USER MANUAL
Contents
1. 00 FT make sure that there is no evident damage caused by transportation In the event that the unit s housing or cable is damaged do not plug it in and do not attempt to use it until after contacting your ROBE distributor for assistance 4 Setup Remove all packing materials from shipping box Check that all foam and plastic padding is removed Place machine ona at surface and remove hazer liquid tank cap Note the maximum liquid level mark located on the rear of the hazer Pour hazer liquid into the liquid tank being careful not to exceed the maximum liquid level DO NOT OVER FILL Use only ROBE hazer liquid or other dealer recommended high quality hazer liquid Any other types of liquid can damage the unit When liquid level reaches the fill line place cap back on liquid tank Your hazer may be operated with or without a remote controller If you will be controlling your unit remotely firmly attach the remote control cable to the proper input 5 Operation Plug power cord into a grounded electrical outlet To operate without remote control simply turn hazer on Haze emission will begin automatically To operate via remote control press the appropriate button on the remote to begin haze emission For further information on operating your Haze 400 FT see the section titled Remote Control Operation If your model includes a mounting bracket designed for overhead installation it may be installed at oor level or suspended overhea2. azer liquid gets inside the housing imme diately unplug the unit and contact a service technician or your ROBE distributor before using it again No user serviceable parts inside Refer to your ROBE distributor or other qualified service personnel For adult use only Hazer must be installed out of the reach of children Never leave the unit running unat tended Never aim the output at open ames Danger of explosion Never add ammable liquids of any kind oil gas perfume to the hazer liquid Pay attention to all warning labels and instructions printed on the exterior of your Haze 400 FT Use only the high quality hazer liquid that your dealer recommends Always make sure there is sufficient liquid in the hazer liquid tank Operating this unit without liquid may cause permanent damage to the machine If your Haze 400 FT fails to work properly discontinue use immediately Drain all hazer liquid from the tank pack the unit securely preferably in the original packing material and return it to your ROBE distributor for service Never drink hazer liquid If it is ingested call a doctor immediately If hazer liquid comes in contact with skin or eyes rinse thoroughly with water 3 Unpacking amp Inspection Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact If any equipment is missing contact your ROBE distributor immediately Before beginning initial setup of your Haze 4
3. d If the unit is to be mounted using the bracket avoid suspending the unit such that haze is emitted directly toward any one s face Whatever installation method you choose do not allow the unit to have more than a 15 degree angle of inclination Important Always monitor tank liquid level during operation Running a hazer with no liquid can permanently damage the unit If you experience low output mechanical noise or no output at all unplug immediately Check liquid level the external fuse remote connection and power from the wall If all of the above appears to be O K plug the unit in again If hazer does not function after 30 seconds discontinue operation or permanent damage to the unit may result Return the machine to your ROBE distributor Always drain tank before mailing or transporting this unit 6 Remote Control Operation Haze 400 FT uses 10 meter wired multi function remote controller with 14 stereo plug Press the red POWER button to activate the remote control Press the yellow TIMERS button to activate the timer function Adjust the interval between each haze emission within the range of 10 seconds to 5 minutes by means of the INTER VAL control knob Adjust the duration of each haze emission within the range of 1 to 90 seconds by means of the DURATION control knob When pressed the green MANUAL button activates the hazer overriding all other function controls 7 DMX Operation The Haze 400 FT has onboar
4. d DMX control Currently it uses 1 channel to control output operation The DMX channel is set on the back panel of the Haze 400 FT by setting the dip switches to the desired channel Examples DMX Address 3 DMX Address 24 If Channel has a value from 0 to 5 the unit is OFF Between the values 6 to 255 the Haze 400 FT produces haze Haze 400 FT Liquid Use only original liquid recommended by ROBE distributor Do not allow the liquid to become contaminated Always replace the caps on the hazer liquid container and the hazer s liquid tank immediately after filling 8 Technical specifications Power supply Power consumption 600 VA Voltage ennn 230V 240V 50 60 Hz or 100V 120V 50 60Hz optionally Tank capacity 2 5 Liter Output 2 800 Cu ft Min Liquid used Premium Haze Dimensions 500 x 320 x 2460 mm Weight 18 5 kg 9 Maintenance and cleaning Clean with a dry cloth only Store dry Cleaning your fog machine regularly will help reduce costly parts replacement and repair charges DANGER Disconnect from the mains before starting any maintenance work More complicated maintenance and service operations are only to be carried out by authorized dealers Replacing the fuse Before replacing the fuse unplug mains lead Replace the fuse by a fuse of the same type and rating January 31 2011 Specifications are subject to change without specification
5. nera 400 USER MANUAL FTse ries Version 1 2 ROBE Lighting s r o e Czech Republic e www robe cz We keza 4o00 Table of contents 1 Introduction 2 Cautions 3 Unpacking amp Inspection 4 Setup 5 Operation 6 Remote Control Operation 7 DMX Operation 8 Technical specifications 9 Maintenance and cleaning D Oo Dm mm D PS E 1 Introduction Thank you for choosing an ROBE Haze 400 FT You now own a rugged and powerful state of the art machine Prior to use we suggest that you carefully read all of the instructions By following the suggestions found in this user manual you can look forward to the reliable and satisfactory performance of your ROBE Haze 400 FT for years to come Please follow these operation and safety instructions to ensure a long and safe life for your Haze 400 FT 2 Cautions Do not overfill your Haze 400 FT Overfilling will cause the unit to clog Danger of electric shock Disconnect the appliance from the electric supply before removing the cover Keep this device dry For inside use only Not designed for outside use For the 120 V models use 3 prong grounded electrical outlet only Prior to use take care to determine that the unit is installed at the rated voltage Always unplug your Haze 400 FT before filling its tank Keep hazer upright Turn off or unplug when not in use This machine is not water or splash proof If moisture water or h
Download Pdf Manuals
Related Search