installation, user and servicing instructions for eslr9c oven range
Contents
1. 5 cscs wee opor SUE 6 COMMISSIONING 6 User Instr cllOliS 7 Service 8 GUTA Oo 8 WARNINGS AND PRECAUTIONS It is mandatory that all appliances are installed commissioned and serviced by a qualified and competent person as defined by the regulations in force in the country of installation Failure to comply will invalidate the warranty WARNING This appliance must be installed by a competent installation engineer in accordance with the installation instructions and should conform to the following requirements Do not obstruct or block the appliance flue Installation must include sufficient ventilation to prevent the occurrence of unacceptable concentrations of substances harmful to health in the room in which they are installed It is recommended that this appliance be sited under an extraction canopy for the removal of heat and odours After operation some parts of the appliance will remain hot for a period of time Please take care to avoid accidental burns CAUTION All equipment must be earthed to prevent shock Do not connect directly to any flue ducting or mechanical extraction system Parts which have been protected by the2. Lincat SILVERLINK GOO INSTALLATION USER AND SERVICING INSTRUCTIONS FOR ESLR9C OVEN RANGE This is just one of over 300 different items of catering equipment available which is constantly being extended and improved Details are available from your local distributor or direct from us Used for the purposes for which it is intended and with careful maintenance as outlined in this User Guide your Lincat product will give you years of trouble free service ep NOTE Please read all of the safety and operating instructions carefully before using this product Please pay particular attention to all sections of this User Guide that carry warning symbols and notices WARNING This is a Warning symbol This symbol is used throughout the user guide whenever there is a risk of personal injury Ensure that these warnings are read and understood at all times CAUTION This is a Caution symbol This symbol is used throughout the user guide whenever there is a risk damaging your Lincat product Ensure that these warnings are read and understood at all times NOTE This is a Note symbol This symbol is used throughout the user guide to provide additional information hints and tips 15293 ECN3004 2 CONTENTS Contents Page Warnings and Precautions esee eere ee eee ee 3 ssa Uer Eu amet uutas 4 Check List of
3. e There is an equipotential bonding point fitted on the rear of the unit e This fixed wiring to this unit must be fitted with a switch isolator to provide all pole disconnection COMMISSIONING PREPARATION e Remove all packaging and protective coatings prior to installation e Before first use burn off the protective coating on the hotplates by heating them on maximum without a pan for 3 5 minutes and then wipe clean when cool e For maximum efficiency use good quality pans of adequate size with stable slightly concave bottoms VENTILATION The area in which this equipment is to be installed should have sufficient fixed ventilation to comply with local legislation requirements 15293 ECN3004 6 USER INSTRUCTION APPLIANCE USE This appliance is only for professional use and should only be used by qualified personnel Ensure that the person responsible understands how to safely operate shutdown and clean the appliance and is made aware of the position and operation of the electrical isolating switch in the event of an emergency HOB OPERATION e Switch on the mains supply to the unit and the green neon will illuminate e Adjust the temperature to the desired level by means of the control knob 1 being low and 6 being high e Each plate incorporates a protection device that automatically reduces the power when the pan is removed or if a pan boils dry OVEN OPERATION e Switch on the mains supply to the unit and the gr
4. een neon will illuminate e Set the oven control knob left hand side of unit to the desired temperature degrees Celsius The oven fans run continuously whilst the oven is turned on The orange light will illuminate indicating that power is being supplied to the elements e The orange light will go out when the oven has achieved the set temperature Periodically the orange light will illuminate to indicate that the oven temperature has fallen and the elements have been turned on to raise the temperature e Allow 20 minutes from cold for the oven to heat and stabilise oven is not heating then check and press the oven reset button located above the This unit is fitted with a thermal cut out to protect the oven from overheating If the cable inlet at the rear of the unit o This unit has had the airflow optimised for the most even cooking on the second H and fourth shelves using either 2 1 1 gastronorm trays or 4 1 2 gastronorm trays SHUT DOWN To shut down the appliance rotate all control knobs anti clockwise to the OFF position and isolate the electrical supply CLEANING e Ensure the appliance is cool and the electricity supply is isolated before cleaning e Use only a warm mild detergent solution e Do not use abrasives on stainless steel or enamelled parts Do not use any products containing chlorine or hydrochloric acid to clean stainless steel surfaces e The unit is fitted with a removable oven liner base
5. manufacturer or his agent must not be adjusted by the installer or user 15293 ECN3004 3 TECHNICAL DATA Model X ESLR9C Dimensions Overall height to hobtop Width Depth excluding handles Hob cooking surface w x d 900 mm x 600 mm Usable oven capacity w xd xh 670 mm x 340 mm x 410 mm Oven shelf size w x d 670 mm x 340 mm Power Rating Line current 230 11 Line current 230V_L2 Line current 230V_L3 15293 ECN3004 4 CHECK LIST OF ENCLOSURES Please ensure the following items are included with this piece of equipment Model A ESLR9C Enamelled oven base panel User Instructions Lo dm dq o d Wire oven shelves 1 2 15293 ECN3004 5 INSTALLATION SITING The installer must ensure that all regulations are met and that there is an unobstructed minimum distance of 500mm from the top of the flue to the ceiling which must be of non combustible material The appliance should be installed on a level surface ensuring the unit is stable and firmly located Any partitions walls or kitchen furniture in close proximity must be of non combustible materials and not be closer than 50mm from the sides and rear of the oven flue ELECTRICITY SUPPLY AND CONNECTION e Connection shall comply with local regulations e Connection is at the rear right hand side of the unit via a cable gland and should be made with an oil resistant sheathed flexible cable
6. to ease cleaning e Do not clean the appliance using a water jet 15293 ECN3004 7 SERVICE INFORMATION LINCAT GROUP SERVICE HELP DESK 44 0 1522 875520 AUTHORISED SERVICE AGENTS We recommend that all servicing other than our authorised service agents carry out routine cleaning We cannot accept responsibility for work carried out by other persons Please quote both the model and serial numbers from the data plate attached to the unit Give brief details of the service requirement If possible please quote the product code of the part number you require Work carried out under warranty will normally be undertaken only during normal working hours i e Monday to Friday 8 30 a m 5 30 p m CONDITIONS OF GUARANTEE The guarantee does not cover e Accidental breakage or damage e Operational misuse wear and tear from normal usage incorrect adjustment or neglect e Incorrect installation maintenance modification or unauthorised service work 15293 ECN3004 8
Download Pdf Manuals
Related Search