EM3038A User`s Manual
Contents
1. EM11A Dual Channel Event Timer User s Manual Rev 1 Specifications Max Cycle Time 127 seconds in high resolution mode 254 seconds in low resolution mode Timing Resolution 1 8 second in high resolution mode 1 4 second in low resolution mode Unit Cascading Unlimited number of units can be cascaded Max Relay Load 12A 120VAC 10A 240VAC 28VDC Power Requirement 12V DC 200 mA Physical Dimensions 4 25 x 2 75 x 1 6 excluding mounting ears Inputs amp Outputs Power Jack VDC Use a power adaptor capable of providing at least 200 mA at 12V DC with a 2 1mm center positive coaxial plug There is no power on off switch Power Light PWR The power light will be turned on when power is applied Trigger Input Terminal TRG Depending on how the switch 2 is set the unit can be triggered by either making or breaking the connection between the trigger input and the ground GND This can be achieved through various de vices such as push buttons pressure mats and motion sensors with dry contacts Reset amp Cascade Terminal RST CAS This terminal serves as both reset input and cascade output The unit can be reset at any time by shorting this terminal to the ground GND The timing cycle if active at the moment will be stopped immediately See the Cascading Units section for the cascade function Relay Output Terminals N C N O COM Both normally closed N C and normally open N O contac2. solution means more accuarte timing Cascading Units At the very end of the timing cycle the RST CAS terminal turns into an open collector output for 0 1 second This pulse can be used to trigger another unit which must be configured for normally open trigger RST CAS RST CAS RST CAS TRG TRG TRG GND GND GND Unit 1 Unit 2 Unit 3
3. ts are available for controlling external devices Teach n Learn Programming The timing cycle can be programmed into the unit with the following Teach n Learn procedures 1 Remove the front cover and press the PROGRAM button The PGM light will be turned on 2 Relay 1 is programmed by pressing holding the CH 1 button at the desired moment for the desired duration The CH1 light will be lit when relay 1 is on Use the CH 2 button to program relay 2 Both relays must be programmed within the same cycle There is no limit on the number of times the relay can turn on off 3 Press the PROGRAM button again to end the programming The timing cycle is now stored in non volatile memory The unit can be re programmed for thousands of times if necessary N O COM gt RELAY 1 N C N O COM gt RELAY 2 N C RST CAS TRG GND VDC PGM CH2 SWITCH D BD ON OFF el 12 PROGRAM CH 1 Switch Settings Switch 1 OFF high resolution mode 1 8 second ON low resolution mode 1 4 second Switch 2 OFF normally open trigger connect TRG to GND to trigger ON normally closed trigger disconnect TRG from GND to trigger Timing Resolution The unit has an internal clock that when the unit is triggered starts ticking once every 1 4 or 1 8 second depending on the resolution Relays get turned on off on the tick only not between ticks There fore higher re
Download Pdf Manuals
Related Search