User Manual - DAZA Opticare
Contents
1. Battery replacement O D Only replace it with a 3 6 Volt lithium cell of size 1 2 AA Never touch the element Correct operation can only be guaranteed when an original battery is used Tadiran brand type TL2150 JE Jumper 2 Remove the four screws on the rear of the pedestal Z f umer 1 Replace the battery as shown in the drawing with the positive terminal down After closing the pedestal of the sensor the sensor will require 2 to 5 minutes to calibrate This is indicated by the regular illumination of the red light behind the sensor lens iii NEVER TOCH THE ELEMENT IN THE SENSOR Figure 3 Battery placement Serial number Set indication l l a On en E On the bottom is a sticker on which the serial number is shown and a combination of A B C D E F GIH 1 J letters and numbers can be marked Mark the same combination on the receiver to 1 2 3 4 5 6 7 8 9 10 indicate that these are configured to work together 1082050137 Figure 4 Serial numbers Daza Opticare BV follows a policy of continuous improvement in the development of its products The technical data can therefore be changed without notice This product is classified as an electrical and electronic device When you decide to discard this product please ensure that this is done accordance with the European Directive on Waste Electrical and Electronic Equipment WEEE and compliant with local laws relating to this directive Page 1 of 12. 1082 CE X Wireless Optiscan 2014 04 29 V1 0 User Manual General This wireless Optiscan detects when a person intends to leave the bed This Optiscan works in combination with the Daza receivers and the Daza pagers Installation and use Place the sensor on the floor facing the bed figure 1 Make sure that the sensor is placed safely where it can cause no harm to the inhabitant for example underneath a chair or table It is highly preferable to place it at a distance of at least 2 meters from the bed The sensor has a 90 degrees field of view over a distance of approximate 7 meter Make sure that no objects are in front of the sensor that can block its view figure 2 Switching on i SY S 1 The sensor is always on you need to switch on the receiver in order to receive ok the alarms See manual receiver 2 Leave the room 3 The sensor switches itself on automatically once no movement across the floor E has been detected for fifteen seconds Figure 2 Viewing angle sensor Switching off 1 Walk into the room and switch the receiver off 2 If applicable reset the alarm on the nurse call system Between detection of movement and activation of the transmitter there is a delay of 2 seconds This gives you the chance to deactivate the sensor before the transmitter is activated It is possible to extend this delay by an extra 3 or 5 seconds You can do this by moving jumper 2 to position three or five figure 3
Download Pdf Manuals
Related Search