI 0008000000808680080 000080000080800008 04 gt 2000800080080886800 0000 080808 0080880080808 08008 000000000068 0008 8080080808080880808081 0000008000086868 0000 008600008O8O8HHO88COO8 00000080 0006 88080HHO008H8H8OOOOOt gt 00008000 0000 808000880088088088008888 20000000080 0000 0808088000808808008088 01 0000 O OOOOH OOHHHHHHHHHHHHHHHHHHHHHHHHHHHHOHHHHHHHHHOHH88888E8 00000000001 99000 OOOHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHOHHHH88H8CO O OO OO OO OO O OB OO OO OS OO OS OOO SOOO HHO OHOH OOOO Owner s Manual Model EM529S In the box Emnerson WIRELESS HEADSET Owner s Manual gt Bluetooth Headset SML DDD Silicone cushions gt e USB charging cable a AC charger Earhook Stereo earphone Car Charger Drive Safe CAUTION Althoug
6. does not perform properly you may within one 1 year from your original date of purchase return it to the authorized service center for repair or exchange TO OBTAIN WARRANTY SERVICE e Provide proof of the date of purchase within the package Dated bill of sale e Prepay all shipping costs to the authorized service center and remember to insure your return e Include a return shipping address no P O Boxes a telephone contact number and the defective unit within the package e Describe the defect or reason you are returning the product Your product will be repaired or replaced at our option for the same or similar model of equal value if examination by the service center determines this product is defective Products received damaged as a result of shipping will require you to file a claim with the carrier The shipping address of the authorized service center is s Southern Telecom Inc ATTN Customer Service 2nd Floor 14 C 53rd Street Brooklyn NY 11232 Should you have any questions or problems concerning this product please contact our customer service department at Q 1 877 768 8483 Toll Free Monday Thursday 9AM 5PM EST Friday 9AM 3PM EST or via e mail at M cs southerntelecom com Warranty service not provided This warranty does not cover damage resulting from accident misuse abuse improper installation or operation lack of reasonable care and unauthorized modification This warranty
7. ference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures e Re orient or relocate the receiving antenna e Increase the separation between the equipment and receiver e Connect the equipment into an outlet on a circuit different from that to which the receiver is connected e Consult the dealer or an experienced radio TV technician for help Do not attempt to repair or modify this equipment Warning Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment Operation is subject to the following two conditions 1 This device may not cause interference and 2 This device must accept any interference including interference that may cause undesired operation of the device The term IC before the certification registration number only signifies that registration was performed based ona Declaration of Conformity indicating that Industry Canada technical specifications were met It does not imply that Industry Canada approved the equipment Limited Warranty In the unlikely event that this product is defective or
8. h this device enables drivers to conduct handsfree conversations it is still safer to pull over before using a mobile phone Always keep your full attention on your driving Driving while talking on your mobile phone is dangerous and illegal in many states Check local laws regarding the use of a mobile handset and wireless headset while driving If you use the Bluetooth Headset while driving ensure your attention and focus remains on your driving Please use your mobile phone and our product responsibly while driving Location of controls Power Switch Power ON OFF Green ON Red OFF Speaker Noise cancel Silicone cushion microphone 1 Call button Answer end a call Volume Up Indicator light Volume Down Charging socket Noise cancel microphone 2 Charging the headset NOTE Charge the headset for at least 8 hours beforeusing it for the first time even if the RED LED indicator shuts off 1 Connect the small end of the USB cable to the charging socket of the headset 2 Connect the other end of the USB cable to either the e AC Charger and plug into a wall A C outlet e Computer s USB port e Car Charger 3 The RED LED indicator light turns on while the headset is charging 4 The RED LED indicator light shuts off when the headset is fully charged approximately 2 3 hours NOTE When the battery is running low the RED LED indicator light starts to flash along with a warning
9. is voided in the event any unauthorized person opens alters or repairs this product All products being returned to the authorized service center for repair must be suitably packaged Limitation of Warranty e THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY APPLICABLE TO THIS PRODUCT ALL OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY DISCLAIMED NO VERBAL OR WRITTEN INFORMATION GIVEN BY SOUTHERN TELECOM INC IT S AGENTS OR EMPLOYEES SHALL CREATE A GUARANTY OR IN ANY WAY INCREASE THE SCOPE OF THIS WARRANTY e REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER SOUTHERN TELECOM INC SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT THIS DISCLAIMER OF WARRANTIES AND LIMITED WARRANTY ARE GOVERNED BY THE LAWS OF THE STATE OF NEW YORK EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO THE APPLICABLE WARRANTY PERIOD SET FORTH ABOVE Some states do not allow the exclusion nor limitation of incidental or consequential damages or limitations on how long an implied warranty lasts so the above limitations or exclusions may not apply to you This warranty gives you specific legal rights
10. n request NOTE The screenshots above are typical of many Bluetooth enabled phones in the market today and are used to assist in the explanation of the pairing process Your mobile phone s or Bluetooth enabled device s interface and interaction with the headset may be slightly different from the illustrations shown NOTE When the Power switch is set to the ON position for the first time the headset will be in Pairing Mode the indicator light will be flashing RED and BLUE alternately please refer to Easy Pairing Powering ON OFF To turn ON set the Power switch to the ON position green The blue indicator light will flash intermittently Power Switch Power ON Green Indicator light To turn OFF slide the Power switch to the OFF position red The indicator light will flash RED before the headset shuts off Power Switch Power OFF Red Indicator light Answering Ending a call e To answer a call press and release the Call button or press the answer key on your mobile phone e To end a call press and release the Call button or press the end key on your mobile phone Call button Answer end a call Rejecting a call During an incoming call press and HOLD the Call button for 3 seconds or until you hear a confirmation beep Making a call Dial the number and press the send button on your mobile phone the call is automatically transferred to the headset
11. one behind your neck and insert it into your other ear This headset allows you to listen in full stereo and control the music and video on your Bluetooth enabled mobile phone gaming console computer or mp3 player and supports the following Bluetooth profiles e A2DP Advanced Audio Distribution Profile e AVRCP Audio Video Remote Control Profile e HSP Headset Profile e HFP Handsfree Profile To use the headphones to listen to and control music and video your Bluetooth enabled device must support the A2DP and AVRCP profiles Please refer to the user guide of your Bluetooth enabled device for more information To enjoy music and video using your Bluetooth Headset press the Play button of your Bluetooth enabled device to begin music playback Once playback has begun you can control the music and videos or answer phone calls from the control buttons of the Bluetooth Headset Not all mobile phones support the control of music using Bluetooth Adjusting the volume Press the Volume Up or Volume Down button to adjust the volume to the desired level NOTE You may also adjust the volume from your mobile phone s volume control Play Pause music and video While the music or video is playing press the Call button to pause To resume playback press the Call button again Skipping or searching music or video While the music or video is playing press and HOLD the Volume Up button to go to the previous
12. ooth Enabled Paired Devices Select Device 7 Enter the passcode 0000 when prompted by the phone Bluetooth Enabled Paired Devices OOOO Enter numeric passkey for EM529 OR depending on which model mobile phone you are trying to connect the headset to it may not be necessary to enter a passcode and the following message or similar may appear on your phone s display Bluetooth Enabled Paired Devices EM529 would like to pair with your phone Would you like to allow it to pair Select Pair to complete the pairing process 8 Your mobile phone will confirm that the pairing process was completed and prompt you to accept the connection Please select YES to connect the headset to your mobile phone If the pairing was successful the headset s blue indicator light turns to standby mode and flashes once every three seconds Bluetooth Enabled Paired Devices Confirm connection to EM529 s 9 When attempting to reconnect the headset to your mobile phone you may see the message below and your mobile phone will prompt you to accept the connection request to the EM529 headset and an option not to ask this again Please accept the connection and if you select Don t ask this again your phone will automatically accept future connection requests from the headset Bluetooth Enabled Paired Devices from EM529 cE M Don t ask this again Accept connectio
13. song or press and HOLD the Volume Down button to go to the next song Answering a call while media is playing During an incoming call press the Call button to answer Press the Call button again to end the call and return to media playback Call button Play Pause Volume Up Press and HOLD Previous song gt Volume Down Ra Press and HOLD Next song Certain Bluetooth features including those listed may not be supported by all compatible Bluetooth enabled devices and or the functionality of such features may be limited in certain devices cannot get the headset into Pairing Mode e Make sure the headset is turned on before beginning the pairing process the headset is in pairing mode when you turn it on for the first time e If you are not pairing for the first time or for manual pairing press and HOLD the Call button until the indicator light flashes RED and BLUE alternately 2 My mobile phone cannot pair with the headset e Make sure that you fully charged the headset before pairing e Keep the headset and mobile phone within 3 feet of each other during the pairing process e Check that your phone s Bluetooth feature is turned ON e Try removing the battery from your mobile phone for 5 minutes Place the battery back in the phone power it on and retry the pairing process see Manual Pairing e Try repeating the pairing process see Manual pairing
Download Pdf Manuals
Related Search