User Manual
Contents
1. EXPOSURE MENU EXPOSURE WHITE BAL IMAGE INTELLIGENCE SPECIAL FUNC DISPLAY EXPOSURE MODE NORMAL BRIGHTNESS be WDR BLC DAY amp NIGHT EXIT SAVE DFLT BACK SAVE DFLT MODE Select LENS type NORMAL DEBLUR BRIGHTNESS Adjust brightness level O dark 20 bright steps SHUT SPEED Can be set in AUTO or MANUAL AUTO x2 x8 x4 1 30 25 1 60 50 1 120 100 1 240 1 500 1 1000 1 2000 1 4000 1 8000 1 16000 1 30000 1 60000 sec DSS Select maximum DSS Digital Slow Shutter OFF x2 x3 x4 FLICKERLESS Select Flickerless mode OFF ON remove screen flicker AGC Select Auto Gain Control OFF ON WDR BLC Select WDR Wide Dynamic Range or BLC Back Light Compensation WDR LEVEL Adjust WDR level LOW MID LOW MIDDLE MID HIGH HIGH WDR doesn t work in Shutter Manual Mode BLC POSITION Adjust the window position SIZE Adjust the window size Can t use WDR and BLC at the same time When WDR On BLC is Off And when BLC is On WDR is Off DAY amp NIGHT Select Day amp Night MODE AUTO EXT IN DAY NIGHT AUTO When using D amp N and COLOR model POLARITY ACTIVE LOW HIGH EXT IN When using IR CDS model POLARITY ACTIVE LOW HIGH To turn on the IR set the mode to ACTIVE LOW DELAY 0 255 sec THRS 0 28 DayNight switching level in Auto Mode Switching in lower lux with higher threshold level GAP LOW MID LOW MIDDLE MID HIGH HIGH Margin between Day Night switching l2. message OFF ONe ID OFF ON BAUDRATE OFF ON PROTOCOL OFF ON VERSION OFF ON INIT MSG OFF ON SET INIT MSG modify initial message Text edit SPECIFICATION 1 2 9 Sony Exmor CMOS Sensor Digital 1920x1080p 1080p 30fps AAA Min Mumination Color 0 5 lux BW 0 1 lux Color DSS 0 002 lux BW DSS 0 001 lux Flickerless o o OOA y DSS OFA KB Sharpness CT O tOsteps ITA A TIA TA A A E EA A ETT EA ANTES DONAR Off Low Middle High Auto Off On 24 points Motion CT FON Bpointsy o Shading 9 On HD Format SS dOBOP T2OP SS 14 F 122 10 C 50 C Humidity 0 RH 90 RH Dimensions 4 13 W x 3 17 H inches 105 x 80 5 H mm Specifications are subject to change without notice MADE IN KOREA www okinausa com HDC 30 Copyright O 2013 All Rights Reserved 8 R201311 V18
3. MD 0 20 steps More sensitive to setting to low step with sensitivity POSITION Adjust the Area position SIZE Adjust the Area size INTERVAL TIME Select the alarm interval time 0 255sec DWELL TIME Select the duration time about changing MD mode 0 255sec SPECIAL FUNCTIONS MENU SPECIAL FUNC DEFECT al SYSTEM NTSC HD FORMAT 1080P COMM al EXPOSURE WHITE BAL IMAGE INTELLIGENCE SPECIAL FUNC DISPLAY EXIT EUa BACK SAVE IDFLT DEFECT Compensates for bad pixels that may occur Occurs when the whole screen is in full black or if there is bad pixelation and it changes the THRS values until the screen is fixed SYSTEM Select NTSC 30fps or PAL 25fps NTSC PAL HD FORMAT Select Digital output 1080P or 720P 1080P 720P COMM Set up the camera ID baud rate protocol ID Select the camera ID 1 255 BAUD RATE Select serial communication speed 2400 4800 9600 19200 38400 57600 115200bps PROTOCOL Select operating protocol VISCA PELCO D PELCO P UPDATE DISPLAY MENU EXPOSURE WHITE BAL IMAGE INTELLIGENCE SPECIAL FUNC DISPLAY DISPLAY DISP SEL ON 4 SET TITLE al INIT SEL ON J SET INIT MSG al LANGUAGE ENGLISH EXIT SAVE DFLT BACK SAVE DFILT DISP SEL Select display item OFF ON4 ID OFF ON TITLE OFF ON ZOOM RATIO OFF ON SYSTEM MSG OFF ON MD Alarm and Wait message SET TITLE Select camera title menu Text edit INIT SEL Select display initial
4. OKINACSA HD21D12 940 HD SDI 1080p WDR DNR 12 IR OSD indoor Dome Camera USER MANUAL FEATURES SDI 1080p 1920 x 1080 1 2 9 Sony Exmor 4 0mm Fixed Lens 0 5 Lux 12 IR LED IR distance up to 25ft 7 5m 700mA max 12V DC AN Please read the Manual before attempting to use this product Specifications and appearance are subject to change without notice FE CE RoHS HDC 30 Copyright 2013 All Rights Reserved R201311 V18 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN TO REDUCE THE RISK OF ELECTRICAL SHOCK DO NOT OPEN COVERS OR BACK NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL sd Disposal of Old Electrical amp Electronic Equipment Applicable in the European Union and other ms European countries with separate collection systems This symbol on the product or on its packaging indicates that this product shall not be treated as household waste Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment By ensuring this product is disposed of correctly you will help prevent potential negative consequences for the environment and human health which could otherwise be caused by inappropriate waste handling of this product The recycling of materials will help to conserve natural resources For more detailed information about recycling of this product please contact your local city office your househol
5. ally on the screen V You can flip the picture vertically on the screen H amp V You can flip the picture horizontally amp vertically on the screen SHARPNESS Adjust sharpness level 0 10 steps ACE Select Digital WDR Wide Dynamic Range OFF LOW MIDDLE HIGH DEFOG Carry out defog function OFF ON MODE AUTO MANUAL LEVEL LOW MIDDLE HIGH Can t use DEFOG and ACE at the same time When ACE On DEFOG is Off And when DEFOG is On ACE is Off FREEZE Select real or still mode OFF ON GAMMA Select GAMMA 0 45 0 50 0 55 0 60 0 65 E ZOOM OFF ON LIMIT Max x2 x19 x21 x23 x25 x28 x32 POSITION Select maximum digital zoom magnification Can t use Digital Zoom when the motion detection is turned on INTELLIGENCE MENU INTELLIGENCE PRIVACY OFF MOTION OFF EXPOSURE WHITE BAL IMAGE INTELLIGENCE SPECIAL FUNC DISPLAY EXIT SAVE DFLT BACK SAVE DFLT PRIVACY Hide an area you want to hide on the screen OFF ON MASK Select mask area number 1 24 MODE Mask enable or disable OFF ON 6 POSITION Adjust the mask position SIZE Adjust the mask size COLOR Select mask color 0 13 TRANS Select mask transparency level 0 4 MOTION When there is movement of the subject in the screen there will be a motion detection OFF ON AREA Setting 3 areas 1 3 of motion detection MODE OFF ON Limit and define areas of motion detection SENSITIVITY Adjust sensitivity of
6. d waste disposal service or the shop where you purchased the product CAUTION 1 Never point the camera toward the sun Do not expose the lens directly to the sun or to strong light as this may damage the pick up device 2 Handle this camera with care Avoid any shock or bumping of the camera Improper handling could damage the camera 3 Requires a proper operating environment This camera is designed for indoor use The allowable temperature range for operation of this camera is between 14 F 122 F 10 C 50 4 Clean the front face or lens It is recommended that the surface be cleaned every 3 6 months Cleaning should be done by using a chamois a very fine soft cloth lens tissue or cotton tipped applicator and ethanol to carefully remove any fingerprint or dust 5 Check the power source voltage The power source voltage should be within the specified range Camera must meet the specifications Camera must be connected to a surge protector at all times 6 Objects and liquid entry Never push objects of any kind into this camera as this may touch dangerous voltage points of short out parts that could result in a fire or electric shock Never spill any kind of liquid on the video product 7 Servicing Do not attempt to service this video product by yourself as opening or removing covers may expose you to dangerous voltage or other hazards Refer all service to qualified servicing personnel 8 Damage requiring service Unplug this video p
7. evel and Night Day switching level ANTI SAT LED saturation improves 0 20 BURST OFF ON WHITE BALANCE MENU EXPOSURE WHITE BAL IMAGE INTELLIGENCE SPECIAL FUNC DISPLAY WHITE BAL MODE AUTO RED GAIN BLUE GAIN CHROMA El EXM SAVE BACK SAVE DFLT AWB Select WHITE BALANCE mode AUTO ONE PUSH MANUAL INDOOR OUTDOOR AUTO Automatically adjusts color according to the available lighting ONE PUSH It is a fixed white balance mode that may be automatically readjusted only by pressing ONE PUSH MANUAL Color can be corrected when the user increases or decreases RED GAIN or BLUE GAIN INDOOR Set color temperature to be Indoor light 3700K OUTDOOR Set color temperature to be Outdoor light 5100 K RED GAIN Adjust R gain value 0 20 steps BLUE GAIN Adjust B gain value 0 20 steps CHROMA Adjust CHROMA gain value 0 20 steps MENU EXPOSURE WHITE BAL IMAGE INTELLIGENCE SPECIAL FUNC DISPLAY MIRROR SHARPNESS ACE DEFOG FREEZE GAMMA E ZOOM BACK SAVE DFLT EXIT SAVE HLC Select High Light Compensation When extremely bright light is projected to the camera masking is used on the portion to prevent partial saturation on the monitor MODE OFF ON NIGHT LEVEL 0 20 steps COLOR 0 13 steps DNR Select Digital Noise Reduction AUTO OFF LOW MIDDLE HIGH MIRROR Select a flip mode OFF H V H amp V H You can flip the picture horizont
8. ns please include all ii MANUAL components listed above with original packaging in Resalable Condition Absolutely No Returns will be accepted if any component is missing damaged DIMENSIONS Unit inches mm 2 95 75mm _3 09 78 5mm 3 31 84mm PARTS AND FUNCTIONS IR OSD Control Board OSD Control Board IR LED Board ff of ff ff of Lf 1 Fix the base housing with the supplied 2pcs of screws on the ceiling or wall 2 Adjust the camera direction by BASE ASSY turning the gimbal bracket 3 Firmly fix the decoration ring into the base l screw Decoration Ring Dome cover 3 AXIS Ceiling Type Wall Type PAN SWIVEL 355 TILT SWIVEL 355 Set Camera DIRECTION 3 axis movement Set Camera DIRECTION 3 axis movement CABLE CONNECTION NOTE Camera menu is subject to change without prior notice MAIN MENU MENU Functions can be setup using the Menu Key Commano from the Visca EXPOSURE protocol WHITE BAL The menu consists of the Main Menu and Sub Menu IMAGE The main menu is displayed where 6 camera functions can be selected INTELLIGENCE The sub menu is displayed after selecting a main menu item SPECIAL FUNC DISPLAY If you want to save the menu select SAVE If you do not want to save the menu select EXIT then Power off gt on If you want to set the menu to default select DFLT EXIT SAVE DFLT
9. roduct from the wall outlet and refer service to qualified servicing personnel under the following conditions a When the power supply cord or plug is damaged b If liquid has been spilled or objects have fallen into the video product c lf the video product has been exposed to rain or water d If the video product has been dropped or the cabinet has been damaged e When the video product exhibits a distinct change in performance LIMITED WARRANTY OKINA USA products are covered under warranty for one 1 years from the date of purchase The warranty will automatically be voided if any of the following occurs 1 Camera sticker is removed If the camera sticker is removed we will not be able to confirm any information regarding when and where the product was purchased We have no other way to verify the purchase record without the serial number on the camera sticker therefore it should not be removed 2 Camera is modified in any way If the camera is scratched damaged or modified in a manner not described in this manual the warranty will be voided immediately It is the customer s responsibility to keep the camera in good condition 3 Video or power cable is cut The video cable and the power cable should not be tampered with Cutting or modifying of the cables will result in termination of the warranty PACKAGE CONTENTS 1 One 1 HD21D12 940 Camera 2 Two 2 Mounting Screws 3 One 1 User Manual 1 i For any retur
Download Pdf Manuals
Related Search