USER MANUAL BS-100
Contents
1. Mount the chrome telescopic tubes de pending on its intended use See image Now you can mount the table top by placing the holders into the respective fixings and tighten the locking screws into the desired height Use clamping levers to adjust angle and use allen screws to adjust height and depth Page 17 ato form Tilt settings Tilt settings You can adjust tilt by pressing the foot pe dal down It is important to hold on to the tilt table before the foot pedal is activated and while the angle is being adjusted Remove your foot from the pedal to fixate the desired position Page 18 Knee supports for supine position Accessories Please form the knee supports to suit the individual needs of the user Place the fitting in the slot and fasten in the desired height Then place the bar in the fitting and fasten with the handle Mount the knee support bars in the fittings and fasten The knee supports adjust sideways Use the handle lust for life ato form Knee supports for supine position gmbh Page 19 ato form Types Accessories Cleaning Maintenance Types BS 1000 4 BS prone supine and upright stander Size 1 frame yellow p Accessories Following accessories are available for the BS prone supine and upright stander BS 0810 4 Therapy table for prone and supine position BS 0100 4 Abductor wedge 12 x 7 5 x 9 cm BS 0200 4 Heel support pair f2. Support pad large width x height Support pad small width x height Tilt loading capacity Overall weight Overall height including all accessories foot plate up to upper edge of supporting surface Re use The product BS was designed so it could be reused after implementation of various measures Following measures should be followed e Thorough cleaning and disinfecting using appropriate cleaning agents e Maintenance following the maintenance schedule of the manufacturer or autho rized specialist dealer e Preparing accompanying documents and release for re use ato form Technical Details Re use Size 1 BS 1000 4 70 101 cm 51 cm 70 cm max 86 cm max 122 cm 55 67 cm 5 10 cm 31 x 43 cm 25 x 24 cm 5 to 90 50 kg 19 kg e Technical changes reserved Warning Do not use strong solvents which could damage the surface of the device The use of a high pressure cleaner is not recommended Page 21 ato form Storage Spare Parts Spare Parts Only original accessories and original spare parts may be used Non compliance with these instructions and repairs carried out or modifications made to the BS prone supine and upright stander or its parts by unau thorized persons voids any warranties In these cases any product liability granted by the manufacturer ATO FORM GmbH Zur Lauterhecke 34 D 63877 Sailauf voids in advance For all questions a
3. the prone supine and upright stander BS carefully read all instructions of this user manual as these ato form Safety guidelines Important Warnings CE Regular monitoring at your specialist dealer at least once a year lengthens the life time of the prone supine and upright stander BS and gives you security have been drawn up for your safety and as a guideline for the correct use and care of this product This operating manual is an indispensable component of the delivery and should be stored carefully for further use The operating manual is intended for re tailers and users of the prone supine and upright stander BS it contains the re quired information to secure the correct use of the product cannot not however replace the necessary experience of the user or assistant in handling the device The reseller has the duty to deliver the device ready for operation and to explain precisely the functions and technical data of the device as well as the necessary support and briefing needed for a correct Page 5 ato form Safety guidelines Important Warnings and efficient use of the device e The given instructions of the operating manual refer to the point in time of the device being placed on the market The manufacturer reserves the right to introduce any modifications that prove necessary to the device and associated operating manual without being bound to change previous devices and associa ted ope
4. USER MANUAL BS 100 prone supine and upright stander lust for life form Standing Aids Issue 22 12 ato form Foreword Dear Customer We would like to thank you for your trust extended to us and for purchasing our product The BS prone supine and upright stander distinguishes itself by its quality security easy operation and modern design For optimal use of this aid we ask you and possible other users to carefully read this operating manual Please read through these instructions carefully before first use Page 3 lust for life ato form Index COMUCMNS eni nira e E ETE Page Foreword ou nT RI ETES 3 WOK e E een 4 Safety g idelines 22 csesseescsesaesceneteaen den 5 Important Warnings 068 5 7 Warranty and product liability 8 PUIDOSE OT USE arsine ese dues aneen RAN 9 Position of CE sign oo 9 Equipment overview 06 060 10 Delivery esiisiwedetlonederuieboneiensen este 11 Belts and foot support 0 08 11 Assembly of heel support 64 12 Assembly of chin and thorax SUPPOMtS oon cece ees esa ee cee tee 13 Assembly of headrest with facial aperture cee 14 Assembly of abductor wedge 15 Assembly of extension cushion and posterior support n se 16 Therapy table for prone and supine position 17 TESEN ES inei miann naa 18 Knee supports for supine position 19 WY POS site
5. abel is located on the frame name ly the underside of the cross bracing Page 9 ato form Eqipment overview Equipment overview A Extension cushion wide low Accessories F Foot plate partitioned B Pelvis support Accessories G Therapy table with holder Accessories C Abductor wedge Accessories H Swivel wheels lockable D Supporting surface I Chin support Accessories E Heel support partitioned Accessories Page 10 lust for life ato form Delivery Belts and foot support Delivery All BS prone supine and upright standers are delivered in a robust carton and is ope rational immediately after unpacking p Belts and foot support The belt is moved freely guided through the rail and fixed by a star grip The height and angle of the foot rest is adjusted using a clamping lever Page 11 ato form Assembly of Heel support Assembly of Heel support Accessories The heel support is guided through the slot from underneath the foot rest and fastened Page 12 lust for life ato form Assembly of Chin and thorax supports gmbh Assembly of Chin and thorax supports Accessories Chin support Mount the chin support onto the bars as shown and fasten screws carefully Place the thorax supports fittings into the lateral guides as shown and fasten the allen screws into the desired height Then push the side supports into the holder and fasten using
6. arre i E news 20 ACCESSONES wsiccnisesiteccsettecete near sary 20 Cleaning Maintenance 20 Technical details 2 stciicssetsaseteecsevcosy 21 Spareparts siris sees nen cseesensenaesue seas 21 REUSE a titel E comesdates 22 Storage rnsrsiisrronisn inii paranas 22 Page 4 lJ Safety guidelines The prone supine and upright stander BS is labeled with the CE mark and complies with the requirements of Directive 93 42 EWG It was developed in accordance to the newest insights The manufactu ring process is subject to constant quality control It was developed in accordance to the ne west insights The manufacturing process is subject to constant quality control The prone supine and upright stander should only be used on even surfaces Never use the BS on rough terrain steeply sloping ground or stairs Important Warnings When using a prone supine and upright stander the center of gravity is always relatively high up A person using a prone supine and up right stander is always dependent on the stability of the device from the supporting points against the body and support area to the floor Our main objective was to de velop a device which satisfies the demands of many medical indications Nevertheless a prone supine and upright stander cannot be used without exception in all situations The application and utilization should always be followed through with sense and reason e Before using
7. ased and if the product can be identified by the serial number The warranty does not cover acci dental damage including damage caused by misuse or neglect The warranty does not extend to non durable parts which are subject to normal wear and tear and need periodic replace ment The warranty is null and void if non original ATO FORM parts accessories are used or if the product is repaired or altered by anyone other than an authorized ATO FORM representative or by trained per sonnel officially recognized by ATO FORM for repair and maintenance of ATO FORM products ATO FORM reserves the right to inspect the product being claimed for and the relevant documentation before agreeing to the warranty claim and to decide upon Page 8 whether to replace or repair the defective product It is the customer s responsibility to return the item being claimed for under warranty to the address of purchase The warranty is given by ATO FORM or subsequently an ATO FORM dealer ato form Purpose of use Position of CE sign Purpose of use The prone supine and upright stander BS is only intended for indoor use It offers a variety of therapeutic applica tions such as standing frame prone board and supine board or as a drainage support The optional therapy table supports opti mal head control training We wish you every success using the pro ne supine and upright stander BS i Position of CE sign The CE l
8. bout spare parts and accessories contact your specialist dealer or the ATO FORM Service 49 6093 944 0 www ato form com In environmental protection matters All packaging parts are re useable The cardboard packaging is to be recycled as waste paper We therefore use paper as filler material Possible used plastic film of the packaging are made out of PE and are therefore low in pollutant and can either be recycled or burnt Page 22 lust for life ato form Complete program E Walking aids E Walking frames E Standing aids E Seating aids E Hoists E Body Protection E Customized solutions Thank you for your interest in our products For questions please contact us or our dealer and sales representative Your ATO FORM Team Your sales representative ATO FORM GmbH Zur Lauterhecke 34 D 63877 Sailauf phone 49 0 60 93 9 44 0 E Mail info ato form com www ato form com
9. or prone position BS 0300 4 Thorax Pelvis support pair BS 0600 4 Chin support 4 x 9 x 31 5 cm BS 0700 4 Head support with facial aperture 25 x 24 cm BS 0900 4 Posterior support 26 x 16 cm BS 0910 4 Knee support for supine position 10 5 x 6 5 cm BS 0400 4 Extension cushion type 1 narrow high 26 x 16 cm BS 0500 4 Extension cushion type 2 wide low 32 x 12 cm BSZ 214 0550 1 Foot plate pair ll Cleaning Maintenance Further information regarding the Leftovers dirt and dust are always to be accessories can be found on our removed Moving parts operate better if oO homepage you apply one drop of acid free sewing machine oil after cleaning Belts are best cleaned using water and a mild detergent The upholstery is made of imitation leather and is washable When using any cleaning agent please follow instructions of the manufacturer For the protection of the warranty it is especially important that BS prone supine il and upright stander is serviced regularly Storage once a year from the date of purchase Keep this operating manual in a safe place Please request the relevant maintenance after reading so that you can refer to it at checklist a later date Page 20 Technical Details prone supine and upright stander Article number Armpit height Overall width Overall length Overall height basic model Overall height including all accessories Overall height horizontal Access height
10. rating manuals e The prone supine and upright stander BS may only be operated with continues presence of a qualified person respec tively a family member of the user The BS may only be used by persons of a suitable stature and physical aptitude The BS is only intended for use inside buildings e The BS may only be operated by persons who have familiarized themselves with the standards and rules of the present operating manual Never place a patient in a standing aid which is not coordinated with his or hers body height and weight Do not place any hot containers or objects on the therapy table as hereby the wood or coating could be seriously damaged e Do not place any heavy objects on the standing aid for example on the table as it would affect the center of gravity and consequently impair the balance Page 6 Do not operate or take any action if unsure of its effects if in doubt please contact the nearest technical service center or manufacturer Always ensure there are no obstacles in operating range of the BS such as car pets stairs or objects on the floor which could lead to the BS overturning Move all objects out of the way which could be hit or fall whilst operating the prone supine and upright stander BS The use of the prone supine and upright stander BS and its auxiliary equipment must be administered under medical supervision Never use the BS on rough terrain stee ply sloping g
11. resholds and similar Never allow persons not familiar to operate the standing aid respectively those who have not read this operating manual e Always demand original spare parts e In case of an accident contact the manu facturer for a speedy investigation e The manufacturer can accept no respon sibility for damages caused by unsuitab le and incorrect application of the device by the user neglected maintenance unauthorized alterations and modifica tions the use of non original spare parts unpredictable and exceptional events or from nonobservance of the instructions f thi j l a tieie We constantly develop new aids and e The manufacturer bears no responsibility improve existing products We will be for damages caused to persons objects happy to receive your suggestions of any or animals in the following cases description Page 7 ato form Warranty and Product Liability Warranty and Product Liability ATO FORM offers a 2 year warranty against defects in workmanship and ma terials The warranty would be adversely affected if the customer s responsibility of servicing and or daily maintenance is not carried out according to the guidelines and intervals prescribed by the supplier and or stated in the manual For further information we refer to the ATO FORM homepage download www ato form com The warranty can only be sustained if the ATO FORM product is in use in the same country where it was purch
12. round or stairs Never leave the user of the BS unatten ded with the device Do not use the BS before locking the wheels of the standing aid Do not use the prone supine and upright stander BS without ensuring a correct mounting of the safety belts Never place the prone supine and up right stander BS on steep grades Do not use the device if any parts are damaged or missing In case of malfunction or accident contact the reseller from whom you purchased the device from Control befo re every use that all adjustable parts are ato form Safety guidelines Important Warnings always locked Incorrect use of the aid Use of the device by non suitable persons Incorrect mounting of parts or accessories Use of non original spare parts None observance of the given instruc tions in this operating manual Exceptional events e Check regularly if all screws and handles etc are tightly fastened Worn and de fect parts are to be repaired or replaced immediately This is especially important to ensure a safe use of the aid Carefully check for a firm hold of the clamping jigs and the like e Clean the prone supine and upright stander BS in accordance with the inst e Adjust settings only in the unloaded ructions in the chapter Cleansing condition e Be careful when moving the standing aid whilst a patient is standing in the device This is particularly applicable when crossing ramps th
13. the star grip Page 13 ato form Assembly of Headrest with facial aperture Assembly of Headrest with facial aperture Accessories Push the long guide rails about 15 cm upwards and secure the headrest into the mid pipes fasten by use of the clamping screws Page 14 lust for life ato form Assembly fo Abductor wedge gmbh Assembly of Abductor wedge Accessories Push the abductor wedge through the slot centered in the lying surface Fasten on the backside using the allen screw Page 15 ato form Assembly of Extension cushion and posterior support Extension cushion and posterior support Accessories The extension cushion is mounted onto the two guide rails between the lower and upper cushion The supporting adaptor for the posterior support is mounted as shown onto the long guide rails Lead the bars through the extension cushion and the posterior support Fasten with the handle The posterior support can be adjusted as shown The posterior support can be swung aside to for easy entering and exiting Page 16 ato form Therapy table for prone and supine position Therapy table for prone and supine position Start by removing the upper supporting cushion by loosening both locking screws Mount the painted table holder adjusting screws are on lt lt the top onto the long guide rails and tighten the adjusting screws Now assemble the upper cushion support again
Download Pdf Manuals
Related Search