Waste Receptacle 1
Contents
1. SAFCO PARTS LIST Waste Receptacle MODEL NUMBER 9728 PARTS LIST DESCRIPTION Left Side Panel PART NO DESCRIPTION PART NO Nut Back Panel Plastic Insert Right Side Panel Mounting Screw Bottom Panel with Glides Large Door Top Panel Door Hinge Mount Plate Small Door reversible Door Hinge Hinge Plate with Peg O DOOS Bumper Button Head Bolt D NINI INJA Small Bumper Screw TOOLS REQUIRED FLAT BLADED amp PHILLIPS SCREWDRIVER WRENCH RUBBER MALLET Note when corresponding about wood parts be sure to state color gray or medium oak 1 Locate the B Back Panel and lay it down on a smooth clean surface with the cam locks facing up Lay the A Left Panel and the Right Panel on the left and right sides of the Back Panel Arrange the Top Panel and D Bottom Panel Bottom Panel has four female Cam Locks on one side and four plastic feet on bottom side at the top and bottom ends of the Back Panel with the cam locks facing up Fasten the Bumper to the Right Side Panel using the P Small Bumper Screw LEFT PANEL Mounting holes for two Hinges on one side 9728 37 1 of 2 Rev 1 06 01 ASSEMBLED UNIT Model 9728 For questions or concerns please call Safco Consumer Hot Line 1 800 664 0042 available Monday Friday 8 00 AM to 4 30 PM Central Time English speaking operators UNFINISHED EDGES CAM LOC2. K mete Female Safco Products Company New Hope MN 55428 2 Raise the Right Side Panel and insert the male cam locks into the female cam locks on the B Back Panel Lock each cam by turning its screw 1 4 turn clockwise 3 Raise the A Left Side Panel and insert the male cam locks into the female cam locks on the Back Panel Lock each cam by turning its screw 1 4 turn clockwise Insert the cam locks on the Bottom Panel finished edge to the front into the cam locks on the left and right panels FINISHED EDGE Press the Plastic Inserts into the small hole near the upper end of each side panel Carefully tilt the Small Door until the Hinge Plate pegs can be inserted into the Plastic Inserts Insert the cam locks on the Top Panel into the cam locks on the upper end of the Left Right and Back panels Lock each cam by turning its screw 1 4 turn clockwise Check to be sure all cams are locked Bend the arm of the Hinge and slide the arm into the Hinge Mount Plate Set the Waste Receptacle upright Center the Lower Door panel by adjusting the set screws on the Door Hinges either in or out as needed 4 Determine which side of the F Small Door will face outward From the back side fasten one Hinge Plate with Peg to the upper left edge of the Small Door with two H Button Head Bolts and two Nuts hinge peg should be pointing to the left Repeat for second hinge plate with this hinge peg pointing to the righ
3. t Turn the cabinet onto its left side Tap the N Door Hinges into the recesses on the L Large Door Fasten using K Screws through the hinge leaf and into the pre drilled holes Use K Screws to fasten the M Door Hinge Mount Plates onto the left panel through the hinge leaf and into the pre drilled holes NOTE large door is easier to install when cabinet is placed on its side Adjust the Upper Door vertically so it does not brush against the Lower Door panel Do this by loosening the screws on the hinge plates and repositioning the panel Re fasten all screws Place the Plastic Liner model 9669 sold separately in the cabinet 9728 372012 REV ts 08 0 Safco Products Company New Hope MN 55428
Download Pdf Manuals
Related Search