Bose AM324443 Home Theater System User Manual
Contents
1. with batteries calibration headset Congratulations At this point you have set up the control console the Acoustimass module and the speakers You are now ready to turn on your system and enter the interactive phase of the setup process using the Unify intelligent integration system 12 IMPORTANT e Before you start make sure your speakers and Acoustimass module are in their final positions Do not connect any devices to the control console at this time The instructions provided on your TV will tell you when to do this 1 Slide the battery compartment cover off the back of the remote control AA IEC LR6 batteries 4 Battery compartment cover 2 Install four AA IEC LR6 batteries matching the polarity markings and to the markings inside the battery compartment 3 Slide the battery cover back into place Press the power button on the control console to turn on your system Because the system is in a low power state when in standby it takes several seconds to start When the power light changes from blinking to steady green your system is ready to use Power light O Turn on your TV Using the remote that came with your TV change the TV input to the one that is connected to your LIFESTYLE system Follow the instructions on your TV screen You will be prompted to do the following e Select your language Optimize the audio from your system using t2. Additional safety information See the additional instructions on the Important Safety Information sheet enclosed in the shipping carton Batteries Please dispose of used batteries properly following any Xx local regulations Do not incinerate Class B emissions This device complies with FCC and Industry Canada RF radiation exposure limits set forth for general population It must not be co located or be operating in conjunction with any other antennas or transmitters This product conforms to all EU Directive requirements as C applicable by law The complete Declaration of Conformity can be found at www Bose com compliance 2010 Bose Corporation No part of this work may be reproduced modified distributed or otherwise used without prior written permission SYSTEM SETUP Welcome Thank you for choosing a Bose LIFESTYLE system for your home This guide provides step by step instructions for setting up your new system There are two phases to the setup process Physical setup phase Placing the system components and connecting them together Interactive setup phase Completing your setup following the interactive steps on your TV screen provided by the Unify intelligent integration system Unpacking The parts of your new system are packaged in four numbered kits plus a small box containing the appropriate power cords 1 Control console kit A Acoustimass module kit E Speaker kit
3. H P 2H a 2 LIFESTYLE V35 V25 Home ENTERTAINMENT SYSTEMS LIFESTYLE T20 T10 Home THEATER SYSTEMS Setup Guide Gu a de instalaci n Guide d installation SAFETY INFORMATION Please read this guide Please take the time to follow the instructions in this guide carefully They will help you set up and use your system properly so you can enjoy its advanced features Please save this guide for future reference CAUTION AVIS RISK OF ELECTRICAL SHOCK RISQUE DE CHOC ELECTRIQUE DO NOT OPEN NE PAS OUVRIR ATTENTION POUR REDUIRE LE RISQUE DE DECHARGE ELECTRIQUE NE RETIREZ PAS LE COUVERCLE OU L ARRI RE IL NE SE TROUVE A L INT RIEUR AUCUNE PIECE POUVANT ETRE REPAREE PAR L USAGER S ADRESSER UN R PARATEUR COMP TENT CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED PERSONNEL The lightning flash with arrowhead symbol within an AN equilateral triangle alerts the user to the presence of uninsulated dangerous voltage within the system enclosure that may be of sufficient magnitude to constitute a risk of electric shock The exclamation point within an equilateral triangle alerts the user to the presence of important operating and maintenance instructions in this guide Edil e To reduce the risk of fire or electrical shock do not expose the product to rain or moisture Do not expose this apparatus to
4. such as an unrecognized device remote or a connection error you can reactivate the interactive setup mode at any time and correct or change part of your system setup See Using the Setup Mode in your system operating guide For help in trying to resolve any problems see the troubleshooting table in your system operating guide Contacting customer service For additional help in solving problems contact Bose Customer Service See the address sheet included in Kit 4 Applicable only for LIFESTYLE V25 and V35 home entertainment systems Made for iPod means that an electronic Madefor accessory has been designed to connect O iPo specifically to iPod and has been certified by the developer to meet Apple performance standards Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards iPod and iPhone are trademarks of Apple Inc registered in the U S and other countries All other marks are registered trademarks and trademarks of Bose Corporation 15 MABE Better sound through researche 2010 Bose Corporation The Mountain Framingham MA 01701 9168 USA AM324443 Rev 00 324443 0010
5. E Interactive kit e S Power cord kit used with kits 1 and 2 Starting with Kit 1 unpack each kit and set up its contents before unpacking the next one Be sure to save all of the packing materials These provide the safest means for any necessary shipping or transporting If any part appears damaged do not attempt to use it Notify Bose or your authorized Bose dealer immediately For Bose contact information refer to the address sheet included in Kit 4 SYSTEM SETUP Control console kit What you need for the following steps From Kit 1 Power supply S Audio input cable HDMI cable Control console From the Car power cord kit Power cord 1 Place the control console on a flat stable surface near your TV Control console Note Until your system is completely installed it may be helpful to keep the control console positioned for easy access to its rear connection panel SNQUusn SYSTEM SETUP 2 Plug one end of the HDMI cable into an HDMI INPUT connector on your TV If an HDMI cable is already connected to an HDMI input on your TV you can use this one Just disconnect the other end Plug the other end of the HDMI cable you are using into the connector labeled HDMI OUT Video to TV on the control console HDMI OUT Video to TV SYSTEM SETUP 4 Plug one end of the audio input cable into the Acoustimass Module connector on the control con
6. dripping or splashing and do not place objects filled with liquids such as vases on or near the apparatus As with any electronic products use care not to spill liquids into any part of the system Liquids can cause a failure and or a fire hazard Do not place any naked flame sources such as lighted candles on or near the apparatus Keep the remote control battery away from children It may cause a fire or chemical burn if mishandled Do not recharge disassemble heat above 100 C 212 F or incinerate Dispose of used batteries promptly Replace only with a battery of the correct type and model number Contains small parts that may be a choking hazard Not suitable for children under age 3 CANTONS e Make no modifications to the system or accessories Unauthorized alterations may compromise safety regulatory compliance and system performance and may void the warranty Long term exposure to loud music may cause hearing damage It is best to avoid extreme volume when using headphones especially for extended periods Notes Where the mains plug or appliance coupler is used as the discon nect device such disconnect device shall remain readily operable The product must be used indoors It is neither designed nor tested for use outdoors in recreation vehicles or on boats This product is intended to be used only with the power supply provided The product label is located on the bottom of the product
7. personal preference If placing the speakers in an enclosed bookcase shelf position them at the front edge of the shelf If you have Jewel Cube or Direct Reflecting cube speakers rotate the cubes so that one cube of each speaker points forward into the room and the other points at a side wall to create reflected sound SYSTEM SETUP 3 Place the rear speakers toward the back of the 4 Locate the colored connectors on the bottom panel room behind the viewers at ear height when of the Acoustimass module seated or higher if possible Colored connectors Left rear LR 5 Plug the speaker cables into the Acoustimass module connectors Be sure to match each cable plug to each connector by the color code Make sure the 50 ft 15 2 m rear speaker cables will reach from the speakers to the Acoustimass module Aim the speakers away from the listeners to pre vent them from pinpointing the exact location of the sound source If you have Jewel Cube or Direct Reflecting cube speakers rotate the cubes so that one cube of each speaker points forward into the room and the other points at a side wall to create reflected sound 5 SYSTEM SETUP 6 Locate the speaker position markings on the free 7 Using the speaker position markings run each ends of the speaker cables cable out to its respective speaker as in the following setup example of a room e FRONT SPEAKERS Speaker posi
8. he ADAPTiQ audio calibration system e Connect audio video devices to the control console Configure your Bose remote to control your connected devices SYSTEM SETUP Other Kit 4 items The remaining items in Kit 4 may or may not be required to set up your LIFESTYLE system For more information on using these accessories or adding other devices to your system at another time see the operating guide wx IR emitter cable Stereo audio cable AM antenna E gt FM antenna Rubber feet Rubber feet for Acoustimass for front center module speaker iPod iPhone Operating guide USB flash drive compatible for system dock updating only For LIFESTYLE V25 and V35 systems only 13 SYSTEM SETUP Applying rubber feet When placing the Acoustimass module on bare floors you can attach the included rubber feet to the bottom of the module for greater stability and to protect your floor Rubber feet for Acoustimass module Bottom panel Vibration can cause speakers to move particularly if placed on a smooth surface like glass or highly polished wood If you are placing the center speaker on such a surface you can attach the included rubber feet to the bottom of the speaker for greater stability gt o o Rubber feet Bottom panel for of center front center speaker speaker 14 If you have setup problems If you experience any difficulties during the setup process
9. sole Make sure the flat surface with the arrow on the plug faces up Leave the other end of the cable on the floor You will be asked to connect it while setting up the next kit pnt Acoustimass Module 5 Plug the power supply output cord into the control console Power connector Power supply output cord supply Remove a power cord from the power cord kit Plug one end of the power cord into the power supply Make sure you push the plug in as far as it can go Plug the other end of the power cord into a live AC mains power outlet Continue with Kit E on the next page SYSTEM SETUP 1 Place the Acoustimass module on the floor at the same end of the room as the TV Make sure there is a live AC outlet nearby Acoustimass module kit What you need for the following steps From Kit 2 Acoustimass module N Lay the module on its side and locate the connector panel Acoustimass module From the Cm power cord kit Connector panel Power cord SYSTEM SETUP 4 CAUTION DO NOT stand the Acoustimass module on its front or back end 5 3 Plug the free end of the audio input cable into the Media Center connector on the Acoustimass module Make sure the flat surface with the arrow faces the front of the module Media Center 6 7 Remove a power cord from the power cord kit Plug one end of the power cord into the AC Power connector on the Acou
10. stimass module Make sure you push the plug in as far as it can go AC Power Plug the other end of the power cord into a live AC mains power outlet Continue with Kit E on the next page SYSTEM SETUP Speaker kit What you need for the following steps From Kit 3 System speakers one set of the three types shown Jewel Cube speakers 4 Leftor right front 1 Center front speaker x rear speaker Direct Reflecting cube speaker arrays 4 Left or right front 1 Center front speaker or rear speaker Virtually Invisible single cube speakers 5 Left or right front or rear and center front speaker Front speaker cables Left front L Center front C Right front R White Brown Light blue Rear speaker cables Left rear LR Right rear RR Light green Purple Note You can place system speakers on wall brackets or floor stands To purchase these accessories contact your local Bose dealer or visit www Bose com SYSTEM SETUP Place the center front speaker on a stable and level surface directly above or below the center of your TV screen as in the following example Left front L Right front R Center front C Place one speaker to the left and one to the right of the TV Keep each speaker within 3 ft 1 m of the TV Screen to prevent too much separation of the sound from the picture Vary this distance to suit your room conditions and
11. tion marking L C R LR or RR e REAR 4 SPEAKERS 10 SYSTEM SETUP 8 Connect the speaker cable to the type of speaker you have For Jewel Cube speakers Insert the plug into the speaker connector For Direct Reflecting and Virtually Invisible single cube speakers Press the button and insert the wires Connect the red collared wire to the red connector Connect the other wire to the black connector Note The rear speaker cables for Direct Reflecting and Virtually Invisible cube speakers are webbed together You can pull them apart as needed Put the Acoustimass module in its final position Upright BEST or on either side ALTERNATE BEST ALTERNATE With the front opening facing into the room At least 18 in 45 cm from any TV to avoid magnetic interference with the TV image Move it farther away if you still notice interference CAUTION Do not put electronic media such as video or audio tapes on or next to the module for long periods of time The magnetic field surrounding the module may erase some or all of the recorded material CAUTION DO NOT BLOCK the ventilation openings on the module This can cause it to overheat 10 Continue with Kit E on the next page 11 SYSTEM SETUP Interactive kit What you need for the following steps From Kit4 Ro Remote control ADAPTIQ audio
Download Pdf Manuals
Related Search