User Manual - Avantco Refrigeration
Contents
1. REFRIGERATION AVANTCO User Manual www AvantcoRefrigeration com Chest Freezer User s Manual 178HF5 05 2015 178HF9 178HF14 178HF20 Please read the manual thoroughly prior to equipment set up operation and maintenance a ee REFRIGERATION OLY am VEEL VANTCO www AvantcoRefrigeration com Installation Important Please Read Before Installation e Make sure that the unit drops down to desired temperature before loading the unit with product e Make sure that there is proper ventilation around the unit in the area where it will operate e Please read through the manual in its entirety Cabinet Location Guidelines e Install the unit on strong and leveled surfaces Leveling can be obtained by adjusting the screws on the bottom of unit Unit may be noisy if surface is uneven Unit may malfunction if surface is uneven e Install the unit in an indoor well ventilated area Unit performs more efficiently in a well ventilated area For best performance please maintain clearance of 4 on the back of the unit Outdoor use may cause decreased efficiency and damage to the unit e Avoid installation in a high humidity and or dusty area Humidity could cause unit to rust and decrease efficiency of the unit Dust collected on condenser coil will cause unit to malfunction Malfunction due to dirty condenser will void warranty e Select a location away from heat and moisture generating equipment High ambient tem2. To minimize shock and fire hazards please do not plug or unplug the cord with wet hands e During maintenance and cleaning please unplug the unit Proper Grounding Required e To minimize shock and fire hazards make sure that the unit is properly grounded Warning e Do not attempt to remove or repair any component unless instructed by factory e Make sure that the unit is not resting on or against the electrical cord and plug e To minimize personal injury do not hang on the door e Do not store any flammable and explosive gas or liquids inside the unit e Do not attempt to alter or tamper with the electrical cord REFRIGERATION VANTCO www AvantcoRefrigeration com ORY VED Troubleshooting Compressor Not Running Fuse blown or circuit breaker tripped Power cord unplugged Thermostat set too high Replace fuse or reset circuit breaker Plug in power cord Set thermostat to lower temperature Condensing Units Run For Long Periods of Time Excessive amount of warm product placed in cabinet Prolonged door opening or door ajar Allow adequate time for product to cool down Ensure door is closed when not in use Avoid opening door for long periods of time Cabinet Temperature is too Warm Thermostat set too warm Airflow blocked Excessive amount of warm product placed in cabinet Fuse blown or circuit breaker tripped Unit is Noisy Loud noise is heard Sounds like water running Condensat
3. eezer temperature rises frost will melt or scale off 2 To speed up defrosting place a pan of hot water into the unit and close the door After defrosting drain the water and then use a soft cloth to dry the interior walls Plug unit and resume operation Note Never use sharp utensils to scrape off frosting layers Regular Maintenance Care and Cleaning It is suggested that the freezer be cleaned periodically generally clean it every 30 45 days Unplug before cleaning and use a soft cloth with a solvent of warm water and mild soap to scrub inside and outside of the cabinet Do not use acids chemical thinner gasoline or benzene for cleaning any part of the chest freezer Dry it with a soft cloth Never use water to rinse the freezer REFRIGERATION User Manual VANTCO www AvantcoRefrigeration com Safety Warning Please pay close attention to the safety notices in this section Disregarding these notices may lead to serious injury and or damage to the unit Attention e To minimize shock and fire hazards be sure not to overload outlet Please designate one outlet for your unit e Do not use extension cords e Do not put your hands under the unit while it is being moved e When the unit is not in use for a long period of time please unplug the unit from the outlet e After unplugging the unit wait at least 10 minutes before plugging it back in Failure to do so could cause damage to the compressor Unplug Cord e
4. ion Condensation is on the exterior walls of the unit Set thermostat to higher setting Re arrange product to allow for proper air flow Make sure there is at least four inches of clearance from evaporator Allow adequate time for product to cool down Replace fuse or reset circuit breaker Be sure there is enough space between chest freezer and the wall No attention required It is the sound of refrigerant liquid for cooling the freezer Condensation may build up on the body or the door when humidity is high REFRIGERATION User Manual VANTCO www AvantcoRefrigeration com Warranty Information Units in this manual are backed by a 1 year parts and labor warranty For warranty inquiries or service first locate e The model number and cabinet serial number located on the front of the unit or inside the door jamb e The bold number on the service plate located on the front of the unit Next call 1 800 678 5517 Be sure to have the model number cabinet serial number and service plate number available when contacting service technicians This warranty does not apply to and Avantco is not responsible for any warranty claims made on products sold or used outside of the United States
5. peratures will cause the compressor to overwork leading to higher energy bills and gradual breakdown of the unit Malfunction due to high ambient temperature will void warranty Electrical e Please ensure that the required voltage of the compressor is being supplied at all times Low or high voltage can detrimentally affect the refrigeration unit e All units should be plugged into a grounded and properly sized electrical outlet with appropriate overcurrent protection Please refer to the electrical requirements on the nameplate e Please make sure that your unit has its own dedicated outlet e Do not use an extension cord REFRIGERATION VANTCO OLY am VETOED www AvantcoRefrigeration com Temperature Control The recommended setting for the freezer is at position 4 If fast freezing is needed for products set at position 7 Turn it to its original position when the articles are frozen Do not fast freeze for more than 4 5 hours To decrease the temperature colder turn to position 7 to increase the temperature warmer turn to position 1 CAUTION Setting the temperature control to the coldest setting may cause the evaporator coil to freeze and ice up This will eventually result in a warmer cabinet temperature Defrost System If the frost on the interior walls is more than 1 4 defrosting should be done Method of defrosting 1 Unplug the unit Take out all contents of the freezer After the fr
Download Pdf Manuals
Related Search