AlcoBlow - Lion Laboratories
Contents
1. U lt re I E CD EN AlcoBlow User Handbook RM42053 Revision 2 3 June 2013 wie User Handbook GB Unit and Controls ON OFF Switch STATUS Light Sample Cone PASSIVE Switch DISPLAY Light Battery Cap User Handbook gt Er Contents 2 1 2 2 2 3 3 1 3 2 3 3 3 4 3 5 3 6 3 7 4 1 4 2 4 3 SAFETY INFORMATION USEFUL INFORMATION Items supplied and packaging Useful information on taking a breath sample with the AlcoBlow Taking a breath sample reading quickly and accurately OPERATION Getting started Switching On and Off Mode of Operation Active Mode Testing Passive Mode Testing Checking a Container Display Light Indications MISCELLANEOUS Cleaning and Maintenance Disposal Technical Specification WARRANTY GB ie ae User Handbook GB BA IMPORTANT INFORMATION RETAIN FOR FUTURE USE Read the instruction manual carefully before using this device especially the safety instructions and keep the instruction manual for future use Should you give this device to another person it is vital that you also pass on these instructions for use Explanation of symbols This instruction manual belongs to this BA device It contains important information about starting up and operation Read the instruction manual thoroughly Non observance of these instructions can result in serious injury or damage to the device WARNING These2. will turn GREEN Hold the device with the sample cone 2 5cm 1in directly in front of the subject s mouth or nose While the subject is breathing out or perhaps talking press the PASSIVE button wait for the device to take a sample before removing the device from in front of the subject Read the result from the DISPLAY light If the light was GREEN you may wish to repeat the procedure in case a useful sample was not taken A further test can be performed once the STATUS light turns GREEN eye a User Handbook GB 3 6 Checking a Container The device can be used as an electronic nose to check a container to see if it contains alcohol CAUTION It is very important that the device only samples the vapours from the test liquid inside the container The device must not contact any fluids directly this could damage the device e Hold the device with the sample cone fairly close to the liquid to be tested and preferably in a relatively sealed environment e Press the PASSIVE button wait for the device to take a sample before removing the device from the container e Note the indicated alcohol reading on the DISPLAY light e A further test can be performed once the STATUS light turns GREEN NOTES if the DISPLAY light shows AMBER or I RED then the liquid contains alcohol to some degree If the reading is GREEN then repeat the test at least twice to be sure the sample wa
3. is kept away from the reach of children Risk of suffocation ae User Handbook GB 2 2 Useful information on taking a breath sample with the AlcoBlow When the subject blows into the sample cone the flow rate is monitored against time Once the minimum conditions of flow and time are satisfied a small sample of breath is taken from the sample cone and passed to the sensor 2 3 Taking a breath sample reading quickly and accurately The Lion AlcoBlow allows contact free indication of alcohol in a breath sample The sample is taken from a distance of 2 5cm the person blowing straight into the sample cone hard enough to trigger the audible flow alarm and long enough for the Status indicator to go RED The alcohol in the sample is analysed and the presence of alcohol indicated on the display LED within 5 seconds This allows for its use where many people have to be tested quickly for the presence of alcohol Additional function Apart from indicating whether alcohol is present in a person s breath the AlcoBlow can also be used to check containers such as bottles cans or glasses for the presence of alcohol 3 OPERATION 3 1 Getting started Removing Inserting batteries The AlcoBlow requires the batteries provided to be fitted prior to first use After a period of use if the Battery Low Indication appears flashing Status and Display Lights you must replace them with four new 1 5V batteries LRO6 AA Rem
4. warning notes must be observed to prevent any injury to the user CAUTION These notes must be observed to prevent any damage to the device NOTE These notes give you useful additional information on the installation or operation Manufacturer Date of manufacture AEE gt p Symbol indicating separate collection of EEE 4 ae User Handbook GB AAT 1 SAFETY INFORMATION Only use the device for the specific purpose described in the user manual Any misuse will void the warranty The device is not designed to be used by persons including children with limited physical sensory or mental abilities or by persons with insufficient experience and or knowledge unless under observation by a person responsible for their safety or unless they have been instructed in the use of the device If a fault occurs or the device is damaged do not attempt to repair the device yourself as this will void the warranty Contact your dealer and only have repairs carried out by authorised service partners Do not move the device away from in front of the subject until the sample is taken or else fresh air may be mixed with the sample taken and reduce the reading Do not let the subject blow smoke into the device Do not hold the device at an angle to the subject hold it straight on Do not let the subject blow very hard into the device this could damage the flow sensor Do not use the device if it is damaged Do not o
5. 00 g including batteries The CE mark of this device refers to the EC directive 93 42 EEC MDD This device is designed for domestic use law enforcement industrial safety applications and medical applications For commercial use a metrological inspection and service must be carried out once a year This calibration will be charged for and carried out manufacturer by your local dealer or the ee User Handbook GB Electromagnetic Compatibility The device complies with EN 60601 1 2 standard for electromagnetic compatibility Inquire at Lion Laboratories Ltd for details In accordance with our policy of continual product development we reserve the right to make technical changes without notice 5 WARRANTY Please contact your dealer in case of a claim under the warranty If you have to return the device please enclose a copy of your invoice and state what the defect is ki Lion Laboratories Limited Ty Verlon Industrial Estate Barry Vale of Glamorgan CF63 2BE Wales UK Tel 44 0 1446 724500 Fax 44 0 1446 724501 E mail info lionlaboratories com sales lionlaboratories com Web www lionlaboratories com Please visit the link below for details of your local dealer www lionlaboratories com international distributors 16
6. ORMATION Continued Keep unused batteries in their packaging away from metal objects in order to prevent short circuiting Do not throw used batteries into the household refuse put them in a hazardous waste container or take them to a battery collection point at the shop where they were purchased 3 2 Switching On and Off Switch On Press the ON OFF button down for 1 second NOTE i During Switch On the device will run diagnostic checks assuring functions operate correctly Switch Off Press the ON OFF button down for 1 second at any point during the operation of the device Automatic Switch Off The device switches off automatically 2 minutes after the last operation Both indicator lights flash and the alarm sounds to indicate the shutdown process is taking place 3 3 Mode of Operation Active Mode The subject blows into the sample cone and a sample is taken automatically for analysis ee ED User Handbook GB Passive Mode For use when the subject is unable to provide a sufficient sample for automatic sampling e g an unconscious patient or for testing the contents of a container i NOTE During the sample process do not move the device away from the subject until the sample has been taken This avoids allowing fresh air diluting the sample 3 4 Active Mode Testing This mode requires the subject to blow Actively into the device It is the most accurate method of oper
7. ation Switch on the device using the ON OFF button O Once diagnostics are complete the STATUS light will turn GREEN Hold the device with the sample cone 2 5cm 1in directly in front of the subject s mouth Tell the subject to blow directly into the sample cone moderately hard and continuously The STATUS light will turn AMBER if the subject is blowing hard enough Once a correct sample is taken the STATUS light will turn RED and an audible alarm double beep will indicate the subject can stop blowing Within 5 seconds the result will be displayed on the DISPLAY light the colour of the light indicating the level of alcohol in the breath sample The displayed result is accompanied by an audible alarm giving an audible indication of the result See 3 7 ae User Handbook GB i The device will reset the DISPLAY light after 2 seconds A further test can be performed once the STATUS light turns GREEN NOTE When the device is in regular use particularly at low ambient temperatures it is advisable to use a paper tissue to clean any breath condensates from the sample cone 3 5 Passive Mode Testing This mode of operation is used where the subject is unable or unwilling to blow into the device This method of sampling will not always produce as reliable a reading as that given by Active testing Switch on the device using the ON OFF button O Once diagnostics are complete the STATUS light
8. oval Turn the battery cap 90 anticlockwise and take the cap off Take out the batteries 7 gt aU a User Handbook GB Insertion Put in four new 1 5V batteries LRO6 AA Make sure the batteries are the right way around see the diagram on the rear label Put the battery cap back on lining the lugs on the case up with the gaps in the cap and turning the cap 90 clockwise WARNING BATTERY SAFETY INFORMATION Do not disassemble batteries Clean the battery and device contacts if necessary before putting in the batteries Remove discharged batteries from the device immediately Increased risk of leakage avoid contact with skin eyes and mucous membranes If battery acid comes in contact with any of these parts rinse the affected area with copious amounis of fresh water and seek medical attention immediately If a battery has been swallowed seek medical attention immediately Replace all of the batteries simultaneously Only replace with batteries of the same type never use different types of batteries together or used batteries with new ones Insert the batteries correctly observing the polarity Keep the battery compartment well sealed Remove the baiteries from the device if it is not going to be used for an extended period Keep batteries out of children s reach Do not attempt to recharge these batteries There is a danger of explosion Se 2 kern User Handbook GB WARNING A BATTERY SAFETY INF
9. pen up the device it contains parts which might be harmful if handled incorrectly Do not use the device in damp environments Do not immerse the device in water or other liquids It is not watertight For cleaning follow the instructions in 4 1 Cleaning and maintenance Do not shake or tap the device Do not drop it wie User Handbook GB e Protect the device from direct sunlight extremely high or low temperatures dirt and dust e If the device is not going to be used for a long period remove the batteries 2 USEFUL INFORMATION Thank you very much Thank you for your confidence in us and congratulations By purchasing the AlcoBlow you have acquired a high quality product by Lion Laboratories Ltd To ensure the best results and long term satisfaction with your Lion AlcoBlow we recommend that you read the following operating and maintenance instructions carefully 2 1 Items supplied and packaging Please check first of all that the device is complete and is not damaged in any way If in doubt do not use it Send it to a service point The following parts are included e 1 Lion AlcoBlow e 4 Batteries AA type LRO6 1 5V e 1 Packing box e 1 User manual The packaging can be reused or recycled Please dispose properly of any packaging material no longer required If you notice any transport damage during unpacking please contact your dealer without delay WARNING A Please ensure that polythene packing
10. s correctly taken from the liquid vapours If the alcohol level in the sample was very high then it may take a minute or even longer for the sensor to clear and the STATUS light turns GREEN ae User Handbook GB 3 7 Display Light Indications Status light e GREEN the device is ready to take a sample e AMBER the subject is blowing at a satisfactory flow rate e RED the instrument has taken a sample further samples are inhibited e Flashing RED AMBER the breath sample is insufficient wait for a GREEN light before asking the subject to blow again e Flashing RED low battery Display light ALCOHOL DISPLAY LIGHT COLOUR Indication RED Alcohol ZERO oar les MEDIUM HIGH Approx Brac 0 00 0 05 0 09 0 10 0 04 mg l 0 000 0 011 BAC 5010 0 020 0 0214 Both lights together e RED AMBER GREEN Sequence functional test at switch on e Ten Red Flashes automatic switch off warning aie User Handbook GB 4 MISCELLANEOUS 4 1 Cleaning and Maintenance e Do not immerse the device in water or other liquids It is not watertight e To clean the device use a soft cloth slightly dampened with water e Never use aggressive cleaning agents thinners benzene isopropyl alcohol or tough brushes e Do not use or store the device in an environment where the ambient temperature or humidity is too high or too low see operating conditions in the Technical Specifica
11. tion section in direct sunshine in the vicinity of static electricity or in a dusty environment e Remove the batteries if you do not wish to use the device for an extended period of time Otherwise there is the danger that the batteries may leak e f the device is used as described in these instructions an annual service is recommended to ensure accuracy is maintained 4 2 Disposal Do not throw away or dispose of in a landfill site Return to the local dealer or manufacturer Please remove the batteries before disposing of the device Dispose of old batteries at a battery collection station a recycling site or in a shop Consult your municipal authority or your dealer for information about disposal L xi gt User Handbook GB 4 3 Technical Specification Name and model Software Display system Power supply Measuring range Response time Display hold time Audible alarm Automatic switch off Operating temperature range Storage temperature range Dimensions Weight ce Lion AlcoBlow SW42010 2 Tri colour LEDs 4 batteries 1 5 V type LRO6 AA Low 0 00 to 0 04 mg l BrAC 0 000 to 0 010 BAC Medium 0 05 to 0 09 mg l BrAC 0 011 to 0 020 BAC High 0 10 mg l BrAC 0 021 BAC approx 5 seconds at 0 00 mg l BrAC 2 seconds Advises of change in display status 2 minutes after the last operation 5 C to 40 C 15 C to 55 C approx 265 x 48 x 48 mm approx 3
Download Pdf Manuals
Related Search