IPC-601-SCA
Contents
1. IPC 601 SCA 1U e Server Chassis Copyright Notice This document is copyrighted November 2000 by Advantech Co Ltd All rights are reserved Advantech Co Ltd reserves the right to make improvements to the products described in this manual at any time without notice No part of this manual may be reproduced copied translated or transmitted in any form or by any means without the prior written permission of Advantech Co Ltd Information provided in this manual is intended to be accurate and reliable However Advantech Co Ltd assumes no responsibility for its use nor for any infringe ments of the right of third parties which may result from such use Acknowledgments IPC 601 and PCA 6102P1V are trademarks of Advantech Co Ltd Note The information in this document is provided for reference only Advantech does not assume any liability arising out of the direct or indirect use of the information or products described herein This manual is subject to change without notice Part No 2002060100 1st Edition Printed in Taiwan Nov 2000 Contents Chapter 1 Introduction 1 1 Introdu ction esssessressssscesssssssscsnnunnesserssssssnninsennee 1 2 Specifications ersessesssssussesnnssssnesussnsnnsnnsnnssnsnnnanee 1 3 Dimensions cs00sscosseensnesonsssensneensnessnsnsensneensnee Chapter 2 System Setup 2 1 Removing the Cover eere2. 2 1 Removing the Cover 1 Unscrew the screws at the rear side of the upper cover 2 Slide the upper cover backwards 3 Lift up the upper cover Please refer to the Figure 2 1 below for illustration Figure 2 1 Upper cover removing 6 IPC 601 SCA User s Manual 2 2 Installing CPU and Add on Cards The IPC 601 SCA supports one PICMG full sized CPU card and one PCI add on card In order to install the CPU card and add on card we suggest to take out the tray from the chassis and install the cards in the tray ouside the chassis Figure 2 2 illustrates the installation of the CPU and add on cards Note Please notice that the SDRAM modules used on the CPU card have height constraints The recommended height is no more than 31 mm Please contact Advantech for recommended vendors S X nd FA A By i ex MAN Chapter 2 System Setup 7 Figure 2 2 Installing plug in cards 2 3 Replacing the Fan 2 4 The IPC 601 SCA provides three hot swap fans There is no screws on the fans and it is easy to replace the fans Adding Disk Drives 8 The IPC 601 SCA supports three hard disk drives one slim type CD ROM which is set in the master mode only and one slim type floppy disk drive The IPC 601 SCA provides one SCA 2 backplane and supports three hot swap hard disk drives Please notice that if the hard disk drives used in the
3. IPC 601 SCA shall be 3 5 1 height SCSI hard disk drives with 80 pin SCA 2 connecotrs In order to install the hard disk drives in the chassis please follow the following procedures 1 Unfasten the dummy HDD trays from the hard disk racks 2 Put hard disk drives in the hard disk racks and fasten them with screws 3 Slide the hard disk racks into the drive bay Figure 2 3 Installing a hard disk drive in the hard disk rack IPC 601 SCA User s Manual Figure 2 5 Opening the hard drive bay Chapter 2 System Setup 9 Figure 2 6 Hard drive bay fully open Figure 2 7 Putting the hard drives into the hard drive bays 10 IPC 601 SCA User s Manual Figure 2 7 Closing the latches Chapter 2 System Setup 11 12 IPC 601 SCA User s Manual Appendix A Passive Backplane PCA 6102P1V 2 ISA 3 PCI 1 CPU slots Dimensions 313 x 38 mm 313 mm PICMG Slot 38 mm CN4 CN3 CN2 CN1 J5 J4 JP1 CN5 ATX PCI Slot Unit mm inches Fan 2 connector Fan 3 connector CN2 CN4 Fan 4 connector EnabE D isabk ATX power function PClepensbn sbe PIMG sbt PICMG fullszed CPU card IPC 601 SCA User s Manual 13 14 IPC 601 SCA User s M
4. anual Appendix B Alarm Board 55 mm gt CN CN CN10 1 CN8 2 155 mm JP10 JP12 IPC 601 SCA User s Manual 15 16 IPC 601 SCA User s Manual Appendix C SCA 2 Backplane CN4 CN3 CN1 CN2 CN5 s 8 CN7 IPC 601 SCA 2 Backplane Connector Description SCSIHDD active indicator 68 pin SCSI connector to host power connector power connector SCA 2 SCSI HDD connector ID3 SCA 2 SCSI HDD connector ID1 SCA 2 SCSI HDD connector ID2 Appendix A Diagrams 17 18 IPC 601 SCA User s Manual Appendix D Exploded Diagram IPC 601 SCA User s Manual 19 e panno DT s wee psum s uses smcosoweoo Moe s esses rada fo forms 20 IPC 601 SCA User s Manual Appendix E Safety Instructions E 1 English 1 2 3 10 11 12 13 14 15 Read these safety instructions carefully Keep this user s manual for later reference Disconnect this equipment from any AC outlet before cleaning Do not use liquid or spray deter gents for cleaning Use a damp cloth For pluggable equipment the power outlet must be installed near the equipment and be easily accessible Keep this equipment
5. away from humidity Put this equipment on a reliable surface during installation Dropping it or letting it fall could cause damage The openings on the enclosure are for air convection Protect the equipment from overheating DO NOT COVER THE OPENINGS Make sure the voltage of the power source is correct before connecting the equipment to the power outlet Position the power cord so that people cannot step on it Do not place anything over the power cord All cautions and warnings on the equipment should be noted If the equipment is not used for a long time disconnect it from the power source to avoid damage by transient overvoltage Never pour any liquid into an opening This could cause fire or electrical shock Never open the equipment For safety reasons the equipment should be opened only by qualified service personnel If any of the following situations arises get the equipment checked by service personnel a The power cord or plug is damaged b Liquid has penetrated into the equipment c The equipment has been exposed to moisture d The equipment does not work well or you cannot get it to work according to the installation reference guide e The equipment has been dropped and damaged f The equipment has obvious signs of breakage DO NOT LEAVE THIS EQUIPMENT IN AN UNCONTROLLED ENVIRONMENT WHERE THE STORAGE TEMPERATURE IS BELOW 20 C 4 F OR ABOVE 60 C 140 F THIS MAY DAMAGE THE EQUIPMENT The s
6. d alarm reset switch on front panel Cooling fan Three 7 CFM cooling fans 21 CFM in total Weight 8 kg 17 6 Ibs Dimensions W x D x H 482 x 610 x 44 mm 19 x 24 x 1 7 Interior paint color Black 2U 2X Fabric Texture Passive backplane PCA 6102P1V Slots One PICMG slot for full sized CPU card and one PCI slot for expansion PC board 4 layer PCB with ground and power planes for reduced noise and low power supply impedance Dimensions 313 x 38 mm 12 3 x 1 5 IPC 601 SCA User s Manual Power supply Output rating 320 watts max Input rating 115 230 V 50 60 Hz auto switch Output voltage 3 3 V 20 A 5 V 9 32A 12 V 12A 5V 0 5 A 12 V 0 5 A 5 Vsb 92A Minimum load 5 V 1 0A MTBF 50 000 Hours amp 70 load Safety UL CUL CE Environmental specifications Operating temperature 0 45 C 32 113 F Relative humidity 10 95 40 C non condensing e Safety UL CE approved CE compliant Chapter 1 Introduction 1 3 Dimensions Unit mm 482 6 z e i O 44 2 et Figure 1 1 IPC 601 SCA dimensions IPC 601 SCA User s Manual CHAPTER System Setup The following procedures are provided to assist you in setting up the IPC 601 SCA Chapter 2 System Setup 5
7. eereneseeseoneszenecnee 6 2 2 Installing CPU and Add on Cards 2 3 Replacing the Fan sssssssssossosssssssonsnnssnssossosnone 2 4 Adding Disk Drives eese Appendix A Passive Backplane Appendix B Alarm Board Appendix C SCA 2 Backplane Appendix D Exploded Diagram Appendix E Safety Instructions E English esee esee rece nin neenon tns tn enata snae E2 German Wichtige Sicherheishinweise CHAPTER Introduction This chapter gives background informa tion on the IPC 601 SCA Sections include Introduction Specifications Dimensions 1 1 Introduction 1 2 The IPC 601 SCA is a 1U high rack mount e Server chassis for high density internet services Engineered for service providers and enterpirses the IPC 601 SCA s rack mount 1U form factor is best for stacking servers as services grow The IPC 601 SCA is designed to accommodate PICMG passive backplane and full sized CPU card configurations to provide flexibility with high reliability With various CPU cards configuration options the IPC 601 SCA provides flexibility and high performance at the same time Specifications 2 Construction Heavy duty steel Disk drive capacity Three optional hot swap hard disc drive space and one slim type CD ROM disk drive and one slim type floppy disk drive Indicators LEDs for power On Off HDD and alarm Controls Momentary power switch an
8. ound pressure level at the operator s position according to IEC 704 1 1982 is equal to or less than 70 dB A DISCLAIMER This set of instructions is given according to IEC 704 1 Advantech disclaims all responsibility for the accuracy of any statements contained herein IPC 601 SCA User s Manual 21 E 2 German Wichtige Sicherheishinweise 22 10 11 12 13 14 15 Bitte lesen Sie Sich diese Hinweise sorgf ltig durch Heben Sie diese Anleitung f r den sp teren Gebrauch auf Vor jedem Reinigen ist das Ger t vom Stromnetz zu trennen Verwenden Sie Keine Fl ssig oder Aerosolreiniger Am besten dient ein angefeuchtetes Tuch zur Reinigung Die Netzanschlu steckdose soll nahe dem Ger t angebracht und leicht zug nglich sein Das Ger t ist vor Feuchtigkeit zu sch tzen Bei der Aufstellung des Ger tes ist auf sicheren Stand zu achten Ein Kippen oder Fallen k nnte Verletzungen hervorrufen Die Bel ftungs ffnungen dienen zur Luftzirkulation die das Ger t vor berhitzung sch tzt Sorgen Sie daf r da diese ffnungen nicht abgedeckt werden Beachten Sie beim Anschlu an das Stromnetz die Anschlu werte Verlegen Sie die Netzanschlu leitung so da niemand dar ber fallen Kann Es sollte auch nichts auf der Leitung abgestellt werden Alle Hinweise und Warnungen die sich am Ger ten befinden sind zu beachten Wird das Ger t ber einen l ngeren Zeitraum nicht benutzt sollten Sie es vom Stromnetz
9. trennen Somit wird im Falle einer berspannung eine Besch digung vermieden Durch die L ftungs ffnungen d rfen niemals Gegenst nde oder Fl ssigkeiten in das Ger t gelangen Dies k nnte einen Brand bzw elektrischen Schlag ausl sen ffnen Sie niemals das Ger t Das Ger t darf aus Gr nden der elektrischen Sicherheit nur von authorisiertem Servicepersonal ge ffnet werden Wenn folgende Situationen auftreten ist das Ger t vom Stromnetz zu trennen und von einer qualifizierten Servicestelle zu berpr fen a Netzkabel oder Netzstecker sind besch digt b Fl ssigkeit ist in das Ger t eingedrungen c Das Ger t war Feuchtigkeit ausgesetzt d Wenn das Ger t nicht der Bedienungsanleitung entsprechend funktioniert oder Sie mit Hilfe dieser Anleitung keine Verbesserung erzielen e Das Ger t ist gefallen und oder das Geh use ist besch digt f Wenn das Ger t deutliche Anzeichen eines Defektes aufweist Bitte lassen Sie das Ger t nicht unbehehrt hinten unter 20 C 4 F oder oben 60 C 140 F weil diesen Temperaturen das Ger t zerst ren k nten Der arbeitsplatzbezogene Schalldruckpegel nach DIN 45 635 Teil 1000 betr gt 70dB A oder weiger DISCLAIMER This set of instructions is provided according to IEC704 1 Advantech disclaims all responsibility for the accuracy of any statements contained herein IPC 601 SCA User s Manual
Download Pdf Manuals
Related Search
IPC 601 SCA