H2X2-C UM EN Recirculation Model
Contents
1. TELESCOPIC HOOD USERS MANUAL INSTRUCTIONS FOR INSTALLATION AND USE Table of Contents e From the Manufacturer e Specifications e SAFETY Read this first e Vent System Requirements e Re circulating e Schematic Diagram e Description of Parts e Instruction for Use e Technical Information e Installation e Cleaning 8 Maintenance e Troubleshooting For original parts amp reliable service Troubleshooting Symptoms Possible Cause Does not function No electrical supply Aluminium filters grease clogged Poor airflow Charcoal grease filters Replace charcoal filters with clogged new sets Motor running but no airflow Butterfly valve jammed device activated Motor cuts after a few minutes The hood is installed too near the cooking stove Charcoal filters not installed Strong cooking smell Aluminium grease filter saturated Oil dripping onto stove Aluminium grease filter saturated Whirring sound Foreign object in contact with fan blade 14 Action Check that the plug is connected Check that the main switch is turned on Clean the filters and replace when it is dry Contact technician ventilated The hood must be at least 65cm from stove In re circulating mode charcoal filters must be installed Wash the aluminium grease filters Wash the aluminium grease filters Contact technician From the Manufacturer Safety Please do not allow young chi2. odors to be expelled
3. of 60cm above the hob for electric cookers and 65cm for gas cookers If the instructions of a gas cooker indicate a greater distance these must be observed When the extractor is working at the same time as other non electrical cooking equipment the outlet air pressure must not exceed 4 Pa To achieve optimum performance the length of the outlet hose should not exceed 4 meters or include more than two 90 angles elbows Although venting to the outside is recommended activated carbon filters may be used which allow the gas to be returned to the kitchen through the outlet pipe Technical Information Dimensions Width Depth Height 10 600 900 mm 280 mm 180 mm Schematic Diagram K2 Light Switch AC220V 240V 50Hz Microswitch Description of Parts Extractable Group TTT rev Trev Light Switch L U Ti A ii m Motor Control 4 Filters Filter Instructions for Use By pressing the button shown in the below you will be able to control the functions of the extractor Light Speed Ye ON ton O of O off A Automatic High To achieve better extraction we recommend switching on the extractor a few minutes before starting to cook 3 5 minutes so that the air flow is continuous and stable when extracting fumes Likewise keep the extractor switched on for a few minutes when cooking is complete to allow all fumes and
4. e attempted only by qualified technical personnel e Itis dangerous to modify any part of this appliance e The manufacturer declines all responsibility in case of failure to adopt proper safety measures e Ensure the location in which this appliance is installed has good permanent ventilation e The distance between the bench top to the lower part of the hood must not be at less than 65 cm or higher than 75 cm e Use an electrical connector with earth that is correct for your location e Check that the voltage in your area is correct before plugging in e The electrical connection of this appliance must be connected to earth Green amp yellow EARTH Blue NEUTRAL Brown LIVE e Multiple plugs and extension cables must not be used Overload is dangerous and may cause a fire e Ensure that the power supply chord is free from any heat source or sharp objects e The appliance should be switched off and the electrical supply disconnected before any cleaning or maintenance work can be carried out Cleaning amp Maintenance continued Activated charcoal filter To install the charcoal filter the motor anchorage is made to coincide with the anchor points of the activated charcoal filter inserting and locking into place The carbon filter lasts from three to six months depending on the particular conditions of use The activated carbon filter can neither be exhausted it must be changed Once it is exhausted it must be c
5. hanged Changing Bulbs Remove the filter support to access the bulbs Take care to disconnect the mains beforehand and that the bulbs to be replaces are not hot The maximum bulbs power is 40W Cleaning amp Maintenance Before carrying out any cleaning or maintenance activities ensure that the appliances is disconnected from the mains and follow the safety Instructions Filter Cleaning To withdraw the filters from their locations release the anchoring points Clean the filter either putting in the dishwasher refer to notes or leaving it standing in hot water to simplify the removal of grease or if wished by means of special sprays protecting the non metallic parts Once clean leave it to dry Notes cleaning in the dishwasher with aggressive detergents may blacken the surface of metallic parts without this affecting its gas retaining properties The filter must be cleaned at least once a month depending on how often the appliances is used It must be remembered that grease is deposited in the extractor when cooking whether it is switched on or not Cleaning the appliances body The use of 40 C approx soapy water is recommended A cloth moistened in this water is used for cleaning the extractor paying special attention to the grids and dry it using a lint free cloth Note Never use metallic scouring pads or abrasive products that could damage the surface Do not use scrapers with metallic surfaces such as kn
6. ives scissors etc 12 Vent System Requirements Determine which venting method is best for your application Vented non recirculating system must be terminate to the outside Ductwork can extend either through the wall or the roof Do not terminate the vent system in an attic or other enclosed area The length of the ductwork and the number of elbows should be kept to a minimum to provide efficient performance The size of the ductwork should be uniform Do not install two elbows together Use duct tape to seal all joints in the ductwork system Use caulking to seal exterior wall or floor opening around the cap Flexible ductwork is not recommended Flexible ductwork creates back pressure and air turbulence that greatly reduces performance Make sure there is proper clearance within the wall or floor for exhaust duct before making cutouts Do not cut a joist or stud unless absolutely necessary If a joist or stud must be cut then a supporting frame must be constructed Re circulating B RE CIRCULATING MODE e Fumes are filtered for grease and odors through the aluminum grease filters and the charcoal filters respectively and re introduced into the kitchen environment In re circulating mode both the aluminum grease filters and the charcoal filters must be installed Installation To fix the extractor to the kitchen unit The lower part of the extractor must be located at a minimum height
7. ldren to play with the plastic bag packaging Before disposing of any old appliances be sure to cut off the power chord so that others will not be endangered by a defective electric appliance This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance If the supply cord is damaged it must be replaced by the manufacturer its service agent or similarly qualified persons in order to avoid a hazard There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels not applicable to appliances that only discharge the air back into the room There is a fire risk if cleaning is not carried out in according with the instructions Do not flamb under the range hood The appliance use 4 hob element at most Input 220 240V 50Hz Absorption gt 2x 85W Lamps 2x 40W External Dimensions e 60cm version 600x280x180mm e 90cm version 900x280x180mm SAFETY Read this First e Do not connect the appliance if there are obvious signs of transportation damage e Read this user manual thoroughly before attempting to use this appliance e Installation and repair should b
Download Pdf Manuals
Related Search