Installation Instructions
Contents
1. LIGHTED WALL MOUNTED MIRROR INSTRUCTION SHEET Q2505HW 92515HW 92525HW 92535HW 92545HW 92555HW 92565HW 92575HW 92585HW 92595HW 925135HW OPERATING INSTRUCTIONS 1 Turn switch to the OFF position Plug cord into any standard 120 volt wall outlet Turn switch to the ON position 2 Lighted mirror will rotate so that you can use either the normal flat mirror or 5X magnifying mirror located on the opposite side 3 After use always turn switch to the OFF position 4 Unplug it from outlet when not in use IMPORTANT SAFETY INSTRUCTIONS THIS APPLIANCE IS INTENDED FOR HOUSEHOLD USE WHEN USING ELECTRICAL APPLIANCES BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOL LOWED INCLUDING THE FOLLOWING WARNING To reduce the risk of burns electrocution fire or injury to persons 1 Read all instructions before using the appliance and keep them for later reference 2 To protect against electrical hazards do not use while bathing or in the shower and do not touch plug or switch with wet hands 3 To reduce the risk of burns 3 1 Avoid swivel the makeup mirror into horizontal position when turn switch to ON 3 2 Do not touch the housing especially the top half and mirrors when turn on the switch or off within 10 minutes 4 Repairs and service should always be carried out by an authorized service center Do not use the appliance if it is damaged or if the cable is damaged Instead send it toa service departme2. al Dim 227mm W x 300mm H Letter height at less 1 6mm
3. not light until you are certain mirror is completely dry to protect against electrical hazards This device complies with part 15 of the FCC Rules Opera tion is subject to the following two conditions 1 This device may not cause harmful interference and 2 this device must accept any interference received includ ing interference that may cause undesired operation NOTE This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interfer ence to radio or television reception which can be deter mined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help The
4. nt 5 Be sure mirror is not in a position where it can reflect sunlight reflected sunlight can cause fire 6 After use always pull the plug from the socket 7 Handle cord carefully for longer life do not jerk or strain at plug connections or wrap cord around mirror for storage This could cause damage to the cord and short circuit To store mirror coil cord loosely 8 Use only the original accessories supplied 9 Allow the light bulb in the mirror time to cool down before storing it away 10 Do not lay a switched appliance on soft furnishings such as a bed cushion etc This will prevent over heating 11 Instruct young children about the dangers and safety rules concerning electrical equipment 12 Never let young children use electrical equipment without supervision 13 Turn switch to OFF position and unplug cord before replacing light bulbs 14 Do not place hang or store appliance where it can fall or be pulled into a tub or sink 15 If an appliance falls into water unplug it immediately Do not reach into the water 16 Never use while sleeping 17 Do not place in or drop into water or other liquid TROUBLE SHOOTING If there is still no light unplug the lighted mirror and call the manufacturer CLEANING AND MAINTENANCE Always unplug lighted mirror first Clean the outside of appliance with a damp cloth Never immerse it in water or any other liquid Clean mirror surfaces with a glass cleaner Do
5. users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment Please turn over Front 23Aug 11 INSTALLATION INSTRUCTIONS 1 Aptations Inc recommends using a qualified electrician for all electrical wiring procedures and installations 6 Connect the electrical wires coming from the electrical box to the terminal connections Tighten the set screws 2 A standard 120 Volts AC electrical box must be installed at the desired location of the wall before continuing Wire references are 3 Remove the mounting screws on both sides of the mirrors base L Live wire Line Phase Black wire N Neutral White wire Ground Green Yellow wire lt LIVE WIRE LINE PHASE NEUTRAL 4 Remove the mounting plate from the base GROUND Mounting 7 Finish installing mirror by mounting base of mirror over the Plate base plate that is attached to the electrical box 8 Fasten the mounting screws on both sides of the base Ground wire Mirror Base 5 Secure the mounting plate to the electrical box on the wall with four 4 wall anchors and mounting screws 9 Put mirror at desired position and turn black rocker switch on for use 925X5SHW Eng Back User Manu
Download Pdf Manuals
Related Search