Maha Powerex C808M manual
Contents
1. MH C808M Eight Cell AA AAA C D Ultimate Professional Charger Thank you for purchasing the PowerEx MH C808M battery charger Read these instructions carefully and thoroughly before operating this unit IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS GENERAL PRECAUTIONS Do not charge battery cells other than NiMH or NiCD AA C and D batteries must be able to accept a 2 0A Rapid mode 1 0A Soft mode rapid charge current AAA Batteries must be able to accept a 0 7A Rapid 0 35A Soft rapid charge current Do not use one hour rapid charge mode on AA C D batteries rated under 2000mAh and AAA batteries under 700mAh To charge them use the Soft Charging mode refer to Soft Charging Mode Do not expose the unit to rain or moisture due to the risk of fire Do not operate the charger if it appears damaged in any way Always place the battery cells with positive tip facing the top Incorrect polarity may cause fire or explosion Observe polarity diagrams located on the charger Do not allow the unit to be exposed to direct sunlight Operate in well ventilated area Do not allow the battery terminals to become shorted To reduce the risk of damage to the power cord always pull by connector rather than the cord FEATURES amp SPECIFICATIONS Eight independent charging slots Charges 1 8 AA AAA C or D NiMH NiCD batteries Selectable Rapid Charge and Soft Charge mode Ultra fast rec2. d immediately by the Conditioning button THIS CAN TAKE UP TO 60 HOURS FOR HIGH CAPACITY BATTERIES Insert the remaining batteries The condition cycle will first apply an initial charge discharge then recharge the batteries CHARGE CHARGE CHARGE AGS f JE5 CHARGE CHARGE CHARGE DONE Initial Charging Discharging Standby for Done Recharging OR Recharging It is normal for all symbols to disappear from one or more slots toward the end of discharge This indicates that discharging is nearly completed and recharging will commence soon During discharging batteries that finish before others will show CHARGE symbols However actual charging will not commence until all batteries have finished discharging Manufactured By MAHA ENERGY CORP 1647 Yeager Ave La Verne CA 91750 Tel 1 800 376 9992 1 909 392 1568 http www mahapowerex eu Copyrighted 1998 2006 Maha Energy Corp
3. d to rescue degraded batteries and exercise infrequently used batteries Recommended once every ten normal charges for NiMH batteries to ensure performance OPERATION Rapid Charge Mode Default 1 Connect the power supply unit DIN connector to the charger as shown in the figure below Then connect the supplied AC cord to a compatible outlet 100 240VAC 50 60Hz and the other end to the power supply unit TIP When operating the charger outside of its intended region of use simply obtain a power cord with a suitable plug type or use a plug changer Transformer is not necessary Insert AA AAA C and or D batteries For best performance insert the batteries from left to right Note that each battery slot will only support ONE battery at a time Do not attempt to insert more than one battery in any given slot NOTE Ensure that the batteries are pressed down all the way to ensure optimal contact If a battery cannot be detected make sure that the battery is inserted all the way and try changing the slot If it still cannot be recognized the battery may not be accepting a charge and may need to be replaced When the battery is correctly inserted charging will commence for that slot The charger is equipped with a four level battery gauge which displays the charging progress CHARGE Extremely low charge Typically indicates abnormal or aged batteries Conditioning is recommended Flashin
4. g CHARGE CHARGE CHARGE DONE Solid or m fs B Flashing Flashing Flashing Flashing 0 50 50 80 80 100 Charging charge charge charge completed CHARGI PONEC Battery fault Flashing all together Soft Charging Mode NOTE Soft Charging is activated for all battery slots simultaneously and cannot be activated for each individual battery 1 2 3 Remove all batteries from the charger if any Insert one battery in the leftmost slot Within five seconds press and hold the SOFT button until Soft Charging symbol is displayed on the LCD screen SOFT CHARGING CHARGE PRINTED IN TAIWAN A03 3713364 456 4 Insert the remaining batteries Soft Charging mode will remain activated as long as there are batteries in the charger even if charging is completed The charger will reset to Rapid Charge mode Soft Charging symbols disappears when all batteries are removed Conditioning Mode NOTE Conditioning is activated for all battery slots simultaneously and cannot be activated for each individual battery 1 2 3 Remove all batteries from the charger if any Insert one battery in the leftmost slot Within five seconds press and hold the CONDITION button until Condition symbol is displayed on the LCD screen CONDITION CHARGE a TIP If Conditioning and Soft Charging is desired simultaneously insert the first battery press the Soft Charging button first followe
5. harging time Selectable conditioning rejuvenation cycle Worldwide power supply Rapid Charge Current Microprocessor Eighth generation MH NM7008 Powerex Precision Microprocessor 2 0A AA C D 0 7A AAA Charge Time AA AAA 1 Hour Rapid 2 Hour Soft C 1 to 3 Hour Rapid 2 to 6 nae Soft D 1 to 5 Hour Rapid 5 to 10 Hour Soft Input Voltage AC 100 240V 50 60Hz Charge time will vary depending upon the brand capacity and condition of batteries being charged PRINTED IN TAIWAN A03 3713364 456 Power Input Fast Soft Button LCD Display Conditioning Button VARIOUS MODES This section explains various charging modes and when to use them To enable each mode refer to the Operation section Rapid Charge Mode Default Shortest recharging time approximately one hour for AA and AAA Suitable for AA C D batteries with capacity greater than 2000mAh and AAA with capacity greater than 700mAh Soft Charging Mode Maximizes battery life and performance recharging time approximately two hours for AA and AAA Suitable for most batteries Recommended if recharging time is not critical Conditioning Mode A special mode which rejuvenates and cycles batteries Applies a special initial charge discharge and recharge cycle which restores battery performance requires up to 7 hours to complete for AA AAA and up to 30 hours for C D Conditioning cycle can be use
Download Pdf Manuals
Related Search