Engineer to Engineer Note EE-6
Contents
1. word only rather than have no frame signal at all ANALOC DEVICE2. Engineer to Engineer Note EE 6 Notes on using Analog Devices DSP audio amp video components from the Computer Products Division Phone 800 ANALOG D or 781 461 3881 FAX 781 461 3010 EMAIL dsp support analog com ADSP 21xx Serial Port Startup Issues Last Modified 2 27 97 Overview This Engineering Note will describe issues that can arise when starting up an ADSP 21xx Serial Port QUESTION Engineer 1 I m using the 2181 for video processing Iam having some trouble reading in a clocked serial stream on SPORTO I set up the SPORT to alternate unframed mode which means it expects a frame signal only at the first bit of a continuous transmission But it looks like the first two bits of my data are always getting swallowed after that it s fine If I change to normal unframed mode the first three bits get swallowed so at least the unframed mode is correct Anyone with experience on this stuff Engineer 2 Yup read the manual very thoroughly Also I do invert the frame sync Setup times are very generous on the order of several uS I have heard from one other 2181 user that the first two bits get swallowed in frameless mode By generating two initial bits on the data stream everything works out fine Looks like an undocumented feature of the 2181 SPORTs ANSWER Actually what you are experiencing is a side effect of the startup timing described in section 5 13 2 1 of the 2100 Family User s Manua
3. l When a serial port is enabled by a write to the System Control Register it takes two SCLK cycles before it is actually enabled On the next third SCLK cycle the serial port becomes active looking for a frame sync The SPORT was designed this way to synchronize the enable signal to the asynchronous serial clock What happens in your case is that there are no SCLK cycles without the frame signal being asserted To the clocked serial port it appears that any cycle could be the start of your frameless data stream there is a valid frame signal every cycle This causes the SPORT to skip the data on the first two or three cycles of SCLK if you are not giving any cycles without the frame signal since it ignores the frame signal until the SPORT becomes active This situation can happen to anyone using frameless modes with the clock only operating when data is being sent The solution of sending a couple dummy bits will work fine if the SPORT is enabled long before the SCLK starts but could cause trouble if the enable bit is written at about the same time as the first SCLK cycle An alternate solution would be to have the frame signal de asserted for 2 or more SCLK cycles and than asserted when the data starts Some other processors have a special asynchronous start mode to better support the toggle the clock only when there is data type of operation The bottom line is that Frameless operation actually means Frame the first
Download Pdf Manuals
Related Search