Twin Eagles Side Burner NG to LP Conversion
Contents
1. TWINEAGLES Defining the Art of Outdoor Cooking GAS CONVERSION KIT FROM NG TO LP PN CKLP TESB FOR MODELS TWIN EAGLES SIDE BURNERS TESB131 B TESB132 B TPSC 1 TPSC 2 All gas connections conversions should be made by a qualified technician and in accordance with local codes and ordinances Before conducting a conversion to a gas appliance verify that the main gas is shut off and disconnected from the appliance Make sure that you have the Side Burner Gas Conversion Kit as follows a P N 12602 Coupling 3 8 Flare x 1 2 FIP 1pcs b P N 13317 Orifice Defendi 0 50 LP Center 2pcs c P N 13318 Orifice Defendi 1 00 LP Outside 2pcs d P N 15302 Regulator LP with Hose lpcs e P N 18528L Installation Instruction Ipes f P N 18351 Label Conversion Gas 1 pc Remove the burner cap burner ring and burner hub to expose the burner base and center orifice Remove the orifice cover plate to expose the outside orifice Remove the center orifice and outside orifice using a 7 mm wrench Replace the orifices for the type of gas use as follows ORIFICE LP GAS Center 0 50mm to replace NG orifice no 0 82mm Outside 1 00mm to replace NG orifice no 1 75mm Replace the regulator to the type of gas use a For Built in models the side cooker must have individual regulator b For Freestanding models the side cooker is attached to the gas grill and uses the same regulator with the grill Check for l2. SIDE ORIFICE P N 18528LB 04 11
3. eaks 10 11 12 13 14 NEVER USE THE SIDE BURNER WITHOUT FIRST LEAK TESTING THE GAS CONNECTION a Prepare a leak testing solution of sudsy water by mixing in a spray bottle with half liquid soap and half water Confirm that all control knobs are in the OFF position Turn the main gas valve supply ON d Apply leak testing solution by spraying on the pipe joints fittings and hose e A gas leak is detected if i there is a faint gas smell and or li growing bubbles appear on any of the connection points and or hose DO NOT attempt to ignite the grill and IMMEDIATELY turn off the gas supply valve f When there is a gas leak call a qualified service technician DO NOT use the grill until the leak is corrected o g Turn on burners Set burners to low setting and check for burner flame height If the flames are too high for simmering or too low that they would not stay lit adjust the low flame setting To adjust low flame setting pull out burner knob towards you This will expose the valve stem Insert a flat skinny screw driver into the stem and turn the adjusting screw to the left to increase the flame or to the right to decrease the flame DO NOT OPEN THE SCREW TOO MUCH THE SCREW COULD FALL OFF THE STEM AND CAUSE LEAK The conversion is complete Fill up the Conversion Label Next paste it next to the original Serial Plate Please refer back to the User s Manual P 4 _cENTER ORIFICE QUT
Download Pdf Manuals
Related Search