User Manual
Contents
1. Components 1 The Universal Transmitter LT 900 with pre installed transmitter code Model LT 900 2 Wrist Strap not shown LT 900 Long Range Transmitter is Long Life battery operated and connects to Sensor Pads The transmitter is attached to posts on Wheelchair Beds etc with Fast Install Velcro Straps When sensor is activated by weight of patient getting ON or OFF sensor pad the transmitter sends the signal to the Enunciator ON OFF switch allows caretaker to attend patient The LT 900 transmitter is selectable to monitor chair bed floor and rail oed sensor pads Transmitter is selectable for INSTANT or DELAY 2 sec operation allowing patient to move around in chair or bed without sending alarm The LT 900 Long Range Transmitter has a switch to turn the transmitter on for instant or delayed operation or off to allow the caregiver to work with a patient and not have the alarm sound The led will flash when transmitter is activated In an alarm condition make sure both transmit ter and receiver units are reset to there non alarm condition when situation has returned to normal There is also a switch to set the sensor for Normally Open position O to activate the alarm when weight is getting on the pad or Normally Closed position C to activate the sensor when weight is getting off the pad We strongly recommend that you test the transmitter with the receiv er enunciator system frequently Fro2. m the time of installation it is absolutely necessary to test the system at least once a week to ensure that the LT 900 transmit ter will be ready when needed Changing Batteries The batteries should be replaced every year or as needed with your transmitting unit To replace the batteries in your transmitter you will need one 3 volt Lithium battery CR123A or equivalent Carefully remove the screws on the transmitter case and separate the transmitter housing RJ22 Connector Button Battery Remove the old battery from the battery holder and place the new battery with the positive end of the battery facing up towards the bottom of the unit towards the RJ22 connector BE SURE TO PRESS THE RESET BUTTON AFTER INSTALLING THE NEW BATTERY side Then reassemble the main transmitter case DO NOT OVER TIGHTEN SCREWS After changing the batteries be sure to test the transmitter to make sure you have installed the batteries properly Now you can feel Safe Secure and at Ease whenever patients family members or friends are confined to bed home or facility and need fast assistance Emergency Caller Products Universal Transmitter LT 900 USER MANUAL QUICK START GUIDE Emergency Caller Products T 800 227 2474 F 800 762 7613 www emergencycaller com sales emergencycaller com U S A and World Patents Issued and Pending on Certain Products ae TITER
Download Pdf Manuals
Related Search